You need to press F2 to turn on the computer. 50

Your BIOS battery is dead, save the BIOS and can't power it, just replace it with a battery. Note: F2 reads the default settings to the computer.

You go to the BIOS and look for an "Probably Yes" option! Just before the option you slowly find the enter is to view the esc is to cancel! Find that and then change him to no is the first option! Then press F10 to save it.

Replaced the motherboard battery! It's the motherboard BIOS, there's a battery there!! Trick-or-treating!

The same problem,Help,I don't understand what I'm talking about below.,It's not good.,Every time you press f2,,The time of the computer is 0.Finish.

1. First, we translate the English meaning, and then press the F2 key to continue. Press the DEL key to enter the settings interface.

2. Then let's try pressing f2 to see if there is any reaction. If there is, then proceed. If there is no response, then we will press Del to enter the BIOS settings interface.

3. After entering the BIOS interface, we found the default value of load optimization in the standard COMS function interface. After clicking OK, we can press F10 to protect the front and shout to save it.

4. After the above operations are done, you can restart your computer to see if you can enter. If it still can't bleed dust, then we also enter the standard CMOS function and then set drive A to none and set floppy disk 3 mode support to disabled, which means turning off the floppy drive.

5. You can also find the floppy disk drive in the device management of your computer, and then disable it.

1. Press F2 when booting up, which means that when the computer is turned on, press F2 to Continue, Del to enter setup, that is, press F2 to continue, and press the Del key to enter the setting interface.

2. (Some motherboards may prompt press the F1 key to continue) Its solution needs to prepare tools, a flathead screwdriver, a keyboard (if the keyboard is unresponsive, it is recommended to use a keyboard with a PS2 interface for operation), and a new CR2032 coin cell battery.

3. Press F2 when you boot up, first of all, it may be that the computer is not installed with a floppy drive or the floppy drive is faulty, but there is a floppy drive in the BIOS, which will cause F2 prompt.

4. After entering the BIOS, please select the first item "Standard CMOS Features".

5. Set "Drive A" to "None" and "Floppy 3 Mode Support" to "Disable".

6. Return to the main BIOS settings interface, select the "Advanced BIOS Features" setting item, and press the Enter key to enter.

7. Set "Boot Up FloppySeek" to "Disabled".

8. Press F10 to save, exit the BIOS setting with ESC key, and restart the computer.