Is it OK to use patch plaster for damp and moldy walls in university dormitories?

If the wall of the university dormitory is damp and moldy, it can be treated with repair paste, but when using it, the wall must be wiped clean and dried before it can be effective.

First of all, the problem of dampness should be solved, and after the problem of dampness is solved, you can use tonifying cream. If you don't solve the problem of moisture, it will still fall off after use.

Yes, but it is best to use the following method, when the wall is damp, you can apply anti-mildew agent or paint isolation sealant to isolate water vapor, if the putty layer will absorb water, you can directly apply waterproof spray to achieve the effect of waterproofing.

The wall is damp, you can't simply use patching paste, this is useless, you can paint the wall with waterproof paint, and then paste the wallpaper.

It is necessary to make up for the leakage on the roof in time, after all, mold is mostly caused by moisture.

If it is moldy, you can spray it a few times with a mold remover, and if there are still some that can't be removed, then brush it.

Then it's mildew-proof, just spray a few times with anti-mildew spray.

The walls of the dormitory are damp and moldy, and it is also possible to use compensatory rest for Gao Weiwei, which should be seen from the outside, so it will not feel moldy.

Yes, friends, it is recommended that you use a tonic cream.

I heard that some repair pastes are also very waterproof, so if it is true, you can consider using repair paste to give it a try.

If the walls of your college dormitory are moldy, you should contact your counselor or the school's logistics department and ask them to deal with it.

How to deal with moldy walls?

First, if the wall is moldy, if you don't repaint it, you can only minimize the mold, gently polish it with sandpaper, and then wipe it clean with a rag, which should be okay.

Second, remove the moldy wall, first brush a layer of 108 glue, and then scrape putty and latex paint.

The walls in the house are often damp and moldy: because the moisture from both the outside and the interior is in the walls, the water content will become black spots and mold. When it rains, the rain enters the wall, and in summer, the sun is scorching and the temperature is high, and the heat sucks the water vapor into the wall, but it can't be discharged, and then on a rainy day, the water from the outside enters the wall again.

Over and over again, many walls will become black spots and mold.

3. Clean the mildew with household bleach, then rinse the entire wall, and reapply the paint after it is completely dry. You can also consider installing an exhaust fan to improve the effect of air synchronization. When re-applying the paint, if you are not at ease, or there is no exhaust fan, but it is a mildew problem again, you can buy a primer with a backing effect on the market to paint, and then paint the topcoat, but it is recommended to use a good paint and its supporting primer, so that the effect is good.

It's vitiligo, it's very unvable