XP vs. XP How to interconnect computers

Use parallel lines to connect both computers to the hub.

Each computer is then assigned an IP address, and both computers should be on the same network segment.

For example, there are many ways to share.

One is to add a router between the modem and the hub, and set up Internet access in the router.

Convenient and easy to use. The second is to set up a network share on one of the computers.

The disadvantage of this method is that in order to access the Internet at the same time, the computer must be turned on.

My computer is also connected to two computers with one wire, I don't know how you connect, but I connect the wire from the outside to the hub given when I press broadband (it can only be one to one, I don't think it's very good), and then the line to be connected to the computer I connected to the other hub (I use the kind of one to five), and then connect two wires to the two computers. I have two computers that can access the Internet at the same time, and I don't have any shared stuff. You can try my method.

It's easy for me to use, but I don't know about you. Hope you can use it too.

Connect the broadband cat to the hub, and then connect the two computers to the hub, but the internet speed will be slow. It is recommended not to use the hub, but to change to a small road tour. The same connection.

Because you're using adsl to surf the internet. You have a hub and a network card. For the hardware, you've got it all.

Now you just need to configure it in your cat. Enable the routing function.

The specific equipment depends on the brand and model of your cat.

Connect the network to a normally open computer, do the first server, which machine is better to have two network cards, and then connect it to the hub, and then connect the hub to another one. Then set it up.

Step Method.

Here's how to set it up: Open Control Panel - Network Connection - Right-click "Wi-Fi Connection" - Properties - Internet Protocol.

2.Step 2: Go back to the interface of the "Wi-Fi" attribute, click on "Wi-Fi Configuration" - Advanced, and select "Computer to Computer Only". The above 2 steps are to be performed on each computer.

3.Step 3: Choose a machine as the server. On the Wireless Network Configuration page, click Add.

4.Step 4: For the security of the LAN, in the pop-up page, it will be"This key is automatically provided to me"The front tick is removed.

Then set the SSID number and the network key (a 16-base character that must be 0-9 or a-f.).This set of characters requires 10 characters), click OK and the server setup is complete.

A: The machine sets the wireless network card status to AP or shared B. Find A's wireless network name directly in the wireless list and connect The network speed is very slow.

The first method is to buy a router and connect it. It's easy to set up an IP address.

The second method is to make use of crossover lines and then set the IP on the same network segment on both computers;

For example: a: b:

Just connect a crossover wire, and then connect to the small switch.