If the computer opens the program, it will be stuck, and it can only be turned off to start! Tell me

If it is solved, you don't need to look at it, it is not solved, then troubleshoot the hardware compatibility problem, start with the memory, you try to change the memory slot, if it can't be solved, then it is recommended to send it to the place where you assembled the computer, tell the problem to help solve it, after all, there are many hardware, you can troubleshoot, (at the beginning, we installed a new set of computers, every time you enter the system, it crashes, no matter how you use it, it will die, it will die when you open it, all the hardware has been changed over and over again, and the final problem is on the CPU, how did you not expect it.) )

If you buy a computer online, there is no hardware replacement troubleshooting, also go to the computer company to send it for repair, software problems we can solve by ourselves, hardware problems, after all, is not obvious, the most effective is the "replacement troubleshooting" and so on to find the cause, then you can deal with it.

The above information manual code words、Please cherish the fruits of labor!

Your configuration is enough, it is estimated that it is affected by the inferior power supply, the direct point is that the power output is unstable, the voltage fluctuation is too large, quickly change the power supply, otherwise the motherboard capacitor is easy to bulge.

What is your power supply? Is the power supply bad? It is also possible that there is a virus, which has an impact on the operating system, and too many plug-ins also have an impact.

The configuration is very good.。。。 If it's not a hardware break, you can try to reinstall the system and find a better system disk or resource--

There is another important parameter that has not been reported. The size of the video memory, whether it supports 3D, whether there is acceleration or not, and the memory usage of 80 is considered very high.

Don't listen to what is wrong with the computer.

You first try online neighbor --right--properties.

There is a local connection and a broadband connection.

Right-click Local Connection --- Properties --General.

Internet Protocol: Double-click.

Automatically obtain IP addresses and change them to manual.

Subnet Mask: Default Gateway:

Next, select the following DNS server address, and then don't double-click to confirm.

The main reason for the slow response is that the computer automatically obtains the IP when it is turned on, but if you are not connected to the Internet, it will keep getting until it times out, and as soon as it times out, it will automatically stop, and your computer will return to normal.

First you reinstall the system, sometimes the restore doesn't work. There are many kinds of crash problems after installation, the hard disk may have bad sectors, or the graphics card may not work In short, where you buy it from, you can find where to solve it, you can't solve it yourself.

Why use another system disc to reinstall the system? This is because one-click restore is not a panacea either.

If there is still such a problem after reinstallation, start from the hardware aspect, the first is to clean the dust, and the second is to pay more attention to the temperature of the memory and CPU, the speed of the fan, and plug and unplug the memory if you can.

If you can turn it on, it means that the hardware is fine. Maybe the hardware driver is not quite right. And the same can happen with poor memory compatibility.

Hard drive problem, I once encountered the same problem, the hard drive has a bad area, fortunately it is still within the warranty period, so I replaced a hard drive.

You can use hard drive detection software to check if there are bad areas in the hard drive.

Don't worry, you can ask someone to borrow a power supply to try If you change the power supply or this, it doesn't matter about the power supply The temperature is too high, you have to see if the CPU fan is turning Then open the cover next to the host Take out the memory graphics card and wipe it Try again If this is the case, there may be a problem with the motherboard I also have such an experience It is a problem with the motherboard The best way is to get to the customer service place and let them help you test it

It's kind of like the power supply is not enough power. Is the power supply 300w? You can try changing to a 350W power supply.

There are also computers that have been used for a long time, and this phenomenon will also occur when the motherboard is aging.

Most of them are due to insufficient power supply. I don't know the specific configuration of your computer, so I can't be sure.

And do you see if the capacitors on the motherboard are broken? Visually see if the top of the capacitor bulges. If the capacitor is broken, it is not expensive to repair, 30 yuan to 50 yuan.

Then you can install software such as a driver wizard on your computer to see the temperature of the CPU and the temperature of the fan.

The problem may not be one place! There are three main problems.

Explain that the Adobe related software on your machine is associated with the right mouse button, and you can try to uninstall the Adobe software.

