PSP3000 Charging Problems?

It doesn't matter, a lot of ** have been introduced, the lithium battery of small p is very convenient, and it is very different from the mobile phone battery.

This will reduce the life of the mobile phone battery, but a small P will not affect it too much. On the contrary, it is best not to wait until the battery of small P is out of power before charging, when the yellow light flashes, it means low power, and at this time, it is not as good as charging 15% or 50%. Also, don't plug it in for too long after the green light is full.

Nothing else to worry about.

You're too cautious, I'm afraid of losing power when I'm playing games, so I'm rushing while playing. If you want to go out, you are afraid that there will be no electricity, so you can charge it at any time. It never cares what the remaining power is, I bought it in 09, and now it's always good.

Although the PSP battery has no memory effect, the number of charges is still limited, so reduce the number of charges as much as possible, mine is less than 5% before charging, 08 years to now there are more than 3 hours to use, recently I couldn't help but change a big one, can be used for 7 hours.

Normal PSP, mine is, usually wait until he shows that the battery is low before rushing, if you rush like your cousin, within a hundred times, the machine is guaranteed to be broken. Because the general battery life can only be charged 100 times improperly, and the battery will not work after 100 times. I'm a lesson from the past.,I've broken a PSP because of charging.,The interface for installing the battery is stuck after a long time.。。

You don't have to be so careful about this charge, as long as you don't turn off because you don't have power.

The battery is broken.

The battery is fully charged with the cradle. Or fully charge the battery with a universal charger. The battery is broken, charged, not stored and has no power.

The lighter is easy to break the battery protection board, and there is no benefit, and the effect is the same as using a universal charger. However, lighter voltages are high enough to break down circuits.

The battery is over-discharged, the protection board is not output, and the battery cannot be detected when it is installed, so it is not turned on and not charged. A fully charged battery can be replaced and the machine can be turned on.

Bypass the battery protection board to charge the positive and negative poles of the battery, and the voltage will rise and resume normal charging. It's the effect of activation. The battery has a amount of voltage, it should not be over-discharged, and it should be able to be charged and turned on normally.

If the charging voltage does not rise, the battery is broken. Some batteries are broken and still have voltage for several years, but they don't have power. The charger is full and the power will be lost immediately when you take it down.

It is estimated that the power is locked. It will naturally be good to leave it for a few days. If you want to get good quickly, you can connect a small motor or small bulb to the battery to discharge, don't say you can't, just a simple circuit like junior high school physics. Don't buy a new battery. A few hundred dollars.