What is the way to remedy the empty corner of the floor tile in the living room? What s the easiest

The method of remedy for the corner of the living room floor tiles: in the case of interior decoration, the construction team is shoddy or the bulge caused by insufficient level. For example, in the case of wall tiles, the floor tiles are not soaked in water or soaked in water is insufficient, the cement slurry is not full, the construction team batches putty is not technically standardized, and the mortar ratio is not scientific.

Wall hollowing caused by wall reasons. It's not that the more flat the walls, the better the tiles will be. Smooth walls are not easy to adapt to the floor tiles, so that the wall tiles and the wall surface can be more solid, and the walls of many rough rooms will continue to be brushed.

When the relative humidity in the air is relatively large, or the temperature is too low, it will affect the catering of floor tiles, so it is not recommended to paste wall tiles in the rainy season or in the process of bottom temperature to prevent the wall from being hollow. If the edge of the wall tile is hollow, we can directly use dilute mixed mortar to inject grout, while pouring while knocking on the floor tiles, so that the plastic penetrates thoroughly, and part of the hollow drum of the wall tiles will digest and absorb the cement mortar by itself, until it is full and waits for it to condense.

If there is a hollowing in the middle of the floor tiles, we can pry the bricks and resurface them. Use a strong suction cup to pick up the floor tiles, then suck them out vertically and start laying them again. When more than one-third of the wall tiles are hollowed, or the wall is hollow in the middle of the above floor tiles but cannot be sucked out with a strong suction cup, it is necessary to consider asking a professional to smash all the floor tiles again and complete the re-laying.

The wall hollow drum needs to see whether it is a partial wall hollow drum or a large-scale wall hollow drum, and a hollow wall tile or floor tile hollow drum. If part of the wall is hollow, it can be reinforced with a saw blade structure at the corner. If it is a large-scale wall hollowing, I may propose to dismantle and reinstall, which is also more dangerous.

Remember that this time you must use tile binder, the pavement can be roving, and the walls must be paved with fine sand mixed with concrete tile binder. Naturally, it is best to find a master with better craftsmanship, and it doesn't hurt to be more expensive.

You can inject glue, or directly re-decorate, you can choose some cement mortar for grouting treatment, which is relatively simple and cost-effective.

When laying floor tiles in the living room, if there is a gap in the corner, the original floor tiles should be trimmed and the space should be replenished as much as possible, which is the easiest way.

1. The corners of the floor tiles are partially hollow, and the filler of the surrounding joints of the floor tile hollow drum can be removed, and the cement mortar is poured in, and the hollow drum of the floor tiles is gently knocked to let the cement slurry penetrate and repair the hollow drum.

2. If a single floor tile is hollow, you can remove the filler around the floor tile, take out the floor tile with a suction cup, cut off the paste layer, and paste it again.

3. If the floor tiles are hollow in a large area, they can only be re-paved.

4. Brick hollowing is a serious quality problem, which will cause the floor tiles to crack and fall off, and it is easy to break when bearing. Therefore, the floor tiles can not have hollowing, and special attention should be paid to the acceptance. To check whether the floor tiles are hollow, the method is actually very simple.

The professional detection method is to gently tap the ground with the detection hammer or gently sweep along the surface of the ground, if there is not a crisp "dangdang" sound, but a hollow "dong dong" sound, it can be judged to be a hollow drum. If you don't have a professional detection tool, you can also find a metal object, knock on the ground one by one, and find out the hollow floor tiles according to the different sounds.

The floor tiles are easy to be empty for some reasons, what to do with the empty corners of the floor tiles in the living room? Today, I will answer them one by one for you.

The main reason for the empty situation of wall tiles is that the cement material is used too little during the decoration, and the tiles often fall off in this case.

You can use plain cement slurry to fill and stare at the noise, generally the tile paste is reserved about 1mm expansion joint, use a thin iron sheet to remove the joint material, and then mix some dilute cement slurry, from the gap to fill the edge of the drum with a suitable tool to beat the corners of the hollow drum, in order to fill solid. If it doesn't work once, it can be repeated several times. This is a common remedy, it works well, it is economical, and you can try it.