Is there a relationship between the gas water heater and the cabinet that is too close to the home d

Home decoration gas water heater.

It is too close to the cabinet, if it does not affect the heat dissipation, it is irrelevant, but the basic requirement is to leave a maintenance operation distance (10cm-15cm is recommended). For safety reasons. The state requires the current gas water heater to adopt a balanced type, the exhaust cylinder of this gas water heater is double-layered, the inner layer exhaust gas, and the outer layer enters fresh air, so it does not consume indoor oxygen, and it can be directly installed in the bathroom.

But the installation of a gas water heater should also pay attention to the following issues:

1. Installation problems of gas water heaters:

1) The installation should be carried out by professionals with gas appliance installation qualifications according to the regulations, and blind installation should be eliminated.

2) Selection of installation room: It should not be installed in a room that does not allow the installation of gas appliances in the code, such as bedrooms and living rooms.

Toilets and other places.

3) The wall surface of the gas water heater installation should be close to the outside, and the principle of smoke pipe setting is "5 meters 1 bend, 3 meters 2 bends", and the ultra-long or elbow will affect the use of gas appliances.

2. Attention to the safe use of gas appliances:

1) In addition to closing the valve of the gas appliance when deactivating, it is recommended to close the valve before and after the meter, especially when you are on a business trip or away from home for a long time.

2) Gas is colorless and odorless, in order to ensure safety, the gas company will add odorant to the gas, and people will be aware of the leakage in time, so if you find that there is a gas smell, you can open the window for ventilation, and check the interface of each equipment by yourself with soapy water foam. If you find that the leakage is a problem and you can't deal with it, close the valve, go outside and call the gas company to repair it, and the gas company will come to repair.

3) It is recommended to install a gas alarm shut-off valve to increase the safety factor.

4) Regular manufacturers buy national standard gas appliances and pay attention to the service life.

5) It is recommended to use long-life corrugated pipes for gas appliance connecting pipes, because the rubber pipes used before are easy to age, and the low strength requires 1-2 years to replace, which is too troublesome.

6) Clean energy.

It is convenient and fast, and we must be familiar with the basic common sense.

If you install a gas water heater at home, if the surrounding air circulates and does not affect the ventilation and heat dissipation, it doesn't matter if you are close to the cabinet. But the vents must be vented outside.

There is no problem, the current water heater air intake is in the back, just use it with confidence.

The gas water heater should not be too close to the cabinet for home decoration, and there should be a specified distance. It's safer this way.

As long as it is more than 20 centimeters, it has no effect.

Gas water heaters cannot be installed in cabinets, they must be installed in ventilated places, and according to the installation specifications of gas water heaters, they must be uncovered. Gas water heaters are prone to accidents if placed in a closed place.

Gas water heater, also known as gas water heater, refers to a gas appliance that uses gas as fuel to transfer heat to cold water flowing through the heat exchanger through combustion heating to achieve the purpose of preparing hot water.

The gas water heater is mainly composed of valve body assembly, main burner, small fire burner, heat exchanger, safety device, etc., and also includes the flue of flue water heater and the strong discharge device of strong discharge water heater. The valve body assembly controls the working procedure of the entire water heater, which includes water valves, air valves, micro switches and ignitions. When installing a water heater, valves should be installed on the inlet pipe, outlet pipe, and gas pipe.

In the early 70s of the 20th century, *** went to Europe for a visit, and when he passed through Hong Kong on the way back, a progressive person gave him two 5-liter in-line water heaters. After returning to Beijing, he instructed relevant people to develop this product, and under the attention of the people, the door of modern water heaters into ordinary people's homes was slowly opened; In 1979, China's first gas water heater was successfully developed in Nanjing Yuhuan Water Heater Factory, marking the end of the era of Chinese civilian pot boiling water bath, and the people's bathing life entered a new era.

China's gas water heater has gone through 5 stages: straight discharge, flue, strong discharge, balance, and outdoor type, and every step is a technological breakthrough, all of which are in the bath"Safety"with"Comfortable"last step forward. Among them, the in-line water heater completed its historical mission by June 2000 and was forcibly banned from sale and use by the state; China's gas water heater implementation standards have also been experienced"86 standard, 94 standard, 2001 standard, 2015 standard"The four standards, each time the standard is updated, it marks a new level in the design and manufacturing of gas water heaters in China, and also raises the entry threshold of the industry.

