Convert other formats to ari software.

To convert ** into text, we generally use OCR text recognition software;

It is important to note that the clarity of the text!

It is recommended that you can try the "**Free Transfer" software, this tool takes a screenshot directly, and then takes a screenshot of the text on the screen, directly recognizes, and the text comes out, you can try it.

OCR software, there are Hanwang, Shangshu No. 7, Tsinghua Ziguang, the effect I experienced is very disgusting, and I have never used it again.

There is also a mini OCR, which has a super ability to recognize text below 12 pixels, but it does not support elephant characters.

This type of software can recognize the text in the ** format to a certain extent.

But this kind of software is not completely accurate either. Just imagine, if it is a cursive text format, I am afraid that there are very few recognizable ones. Therefore, it is generally the standard font in order to get a higher recognition rate.

How to convert ** into text, you can try this method, and solve the problem of converting paper files into electronic files in one second.

That's the conversion to **, not the text.

1. The software installation is very simple, and it can be installed directly by default. Once installed, open the software.

2. If you don't insert a CD, you will be prompted to take a screenshot, insert a CD, if you have multiple CD drives, you need to choose a CD by yourself.

3. Check the audio that needs to be converted, if there are multiple audios at the same time, you can select more than one at the same time.

4. Set the output format, there are many formats below, which can be set according to your needs.

5. Set the output path, click Browse, and select a folder.

6. Click the "Start Extraction" button.

Hello, to engrave cd**, with nero is the best.

Burning a CD doesn't require converting *** to CD** format and then burning it into a disc, and this is not possible. Open Nero, add the *** you want, and then burn the **disc**, Nero will automatically convert *** and other formats to CD** format and then burn the disc automatically. By the way, it also depends on whether your CD machine is recognized, it is best if you have a recorder, the CD disk burned by the burning function of the optical drive may not be recognized on the CD machine, you can go to the special burning point to inquire about the relevant burning knowledge, or look at the relevant tutorials on the Internet.

Remember, the main thing is to see if your CD drive recognizes it after burning.

This shouldn't work.,***The bitrate is too low.,Can't turn.。

This kind of software is there, but the effect is very poor, many lines can not be read, let alone read out the layer, it is recommended to find a copy of the original CAD drawing or draw it again. The maturity of this kind of software cannot be compared with the pdf to the word software, especially the free software, renting Bila is even more pediatric.

I have a few springs, send it to your email first, you can take a look.

flash is a streaming file, and the whole world should be thinking about it like you ......

It is possible to listen quietly by a thousand thousands. Add the file to the list, right-click on the file, select: "Format Conversion", and you're ready to convert it to an audio file.

You can figure it out yourself:

Pay attention to the path to save the file after it is converted, don't find it after conversion!

In total---5 minutes to solve the problem!

You can try the tanuki nest software o( o