-
Anonymous users2024-02-11The wiring method of the rectifier power supply ZS-2, first of all, you have to know what one of its positive and negative poles is, or the positive and negative poles of it, and then use it in this order, and then you can wire it according to their uh linear energy positive and negative electrodes.
-
Anonymous users2024-02-10The tumor power supply is connected to the power supply in 20-2, and the wiring method is to connect the power supply to the power supply, and the power supply is in contact with Fujing on the output side, and this rectifier power supply is a live wire and a neutral line.
-
Anonymous users2024-02-09Rectifier bridge wiring method and wiring diagram The rectifier bridge connection method is mainly understood in two situations, one is the correspondence between the physical product and the circuit diagram. As shown in the figure above, the left side is the internal structure diagram of the bridge rectifier circuit, and B3 is the output of the rectifier positive.
-
Anonymous users2024-02-08Uh, the rectifier power supply can indeed be connected in this way, and the method of this kind of money can only be passed by the method of logging in its wiring, so his rectifier power supply is very easy to do.
-
Anonymous users2024-02-07The easiest way to wire it is to put it on the power cord and then connect it and you're done.
-
Anonymous users2024-02-06Add resistance to the circuit diagram through which the voltage passes, and there will be a connection of the current transformer, which will be turned on and maintained normally.
-
Anonymous users2024-02-05How do you wiring it? Do you see how this wiring method has changed? You still have to wire it according to your own needs.
-
Anonymous users2024-02-04In this way, you can send you this screw, and then write it down again, and the bottom line will be successful, and his words are very simple.
-
Anonymous users2024-02-03Generally speaking, I think that the wiring method of the rectifier power supply can be divided into three steps, right?
-
Anonymous users2024-02-02There are many ways to approach the rectifier power JSJ2, which one do you like to use?
-
Anonymous users2024-02-01**No, when you are very professional, you can also pay attention to safety, otherwise it is easy to get up and go out 15 homework is not cured.
-
Anonymous users2024-01-31There is a power wiring method or a relatively simple or professional mode.
-
Anonymous users2024-01-30The method of rectifying the clerk in the second phase of the line is the same as that of the original whole six or seven, generally blue with green, red with yellow.
You can't think of electrons as too materialistic, they just don't accumulate there, and inversion isn't simply the result of electrons running in the opposite direction. However, it is generally compared to water and water pipes, when the mouth of the pipe is blocked, the water cannot flow, but it does not accumulate at the cut-off. The water pipe and the shut-off valve do not leak because it can withstand this water pressure, just like the pressure of the diode, otherwise it will burst. >>>More
1.The use of LED lamps must be equipped with constant current source power supply, which is selected according to the power voltage of the lamp. >>>More
Are you asking about single-phase bridge rectifier circuit or three-phase bridge rectifier circuit? >>>More
It definitely needs to be replaced.
The power supply of the notebook is called the power adapter, it is not only a power cord, the main thing is the adapter, it is like a transformer, without it, it will be very damaging to the notebook. >>>More
This question is answered in detail in P110 of the book "Fundamentals of Modern Power Electronics Technology" by Zhang Li, a higher education press, and the waveform is very complex because it is three-phase, not DC. >>>More