How to plug in the Grantech host switch cable if it drops

Leakage Grounding Neutral Wiring Switch Closing Late Switch Duplex Switch Light Control Switch Flux **Expert regedit regedit 11960 issues solved: 6 1 Solved. Thank you 6 1 As soon as my computer is turned on, it shows this 6 1 How do I delete it?

6 1 Why do two language bars appear on the computer 6 1 When loading the computer theme, the system prompts that the theme service is not running and cannot be....6 1 The computer disk can't be opened! You can't use Explorer either! The above shows that the system is looking for....6 1 How do you get the address bar out?

6 How the 1XP system changes the account.

It varies according to each motherboard.

Each motherboard cable is also plugged in differently.

Most of the motherboards on the market.

There are terms interpolated.

Start by unplugging the power supply.

Found on the motherboard.

powerw

resetsw

hddled (hard drive status indicator).

- (Power indicator.) Pay attention to the positive and negative poles).

Follow the tips above to find the pins for your motherboard.

Just plug it in.

OK done.

There are two ways to do this.

1 is to enter BI0S and set it to start automatically when it is powered on.

2 is to install 1 time relay. , connect the normally closed contact to the power switch, and engage after powering on for 3s.

It varies according to each motherboard.

The plugging method of each main board connection line is also different.

Most of the motherboards on the market.

There are terms interpolated.

First of all. Unplug the power supply hail imitation.

Found on the motherboard.

powerw

resetsw

hddled (Hard Disk Status Indicator of Source Detection Light).

- (Power indicator.) Pay attention to the positive and negative poles).

Follow the tips above to find the pins for your motherboard.

Just plug it in. OK done.

Schematic diagram of common 9-pin panel connection jumper:

The above picture is a schematic diagram of the 9pin definition switch reset power lamp and hard disk lamp, and it should be noted here that the 9pin is not defined, so you don't need to plug this one when plugging in the jumper. When connecting, you only need to connect according to the above diagram. Among them, the power switch (power sw) and the reset switch (both are not divided into positive and negative poles), and the two indicators need to distinguish between positive and negative poles, and the positive pole is connected in the direction close to the first pin (that is, the direction with a thick printed line).

It is also very simple to distinguish between positive and negative wires on the chassis, generally speaking, the colored wire is the positive pole, and the black and white wire is the negative pole (grounded, sometimes denoted by GND).

Here can be summarized in 4 sentences 9pin definition switch reset power light hard disk light position:

1. Plug in the power supply next to the missing pin.

2. Plug in and reset opposite the power supply.

3. Plug in the power lamp next to the power supply, and the negative pole is close to the power jumper.

4. Insert the hard disk light next to the reset, and the negative pole is close to the reset jumper.

I'll give you **, there are two kinds of motherboard switches, which are also very simple to connect, the switch wire is not positive and negative, even if it is plugged in, it will not burn, rest assured