First of all, there are many restrictions on gas meters and gas water heaters, and some of them are not up to us, so who is the one who restricts us?

It is the gas company, when the gas company is ventilated, it will come to the door to check, if it is checked that the gas meter is installed in the cabinet or wall cabinet, it may not be done, and it may be said that we will rectify. And because the gas company is a monopoly, it is not like buying things, this one can't do it, buy from that one. Therefore, the management of each place is not the same, even if it is the same company, different gas acceptance masters, the final result may be different.

The gas water heater is in the wall cabinet because the gas master has to check it when ventilated, and the service staff of the gas company will also come to inspect it every year, so we must do everything foolproof, so that they are unreasonable.

So I suggest that if you want to install the gas meter in the cabinet, our gas company here stipulates that you can make a few holes above and below the wall cabinet board, and make a few holes of 5-10cm. The purpose of this is to facilitate the intervention of the air and there will be no danger.

If the gas water heater is installed in the wall cabinet, I suggest that you don't punch holes, it is better to remove the upper panel and the lower bottom plate, and then only make a cabinet door, so that you can do it. The gas company couldn't find anything wrong with it, and it was up and down.

Precautions for installing air energy water heaters.

1. Before the water pump and water heater, a filter must be installed, and the whole system must have at least one check valve.

2. The inlet and outlet of the heat pump must be installed with tee, and the gate valve must be installed after the cleaning port is reserved.

3. Three-way external gate valve, if necessary, use two reserved ports to empty and add oxalic acid to clean the air energy water heater.

3. The ventilation conditions must be good, and it is best to place the air inlet in the direction of solar sun, which is more energy-saving.

4. The foundation should be higher than the ten-year average water and snowfall height to prevent the bracket from being corroded by water, resulting in the tragedy that the machine is not broken and the nails are broken.

1.Punching: Before punching, the master should first take a measurement, and then punch the hole on the wall according to the measured data.

The storage water heater must be installed on the load-bearing wall, otherwise there are potential safety hazards, if it has to be installed on the light wall, it must be installed below the bracket or other treatment. It is also a skill to drill holes in the tiles, first use a fine drill bit to grind a small hole to fix the hole position, and then use a thick drill bit to slowly grind the tiles through with a slow gear, and then use the impact gear to drill the hole deeply, so that the general tile will not crack.

2.Hang the gas water heater: drill a dozen, fix the screws, and then hang the gas water heater.

At the same time, it is necessary to ensure that the water heater is firm and not loose. The installation height is generally 165 175 cm, and the fire window is parallel to the person's line of sight. After fixing the water heater, it is necessary to fix its hot and cold triangle valves.

It should be noted that the outlet pipe (hot water) should not be equipped with a valve, otherwise it will affect the water output and affect the use function.

3.Exhaust pipe and threaded pipe installation: connect the reserved cold water pipe to the water heater.

To choose the right water pipe to connect the reserved cold water pipe with the water heater, you can generally use a special metal hose and choose a water pipe that is not easy to age. At the same time, don't ignore the installation of small details, the installation of exhaust pipes and threaded pipes is equally important. The exhaust gas exhaust hole of the water heater should be opened separately, and the public exhaust hole should not be used.

After the installation is completed, the overall test should be carried out, and the gas should be turned on, the electricity should be turned on, and the test should be carried out to test the heating function of the water heater and whether the water pipe is leaking. After that, it is necessary to test the pressure and carry out the compactness test to ensure the safety of use.

Installation Order Recommendation:

As long as the pipes are arranged, they can be in no particular order.

But the water heater and the gas connection of the gas pipe is a hose, it is necessary to open a hole in the cabinet, it will be better to install the water heater first, because the water heater needs to be debugged, there will be water discharged and often discharged in the cabinet, if the water heater and the wall cabinet are on one wall, you can consider letting the cabinet company make more wall cabinets to wrap the water heater, which will be more perfect.

