Thank you in advance

Updated on Financial 2024-06-08
6 answers
  1. Anonymous users2024-02-11

    To press f1 to start: There are several reasons:

    1. The CMOS parameter settings are incorrect

    Floppy drive: If the floppy drive is not detected, please check whether the data cable is connected, and then see if the settings in the BIOS are correct: check the settings of the boot sequence; In addition, if there is no floppy drive, it is directly shielded.

    Keyboard: Some CMOS settings in the keyboard problem will also appear press F1 to boot the situation, the landlord to check it himself.

    Memory: Disable Memory Verification.

    2. Prompt for low BIOS battery - replace the battery.

    3. Jumper setting problem - refer to the manual setting.

    press f1 to resume

    In addition, it may be a non-fatal hardware error that can be replaced with a check.

  2. Anonymous users2024-02-10

    A few suggestions: I hope it helps!

    1. Reboot into the BIOS settings, then close the floppy drive port in the BIOS, and save and exit the F10.

    2. If your machine has a floppy drive, after entering the BIOS, press F10 directly to save and exit.

    3. There is also a possibility that your motherboard battery is out of power and does not save the settings in the BIOS, so it is recommended that you change the motherboard battery.

  3. Anonymous users2024-02-09

    The motherboard battery is dead, and the settings in the BIOS are not saved.

    Just set up the BIOS again.

  4. Anonymous users2024-02-08

    I've also encountered your situation, and it was also caused by an abnormal shutdown. I can't tell you here, why don't you add my number? I know 289455061

  5. Anonymous users2024-02-07

    I guess there's something going on inside the CMOS.

    I can post English and not.

  6. Anonymous users2024-02-06

    First, I see that the bounty score of other people's questions can be any number, why should I set the bounty to be a full 50 points? How can I set any number of Spikes?

    Answer: If it is determined that it is a bounty point, it is a whole five or a whole ten, and 1234 is a bug; If it is the wealth value or points of the personal center, there are many situations where it will not be a full five or ten.

    Second, let's say I offer a reward of 10 points, but I give 5 points, where do the remaining 5 points go? What else can I do with the rest of the points?

    I don't know the specific setting of the score, so I don't set the score for the time being, who will help guide me, and I'll add the score, thank you

    A: All the points you offer will be given automatically, and the questioner cannot assign them. Moreover, in addition to the reward points of the questioner, the system will also receive a reward of 20.

    Question addendum: Also, if I click on the "helps me", it will show that one point has been added, and that one point will be deducted from me?

    Answer: That is not a score, that is called a good review, it is just a clear affirmation of the person, and it will not increase the score of the person who will not increase it, nor will it deduct the score of the scorer.

Related questions
31 answers2024-06-08

Pond management. 1) The bottom of the pond is cleaned, after the end of breeding every year, the pond water should be drained in time, the bottom of the pond should be ploughed, too much silt should be removed, and the pathogenic bacteria should be effectively killed through sun exposure and freezing, and the permeability of the sediment should be enhanced, and the decomposition and mineralization of harmful substances in the sediment should be promoted, so as to create good conditions for improving the water quality of the pond. >>>More

15 answers2024-06-08

This happens a lot as well, just plug in the socket on the switch a few more times! >>>More

6 answers2024-06-08

Ways to increase your wealth:

The fastest - the answer is answered. >>>More

3 answers2024-06-08

When x=3 and x=3, the ordinates of the corresponding points on this parabola are equal. >>>More

36 answers2024-06-08

Oops, I use the clip directly, that is, open the eyes, put the clip on the lens to the eyeball, wait for it to stick to the eyeball, and then close the eye, stabilize the eye left and right, and let the lens fit on the line, pay attention to distinguish the front and back of the clam,