How to fix a crack and leakage in the toilet tank made of PVC

Repair method: JCDecaux Water Leak No. 1 is pasted from the inside of the water tank as a whole to do rigid waterproofing, and then brush the flexible waterproof after finishing.

Neutral silicone glue is pasted throughout the inside of the tank.

Black & Decker strong repair cement is pasted over the cracks and around them. - It's too expensive, it's better to get a new tank for a full paste.

Glass glue repair is also OK, you see so many fish tank leaks are repaired with glass glue.

Patch the water tank Note:

To repair the water tank, you need to completely drain the water in the water tank, then cool it thoroughly and then repair it. In short, tinkering is not a long-term solution!

Extension: What kind of toilet tank is durable and not leaky.

Nowadays, most of the plastic tank tanks are used. The inner liner of this kind of water tank is a plastic water tank, and the shell is the same material as the toilet, which is ceramic, which is beautiful and beautiful; It's just that the average toilet tank is a little more expensive.

There is also a split toilet water tank that uses an all-plastic water tank, which is also very durable, and the installation and maintenance methods are as simple and convenient as the water tank of the squatting toilet, which is cheap and durable.

There are three situations where there will be a small amount of water leakage, 1. The rubber ball valve is broken, the seal is not tight, and there is water leakage, as long as it is replaced.

2. The rubber gasket of the drain port under the ball valve is aging and the sealing is not tight, so it needs to be replaced.

3. The connection between the spherical float of the water tank and the water inlet switch is loose, the float is in place and the switch is not closed, resulting in the water inlet does not stop, and the water flows out from the upright discharge pipe after the water is full, as long as the connection between the float and the water valve switch is tightened.

Hope it helps!

1. a sealing ring.

If the toilet leaks due to failure, you need to remove the toilet, replace it with a new sealing ring, and install and fix the toilet according to the design requirements.

2. If the toilet leakage caused by the misalignment of the sewage caliber, you need to remove the toilet, align the ground with the sewage caliber of the toilet, adjust the position of the toilet, seal the pipe interface, and install the toilet as required. The bottom of the toilet bowl is smeared with glass glue.

After that, wait two to three days before using it.

It is very common for the toilet tank to crack and leak. If it is not solved in time, it will affect our normal life. So, how do we deal with it? Here are some solutions.

The first solution: emergency repairs.

If the toilet tank cracks and leaks, we need to find a way to make emergency repairs as soon as possible. Cracks can be sealed with tape or glue. Wipe the water tank dry with a dry towel first, then seal the leak with tape or glue, and wait until it is dry before putting in the water.

This approach is not a long-term solution, but it can solve the problem at hand.

The second workaround: replace the water tank.

If the water tank leakage is more serious, the problem needs to be solved completely, and we need to replace the water tank. At this time, we need to remove all the accessories on the water tank first, such as the flush button, water valve, water inlet pipe, etc. Then remove the tank with a wrench or wrench, and place the new tank in its original position and install it.

Finally, install all the accessories back on.

The third solution: ask a professional to repair it.

If we don't have the technology and don't know how to deal with it, then the best thing to do is to hire professional staff. We can call the after-sales service** and let the relevant personnel carry out the door-to-door repair.

In short, the problem of leakage caused by the cracked slag of the toilet tank must be dealt with as soon as possible. Regardless of the solution, it is important to carefully inspect every leak to ensure that the problem is completely resolved. At the same time, in ordinary life, if you find that the toilet tank is abnormal, you must deal with it in time to avoid the worst.

The toilet bowl in the bathroom should be used to pay attention to it, the correct use of a lot, people after a period of use, may find that the toilet tank cracks, so it will affect the normal food and life of the family, it is recommended to repair it in time, so how to repair the crack of the toilet tank? The toilet bowl in the bathroom should be used to pay attention to it, the correct use of a lot, people after a period of use, may find that the toilet tank cracks, so it will affect the normal food and life of the family, it is recommended to repair it in time, so how to repair the crack of the toilet tank? What are the causes and solutions of toilet tank leakage?

Let's take a closer look.

How to repair a crack in the toilet tank?

1. First of all, we must find the reason for the leakage of the toilet tank, if you encounter the flush toilet when the water tank has been flowing, check the time to see if the toilet flush button has an instant rebound, if the toilet flushing switch does not rebound immediately, then, the toilet tank will always be in a flushing state. At this time, you only need to press the flush button of the toilet a few more times and wait until it springs back.

2. If the water leakage is caused by the failure of the outlet of the toilet tank, then it is generally caused by foreign body blockage and rubber plug damage, and only the foreign body needs to be removed or the rubber plug can be replaced.

3. If it is caused by the poor quality of the water tank, then the toilet tank needs to be disassembled and checked one by one to see if it is a problem with the parts of the toilet tank. If you can repair it, you can repair it, and if you can't repair it, you can change it.

Causes and solutions of toilet tank leakage

There are many reasons for a leaky toilet, and the corresponding solutions for different leakage causes are different. I'll tell you more about what follows.

1. The material of the toilet tank is inferior, and the selection of inferior materials causes the water inlet valve, drain valve and water inlet pipe itself to crack during injection molding, resulting in sealing failure. Eventually, the water in the tank will flow into the toilet through the drain valve overflow pipe, causing a water leak.

The solution to this reason is: change the best product to completely solve the problem. It is recommended to choose a product that meets the criteria.

2. Improper toilet design will also cause water leakage. For example, when the water tank is discharged, the float and the float rod will affect the normal reset of the flap, or the float rod is too long, the float is too large, and so on.

The solution to this reason is: when designing the water tank accessories, it is necessary to fully consider the free operation of each mechanism after its installation, and do not interfere with each other.

3. If the sealing valve cover of the drain valve is not tightly matched with the sealing surface of the valve body, it will also cause water leakage.

The solution to this reason is: to choose the appropriate and high-quality drain valve valve cover material, and to protect it during packaging and transportation, pay attention to avoid deformation.

The above is about "How to repair a crack in the toilet tank?" Toilet tank leakage causes and solutions" related knowledge, if the toilet tank leakage situation to be solved in a timely manner, for the cause to deal with, if the quality of the toilet is poor, to replace the best products in time, in order to solve the problem.

Summary. How to fix a crack and leak in the toilet tank:

Cracks in the toilet tank can be repaired with anti-theft glue, drain the water in the tank first, then wipe the cracks, and use an electric hot air to blow them to ensure that the cracks are dry. Then squeeze the needle tube along the gap, the gap is small to press the needle tube to inject, increase the amount of glue, and avoid only repairing to the surface. Finally, fill it well, and use it after one day of drying, and do not get wet or soaked in water halfway.

Will the toilet tank leak if it cracks?

Hello, I'm sorry for your problem, the toilet tank is cracked and leaking.

How to repair the cracks and leaks in the toilet tank: The cracks in the toilet tank can be repaired with anti-theft glue, drain the water in the tank first, then wipe the cracks clean, and use an electric hot air to ensure that the cracks are dry. Then squeeze the needle tube along the gap, the gap is small to press the needle tube to inject, increase the amount of glue, and avoid only repairing to the surface.

Finally, fill it well, and use it after one day of drying, and do not get wet or soaked in water halfway.

I hope mine can help you