The laptop screen protector got into the water, can you blow it dry from the outside?

How to deal with laptop water ingress:

1. Unplug the power supply and battery immediately, the speed of power off directly determines the most critical factor in the severity of the damage to the notebook.

2. Pour out the water immediately according to the direction of the water intake, and quickly dry the water with a dry towel or paper towel. If there is water on the top of the keyboard, immediately turn the keyboard down (be careful not to let the water flow into the LCD screen), and try to pour out the water to avoid more water entering the motherboard.

3. If the notebook keyboard gets into the water, remove the keyboard and observe whether the water has entered the motherboard. Carefully dry the front and back of the keyboard with a paper towel. If possible, you can use a hair dryer to dry it with cold air, and be careful not to use hot air, because the keyboard keys and other keys are plastic, which is not resistant to high temperatures, do not use hot air, and avoid blowing damage.

If the liquid is cola, vegetable soup, etc., you need to remove some of the buttons and carefully scrub them with pure alcohol. Because cola and other substances contain sugar, if it is not clear, it will corrode the wiring over time and cause damage to the keyboard.

4. Completely disassemble the motherboard, if you will not disassemble the motherboard, it is recommended to find a professional maintenance personnel to deal with it. Observe whether there are water stains on the motherboard, and if so, carefully wipe it clean with pure alcohol. In the maintenance of notebooks, the motherboard is scrubbed with high-quality plate washing water, not the ordinary plate washing water.

This can be replaced with pure alcohol, which must be used with pure alcohol, not aqueous alcohol. Then dry the motherboard, or the hair dryer should not be too high, and pay attention to protect the plastic connectors on the motherboard.

5. Do not power on and turn on the machine before processing. Because the general user has no professional drying equipment, it is necessary to let many accessories be thoroughly dried as often as possible.

OK,Computer screen protection,Since it can get into the water,It means that the quality of the paste is not good,Secondly,Even if it is dried, there is no such effect,It is recommended to start with a new film。

If the machine with water is not treated, even if it is temporarily good, there will be sequelae, and the water will slowly corrode the motherboard and chip, and finally it will not be repaired if it is broken.

Workarounds for water ingress on your laptop:

Power off your computer first.

After powering off, be sure to remove the external power adapter. In order to avoid unexpected situations during subsequent processing, remember to remove even the battery of the laptop (only for models with removable batteries).

Remove the hard drive and optical drive module that contain valuable data.

Drain the water that remains on the machine.

Wipe down your computer. Do not try to turn it on again, and immediately return it to the service center to be repaired by an engineer.

There is not much water ingress, the problem is not big, if there is more water ingress,. It is recommended to disassemble and check whether there are water stains on the motherboard, otherwise it will corrode the motherboard after a long time.

In order to avoid hardware failures, it is recommended that you contact your local HP Care Pack Service Center to help you test it, and if there is no problem, you can continue to use it. You can find the nearest HP Care Pack Service Center by following **:

We hope you find the above reply helpful.

It should be disassembled and dried at the beginning is the correct way, after all, the whole machine is dried directly, the water volatilization process will be slow, and water stains or rust will form in the motherboard.

It does not affect the use at this time.

Generally no problem! However, it is best to take it to the repair station after the water has been in, but since you are done, it doesn't make much sense to take it now!

The problem is not big, there are few impurities in the water, and there is no corrosiveness. If it's any other liquid, it's troublesome.

There is no big problem, pay attention to maintenance in the future, be careful.