Adobe software is software like Photshop!

Check the memory and hard disk.

It is estimated that it is not a software problem, and the memory is more likely.

I've had this problem with you, and I was in a bad power supply at that time.

A friend's also encountered it once, and it was a matter of CPU and fan.

Yours should be a bigger problem on the motherboard, it is recommended to reinstall each component, wipe the gold finger part with a coarse cloth, wipe a little silicone on the CPU, if it is good, reinstall the system.

Conditionally borrow a power supply and try it out.

It is recommended that you rearrange the wires in the case and press the plugs again, it may be a bad contact.

1. Try changing the power supply. 2. Whether the restart button is normal.

If you're new, it's usually a matter of the wire, so plug the line back in!

Not necessarily. The computer will automatically close the software.

Yes, it's okay not to turn it off, but it will have an impact on the system.

1. Open the case, remove the dust, check the heat dissipation of the CPU and graphics card, and oil the fan.

2. Antivirus. Unplug the network connection, turn off System Restore, and use the latest version of antivirus software to kill the virus in safe mode, and it is best to change to another antivirus software to kill again.

3. Use the optimization master or Super Rabbit or Huangshan Repair to repair and repair IE.

4. Clean up and defragment disks.

1. In the window of my computer, right-click the drive letter you want to clean up - "Properties" - "Clean Disk" - check the files you want to delete - OK - Yes.

2. Clear the temporary file, start-run-enter %temp%-OK.

3. Clean up the registry and junk files with Optimizer or Super Bunny.

4. Close some startup programs, start-run-msconfig---start, in addition to anti-virus software, input methods can be turned off in general.

5. Delete unused program software.

5. Upgrade the graphics card and network card driver.

6. Increase the physical memory, replace it with high-quality memory, and set up virtual memory reasonably.

1. To play games, the virtual memory can be set to be larger, the minimum value is set to 1-2 times of the physical memory, and the maximum value is set to 3-4 times of the physical memory. If you want to do more than 1GB, you can set it to automatic.

2. The method of setting virtual memory is: right-click on my computer - Properties - Advanced - Performance Settings - Advanced - Virtual memory change - Select the partition where the virtual memory (page file) is stored in the drive list - Custom size - Set the value in the "Initial Size" and "Maximum", then click the "Settings" button, and finally click the "OK" button to exit.

3. The partition where the virtual memory (page file) is stored must have enough space, the hard disk resources are insufficient, resulting in insufficient virtual memory, in a computer, it is enough to set up virtual memory in a partition, it is not necessary to set it in multiple partitions, it is best to set it in a disk other than the partition of the system.

7. Optimize your computer with Optimizer or Super Bunny.

Just one memory (it should be one),,There will be no conflict,If there is a problem, use the substitution method,Determine whether there is a problem with the memory。

What program you are opening is dead (does not rule out problems with the program), whether it will be restored, what system.

Would like to ask what your power supply is.

Update the driver of the graphics card again.

It's definitely not a memory problem.,It should be that your computer runs a lot of programs that you can't see and don't know.,It is recommended that you use 360 to clean it up.,If it still doesn't work, reinstall the system.,Your computer configuration is very high.。

The motherboard and your other compatibility are not good.

Remember to install the graphics driver, it won't be very slow.

See if there is a virus, turn off the network port on the machine unnecessarily, if it still doesn't work, then reinstall it and try.

If you root it first, transfer the data first, and then format all the hard disks, maybe your hard disk has bad sectors, or there may be a problem with the system, no matter which one is to reinstall the system.

The fastest and best way is to reinstall the system, one-click ghsot, don't get tangled, that's all!

There may be one on it that is in a hibernation state when it is turned off.,And turn off the power button again.,I don't know.,I'm using the XP system.,The Vista version is unstable.,My notebook was installed at the time and I changed it.,It is recommended that you still change the system at the best.,Wait for Vista's stability to install again.。

All electrical equipment should be disconnected, and so is my house.

Regarding the second question, it is because of the physical problem of coil electromagnetic induction.