How do hairpins look good? How to make hairpins look good

Tools required: hair rings, hair clips.

1. Tie three ponytails separately and don't pull your hair out.

2. Now grab the three hairs together.

3. Tie them together with a rubber band.

4. Be careful not to mess up your hair when tying it.

5. The effect of piercing.

<>7. After getting it, spare the ponytail that grows out to the ponytail and clamp it tightly with a hairpin.

1. First roll the hair out of the middle part, pick up the bangs part of the hair, gather it from both sides of the forehead at the back of the head, synthesize a strand of braids, twist the ** bundle, and fix it with a hairpin.

2. Gather all the hair with your hands, make the action of tying a ponytail, gather the hair together in a slightly lower position, twist the ** bundle, and form a hair curl, this hair curl does not need to be too close, and it doesn't matter if there is broken hair. Hair clips are then used to hold the ends of the hair together with the base of the twisted ponytail.

3. This hairstyle is actually very simple, in fact, it is to comb a low ponytail but fix it with a hairpin, and it should be noted that the ends of the hair must be curled to make the ponytail look messy and fluffy. The hair on the top of the head should be slightly fluffy, so that the head shape will be more three-dimensional when viewed from the side.

4. It is not so easy to create a seemingly simple hairstyle, especially if you have a sense of style in it. Gently lifting the parted bangs above the ears and rotating inward** to secure with a bobby pin, this hairstyle is perfect for long, straight hair with a slight curl, making it both convenient and versatile as an everyday hairstyle.

Here's how to make hairpins look good:

Tools Raw materials.

One thin ribbon (ribbon width 1 cm), one medium ribbon (ribbon width cm), and one bridge finch thick ribbon (ribbon width 4 cm).

A hairpin and a round ornament.

One roll of double-sided tape, one roll of thread, one hot melt glue gun, one pair of scissors, and one ruler.

Method steps.

1.After preparing the relevant tools and materials, we take a medium ribbon and a thick ribbon with a length of 300px.

2.After taking the ribbon, we glue the double-sided tape on one side of the thick ribbon, tear off the protective film after gluing, and stand the middle ribbon on the thick ribbon.

3.Next, we turn the glued ribbon over to the reverse side, glue double-sided tape on one side, and then pick up the other side and glue it to form a circle.

4.We pressed the glued ribbon in the middle, and then pressed the ribbons on the left and right sides into the same shape as a butterfly. Tie it with a thread so that our shape is fixed.

After fixing, adjust the shape of the butterfly a little to make the butterfly clip look more beautiful.

5.After the butterfly is ready, we need to perfect the hairpin and take a thin ribbon of 6 cm. This length is determined by the length of the hairpin, and if the hairpin is longer, you may need to take a longer ribbon. Stick the double-sided tape on the hairpin and tear off the protective film.

6.After tearing off the protective film of the double-sided tape, stick the thin ribbon of the length we took just now to the hairpin, treat the tail after gluing, and fix it with glue later, it will look better.

7.Use a hot melt glue gun to fix the bow on the hairpin, and fix the round ornament in the middle of the bow, press it, so that the fixed sensitive manuscript is more firm, so that our bow hairpin is completed.

Method steps.

The bow hairpin is looped with 4 braid pins, 3 long stitches, and 4 braids, hooked on both sides, and glued to the hairpin.

Small flower hairpin, ring up 1 standing needle, 6 short needles, and then a standing needle, short needle plus needle to 12 needles to complete.

The most common hairpin without a pattern is to take 9 braids and then stand up on one, 4 short stitches, 1 medium long stitch, 4 long stitches, 4 braids, and crochet on the other side.

Small strawberry hairpin, start with 6 short needles, add needles to 18 needles, and finally 3 needles and end with one needle.

6 needles from the red thread of the watermelon hairpin, add to 15 needles, change the white thread to 4 short needles, add short needles, repeat 3 times, change the green thread fabric and hook 9 short needles.

The ice cream hairpin is a little more difficult, loop up 6 short needles, add 12 needles, and hook an ice cream head in the third circle.

Cute double clamp method.

The cute and mischievous double clamping method involves parting the hair in a natural middle and then clipping a nice clip on the top of the head on each side. A diamond-encrusted clip like this one is even more dazzling and must be very beautiful in the sunlight. This kind of cute and naughty double clamping method will be more suitable for some girls with sweet temperament.

The single clip method refers to clamping a good-looking clip on the side of the top of the head to play a stronger decorative role. Like this clip above the ear, with a bit of literary style, it is also called the literary single clip method. It will be more suitable for some girls with delicate and sweet faces, especially the slightly curly hairstyle can also create a lighter volume.

Here's how:Tools required: hair ties, large grips.

1. Tie three ponytails separately and don't pull your hair out.

2. Now grab the three hairs together.

3. Tie them together with a rubber band.

4. Be careful not to mess up your hair when tying it.

5. The effect of piercing.

<>7. After getting it, spare the ponytail that grows out to the ponytail and clamp it tightly with a gripper.

If it is a horizontal clip, clamp it from back to front.