If the wall cabinet and the water heater are not on the same wall, then pay attention to the location and space of the gas meter pipe in the low cabinet, if the water heater and the wall cabinet are on one wall, you can consider letting the cabinet company make more wall cabinets to wrap the water heater, which will be more perfect.

The gas pipe that connects the water heater to the gas is the hose.

It is necessary to open holes in the cabinet, and the water side of the basin cabinet should also be opened, but some cabinets are not directly equipped with a back panel.

If the cabinet and the water heater are not on the same wall, then pay attention to the location and space of the gas meter pipe in the low cabinet, if the water heater and the cabinet are on one wall, you can consider letting the cabinet company make more wall cabinets to wrap the water heater, which will be more perfect.

1. Design it first, it doesn't matter which order the water heater and cabinet are, just reserve a seat in advance; Consider the location of the outlet and inlet and outlet pipes of the water heater's smoke exhaust channel.

2. During the decoration, bury the gas hard pipe (copper pipe) to the position where the water heater is installed, and leave the interface about 100mm out of the wall; Then attach the porcelain piece to the wall, and then install the water heater with a hose connection.

3. It's beautiful. There is no certain sequence, but it is important to pay attention to a few key issues to consider when installing a water heater: the location of the connection of the gas pipeline; the location of the electrical outlet; the location of the outlet of the smoke exhaust channel of the water heater; The location of the inlet and outlet pipes.

These issues should be considered in unison, otherwise they will be very passive.

For more information about cabinets, it is recommended to choose a natural home. The Konecranes Whole House Custom Cabinets under Nature Home make the environment suitable for human behavior and needs by studying the physiology and psychology of human beings and applying them to the design of the whole house. Using the principle of ergonomics, in the overall customization planning, according to the individual differences and behavioral commonalities of human beings, it fully meets the personalized operation needs of different consumer groups, and at the same time conforms to the flow process of the home, and its appearance design meets the aesthetic standards.

The "Nature" brand has been continuously selected as one of the top 500 most valuable brands in Asia, and is deeply trusted and loved by real estate companies and consumers.

Gas water heaters are mounted on the wall independently and have nothing to do with kitchen cabinets.

If the trachea needs to pass through the kitchen cabinet, then drill the eye to pass through.

But most of them are preset in the wall, with three inner elbows side by side. The trachea can be connected with a hose.

Finally, installing the water heater is a standard process.

The whole cabinet should be ordered before the home decoration

That is, on the same day, they were called together and asked to coordinate the installation

All you have to do is inspect the goods at home and pay for them

No matter what is installed, you must carefully accept it, otherwise you will be very troublesome later

The plumbing must be done before the cabinet, and the hose that connects the water heater can be asked by the cabinet company to reserve the pipe or hide the wall, but it is recommended that you do not conceal it, because it is very troublesome to replace.

It doesn't matter which comes first or the cupboard, as long as you reserve a seat in advance.

There is no certain sequence, but there are a few key issues to consider when installing a water heater:1the location of the connection of the gas pipeline; 2.

the location of the electrical outlet; 3.the location of the outlet of the smoke exhaust channel of the water heater; 4.The location of the inlet and outlet pipes.

These issues should be considered in unison, otherwise they will be very passive.

The two do not affect it, and the connecting pipe of the general gas company is a stainless steel pipe. I bought a soft hose myself. The gas pipes in the kitchen you mentioned are just punching holes in the cabinets. The rest is the work of the gas company.

Install the water heater first. The connected tube is the kind of soft rubber tube that can be bent. You can also. The gas switch and various pipes are inside the cupboard. A professional master will get it, and it's very reasonable.

I also just finished installing the cabinets, and the water heater had to be installed before installing the cabinets. We are walking in the dark pipe, and the pipe in my house is close to the ground.

The gas water heater and kitchen cabinet are both wall-mounted, which can save time and trouble by installing them at the same time.

Install the water heater first, and the cabinet designer can design your cabinet according to the location of the water heater.

Hose Install the cabinet first, but plan the location of the water heater.

Damn, of course, it's a gas water heater now.

1. Install the water heater first.

2. a hose. 3. Yes.

Install the cupboard first, then the water heater.

It is best to install a gas water heater five centimeters away from the cabinet, which is safe and beautiful and conducive to maintenance.