What should I do if I spill a glass of water on the computer desk and the mouse is inflexible

If the water doesn't get into it, it's fine, and it can't get into the motherboard. Underneath the entire keyboard is a plastic plate, and underneath the board is the motherboard.

It's OK to dry and be useless, and you can't guarantee it if you get into the water anyway.

Don't rush to turn it on, wait two more days, blow it with a hot breeze, and be sure to wait for the water to dry!! As long as the water is dry, it's fine.,I have classmates who also poured water in the book.,Hurry to turn on.,Just waited for more than a day.,The result is that the motherboard burns,,The reason is that the water hasn't dried yet.。

1.It is advisable to unplug the power source and battery as soon as possible after water ingress.

2.Don't power it on again, take the motherboard out completely, clean it with board washer, and dry the motherboard to 100 degrees with a dryer. to power on again. Don't leave anything to chance.

3.The laptop is flooded, and after the user turns off the computer and dumps the water, there is no other treatment, and after leaving it for a period of time, the computer is turned on.

Generally, there are two results at this time: one is that the machine cannot be turned on, and the other is that the machine can be used normally temporarily.

4.It is quite dangerous to re-power this kind of untreated water ingress laptop, and if there is very little water in, and it does not enter the motherboard and keyboard, the machine may be fine. But more often than not, after a few days or weeks of reuse, the laptop has a black screen again or cannot be turned on or some functions are malfunctioning, then the laptop is quite dangerous, and the repair rate is very low.

When the machine is flooded, first of all, it is necessary to shut down the machine and remove the battery at the fastest speed to prevent short circuit, and then remove the main board of the machine in the shortest possible time, and then put the parts for one night to let it evaporate water.

It should be a matter of rice Now most of the keyboards in this book are waterproof plus your approach is very right for power outages and then power on after drying, even if there is a certain amount of corrosion or something, just don't short circuit This corrosion is estimated to be no problem in a few years.

After the water enters the notebook, you should unplug the power supply immediately, and then disassemble and clean up the motherboard, keyboard, and liquid parts, etc., and then turn on the test after cleaning, if there is no problem, you can use it with confidence, otherwise you need to send it to a professional repairer for maintenance.

I'll help you in Beijing.

If you are not in Beijing, it is recommended that you find a reputable and skilled repairer to help you overhaul.

First of all, you have to turn off the power immediately, and then turn the book back, shake it around, and see what structure you have in this book, if the water does not penetrate into the motherboard or other PCB boards, then it's fine, the circuit board inside the keyboard has a certain waterproof function.

When the water is completely dry, I'm blowing it with a hair dryer, I'm trying to turn it on. Be sure to wait for the water to dry completely.

It is recommended to turn it off immediately and use a hair dryer to blow it well.

Enough to dry before reuse.

If water gets in, you need to unplug the power and battery immediately, and the speed of power off is the most critical factor that directly determines the severity of the damage to the laptop. Don't start shutting down slowly, and then shut down when the system shuts down normally. If it's slow, it's quite dangerous.

Then you remove the keyboard and observe if the water gets into the motherboard. Carefully dry the front and back of the keyboard with a paper towel. If possible, you can use a hair dryer to dry it with cold air, and be careful not to use hot air, because the keyboard keys and other keys are plastic, which is not resistant to high temperatures, do not use hot air, and avoid blowing damage.

If it still can't be turned on after it has dried. Then it's troublesome to deal with. Because there's a good chance that your motherboard is broken.

If you want to fix it. The cost may be higher. Because there are other components on the motherboard. Those repairs might as well buy a new notebook.

If the machine itself is not waterproof, the keyboard is really nerve-wracking.

If you accidentally spill water on the keyboard, don't panic to remove the battery first, then remove the keyboard, and if possible, there is a blower to blow the water on the skin. Wait until it is completely dry and put it on and use it.

Soak in water and try it out.

It is best to dry it for a while before using it.

Oh, what brand of books? Can you tell us about it?

It should be that the water is dry, good luck! But be careful next time!

Sweat! Big brother, you are really talented, you have entered the water, and you dare to turn on the machine without disassembling it to clean up the water.

Find a place to repair the empty computer, and the new film is burned!

This phenomenon has the following possibilities: to confirm what is the water quality renting a trip to the inflow, after the water quality inflow, you turn on the dead town to search for water completely infiltrated into the book, and the water quality flows into the main board of the book, resulting in the line key to know the way, so that it can not be turned on.

At first the water did not flow inside, but later it flowed in. You go to the repair place and find someone to take a look.

Don't turn it on! It is possible to scrap and send it for repair!

It's just a mouse, don't be too nervous, it's broken, just change it, Sony is not a professional mouse. Razer, Microsoft and Logitech are all better than him.

Try it for two days, maybe it will be better in a few days.

It is estimated that it will not be broken, and it will be bright and bright when it is taken apart.

Blow it on with a hair dryer.

It should be fine when it dries.

Take it apart and take it outside to the sun for a basking touch.

If you can't use it when you come back, replace it, I can't tell if it's broken.

It is recommended that you use a hair dryer to blow it, but if it still can't be used, change it!

When sprinkled with water. It should be unplugged first. Because there is electricity. I hope it didn't burn out because of a short circuit. If it's useless after drying. It's useless.

Disassemble it to dry, and if it doesn't work, sprinkle it again and throw it away.

All computer peripherals are afraid of water, even the keyboard is afraid of water, not to mention the mouseAs long as the photoelectric rat enters the water, 80% is scrapped, if it is not a genuine brand of "Microsoft" and so on, it is recommended to buy a new one.

Maybe the water has burned the original inside, if the keyboard accidentally gets into the water, first turn off the computer first, and then use a blow dryer to dry the notebook keyboard, and then turn on the computer after a day

It is not enough to use paper to suction, the paper can generally only be sucked to the surface, and the components that leak under the keyboard cannot be absorbed

Keep the notebook out of a ventilated place to dry. Wait until it is completely dry before trying to turn it on. If it still can't be opened. Congratulations, it may be that some parts inside the computer are burned and you have to go for repairs. Generally speaking, after the laptop is completely dried, it will start up normally.