What to wipe the floor with, and what method to use to wipe the floor

The daily cleaning of the floor is very simple, just vacuum with a vacuum cleaner, wipe with a semi-damp cloth and mop, pay attention to the mop should not be too wet, it should be wrung out before use. If it is a composite wood floor, there is a very thin layer of crystalline aluminum oxide wear-resistant layer on its surface, and the damage of the wear-resistant layer will cause damage to the floor, therefore, if the composite wood floor is accidentally polluted by nail polish, ink, wine, etc., it should be immediately scrubbed with nail polish remover and other cleaning agents, do not use sandpaper to polish during use, use chemicals such as cleaning agents with caution, do not wax and paint, so as to prevent damage to the surface wear-resistant layer.

Use a semi-dry mop for cleaning. If the air in your home is dry, make the mop wetter or put a basin of water on the heater or humidify it with a humidifier.

Cotton mop, cotton mop, cotton mop, cotton mop.

Mopping floors is a necessary part of the daily cleaning of the home. Keeping the floors clean and tidy not only beautifies the home, but also avoids the impact of dirt and bacteria on the health of the home. Here are a few ways to mop the floor.

1. Wet mopping floorWet mopping is the most basic method of mopping the floor. Choose a mop and cleaner to wipe dust, oil, and bacteria off the floor. First of all, clean up the debris on the ground, soak the mop in clean water, wring it out and spray the detergent evenly, and then wipe the floor carefully.

Second, the machine mopping the floor, the use of the machine to mop the floor, can save time and effort. Choose a floor scrubbing machine that performs well and is a reliable brand. When operating, first adjust the machine to a suitable speed failure, then tilt the machine head to start wiping the floor, after wiping a part, use a suction hose to absorb water and detergent, rinse the wiped ground, and then continue the operation.

3. Dry mopping the ground For clean and not easy to get dirty, you can use dry mopping. Prepare a dry mop, cleaner and floor sweep, spray the cleaner evenly on the floor, and use the dry mop to wipe the floor clean.

Fourth, polish the ground: Use a polishing machine to polish the ground, which can make the ground as clean as new. Relax the machine settings, gently slide the polisher on the ground, and gradually increase the speed of the machine until you reach the most suitable speed.

The above four methods can be used to mop the floor suitable for your own family to achieve the effect of household cleaning, hygiene and beautification. At the same time, it is also necessary to pay attention to the choice of cleaning agent so as not to cause damage to the floor dust.

1. Wipe the floor frequently. Wipe down the floor with a dry mop every few days to remove dust to remove daily pollutants. Such as soil, hair and debris, so that debris will not scratch your floor.

A vacuum cleaner equipped with a soft brush can be used instead of a dry mop to remove dust. Do not use a regular floor brush, the sol is hard and has residue and may damage the floor. Drag in the direction of laying the floor.

This will allow you to remove debris from the gaps in the floor.

2. If the liquid is spilled, wipe it immediately. Wipe the liquid immediately with a cloth or sponge. Do not allow liquids, including water, to stay on the floor for long periods of time. Liquids may cause stains or peel off the protective coating on the floor. Absorb the liquid into a dry cloth.

3. Use hot water instead of lukewarm water when washing the floor. This is because there are no blots on the floor. Water is the cleanest detergent, and the protective coating on the floor hardly peels off.

4. You can use a traditional mop. But a sponge mop makes it easier to control the water. You have to use a rag. If the water floats on the floor, it may leave stains or the floor may be distorted. In this case, you should wipe the floor with a damp cloth.

5. You can start from one end and drag to the other. Avoid dragging from the outside to the center so you don't step on the cleaned floor before drying.

6. If there is very little water on the floor, please let it dry on its own. Otherwise, wipe the floor with a clean, dry microfiber cloth. Do not use rough cloth as it may scratch the floor. Make sure the floor is not flooded with water for a long time.

The floor is sprayed with rice washing water and then sprinkled with wax, which has an excellent effect.

The effect of spraying rice washing water on the floor and then waxing it is absolutely wonderful. This novel method is actually very simple, specifically: wipe directly on the floor with a rag dipped in rice washing water, and then dry wipe.

Of course, you can also spray the washing water evenly on the floor and wait for 5 minutes, so that the dirt on the floor will "automatically" float to it. Rice bran water forms a membrane on the floor. At this time, without force, gently wipe the old cotton clothes 4-5 times, carefully wipe the floor clean, leave it for another 15 minutes, let the floor dry, and then wax the floor.

The floor is so polished and waxed that it is shiny and clean, and it is not slippery. The items needed are rice washing water, watering cans for spraying rice washing water (larger ones are easy to make), and old cotton clothes.

It may seem a bit troublesome to sprinkle rice water and then wipe the floor, but this method is really efficient and the effect is even more unique. In order to make it easier to wipe and clean, the furniture should be moved to the corner first. If the room is large, spray half of the floor before cleaning the other half.

Food stains should be sprayed with rice washing water to make them easy to wipe off.

Wipe the floor with fresh cream to make it brighter than with rice washing water, but it is easy to leave residue because of the high amount of oil, so it must be wiped vigorously.

Whether it's new, unwaxed or old, cracked floors, wax them first and dry them thoroughly before you start working.

1) Wax at least three times, and rub the floor with a non-fluffy cloth or waxer each time to allow the wax oil to penetrate the wood.

2) To get a shiny effect, gently rub and polish each wax with a soft cloth.

You need to pay attention when walking in the above methods to avoid slipping on the smooth floor.