Can I fix the bad contact of the ASUS notebook interface?

It can be repaired, and there are several reasons for poor interface contact:

1. If there is a problem with the socket, check the contact quality of the socket.

2. The socket on the computer is unplugged and unplugged for a long time, resulting in ignition failure.

3. The water ingress of the interface fails, and the contact is poor.

4. The data cable is damaged, and the model or the same parameter should be replaced.

5. There is a fault at the interface of the motherboard.

Send it to the after-sales center for testing and processing, and do not disassemble and repair it yourself.

If you have good hands-on ability, you can disassemble it yourself, dial back the shrapnel in the power connector in the notebook, and make a small hole from the side of the shrapnel.

No, it is better to send the repair shop to change the interface, the cost is 2 yuan, and the best way is, of course, to find after-sales service, no risk.

ASUS notebook poor contact can be repaired, do not use alcohol cotton balls to power off, put the interface in the future and try it, there is too much dust inside, poor contact, be sure to power off, wipe the water, you try it, it may be fine.

About this ASUS notebook interface,If I can't accept it,Of course you can repair it.,Just change the interface.,It's not very expensive to change an excuse.,It's still quite cheap.。

It may be that the plug on the motherboard is desoldered, find a repair shop to solder it or replace it with a new interface Bring the computer and power adapter and warranty card to the local service center for testing and processing Replace the charging equipment of the same model by yourself or by the official, it is best to choose the original product.

It can be repaired, and if the contact is not good, you can go to the laptop store for repair, or after-sales.

Generally, the following five good luck points will cause interface problems in the notebook:

Beijing Notebook Nursing Loss Repair Center 400-669-99651, the socket on the computer has been unplugged and unplugged for a long time, resulting in the failure of the ignition.

2. If there is a problem with the socket, check the contact quality of the socket.

3. The core beam of the water inlet of the interface fails, and the contact is poor.

4. The data cable is damaged, and the model or the same parameter should be replaced.

5. There is a fault at the interface of the motherboard.

If you can't solve it yourself, it is recommended to send it for repair in time, so as not to miss the first period of maintenance!

You can go to the after-sales service to replace the interface.

Generally, the following five points will cause interface problems in the notebook core beam:

1. The socket on the computer has been unplugged and unplugged for a long time, resulting in ignition failure.

2. If there is a problem with the socket, check the contact quality of the socket.

3. The water ingress of the interface fails, and the contact is poor.

4. If the data cable is damaged, the model or socks should be replaced with the same parameters.

5. There is a fault at the interface of the motherboard.

If you can't solve the problem by yourself, it is recommended to send it for repair in time, so as not to miss the first period of maintenance!

There are several reasons for poor interface contact and solutions:

1. If there is a problem with the socket, check the contact quality of the socket.

2. The socket on the computer is unplugged and unplugged for a long time, resulting in ignition failure.

3. The water ingress of the interface fails, and the contact is poor.

4. The data cable is damaged, and the model or the same parameter should be replaced.

5. There is a fault at the interface of the motherboard.

Send it to the after-sales center for testing and processing, and do not disassemble and repair it yourself.