How to solve a clogged flushing toilet, what to do if the toilet is clogged and can t be flushed

1. Check whether the toilet is aging After using the toilet, if there is no water or the water pressure is not enough when flushing, the dirt in the toilet will not be flushed away. Slowly, the dirt inside the toilet will block the place where the toilet turns and cause the toilet to clog. If it is determined that the reason for the aging of the toilet is causing the blockage, then there is no need to repair it, and it is better to replace it with a new one!

2. Toilet suction to dredge the toilet blockage, go to the store to buy a toilet suction, put the rubber end against the toilet mouth, and then press down hard, and then lift it up and press it again, so that you can try back and forth a few more times, and the toilet will be dredged under normal circumstances. 3. Use a wire hanger to dredge a wire hanger, bend the hanger, and then put it into the toilet pipe, and then use the hanger to dredge the blocked pipes in the toilet bowl in various ways such as pushing and pulling, twisting, etc. 4. Use vinegar and baking soda to dredge the baking soda and vinegar into the toilet, when pouring the vinegar will make a hissing sound, when the foam bubbles in the toilet bowl stop adding vinegar, pour in 4 liters of hot water to help dissolve baking soda and vinegar, which is also an effective way to dredge the toilet.

5. Use caustic soda to dredge and buy some caustic soda (sodium hydroxide) inside, melt caustic soda with boiling water, pour it into the toilet, and wait for ten minutes for the toilet to be unblocked. However, caustic soda is strongly alkaline and extremely corrosive, so care must be taken when using it. 6. Use pipeline dredging agent to dredge Buy pipeline dredging agent in the store and pour one-third of the dredging agent every 3 minutes.

After pouring it all, wait for the dredging agent to stay for 5 minutes, pour in hot water, and leave it for about 10 minutes to wash with clean water, which can also effectively dredge the toilet. 7. If the above methods are useless, then you need to ask professional dredging personnel to come to the door for dredging, although there will be a certain cost, but this is the most time-saving and labor-saving, and the effect is also the fastest, which can quickly solve the problem of toilet blockage.

How to solve a clogged flushing toilet: If the flush toilet is clogged, the first thing to understand is what causes the toilet to be clogged. Generally, items such as toilet paper and sanitary napkins are easy to cause toilet blockage, for this case, you can first pour boiling water into the pipe, soften the blockage in the waterway pipeline, and wait for the blockage to soften and disperse, and then slowly discharge the sewage.

It can also be solved with the help of a pipe dredging machine or a dredging tool. If it is because you are not careful to make the hair fall out of the toilet cause the drain to clog. At this time, you can use the wire to dredge, make the wire into a hook, and keep shaking it up and down the sewer to make the hair strand around the wire, and then slowly smooth the wire out, and repeat the operation a few more times.

It can also be unclogged by using a hand-cranked unclog.

1. What should I do if the toilet is blocked, and the water can't be flushed?

1.Find a thin wire, twist one end into a hook, and reach into the toilet bowl to spin. You will feel the hook tangled, creating some resistance. When you don't feel anything wrapped around the hook, pull out the wire and repeat until the blockage inside is cleared.

2.Align the toilet plunger with the toilet bowl opening and press slowly and firmly until the toilet hole is completely covered. The toilet plunger must be completely submerged in water to be new, and then continue to push harder.

When you hear the sound of bubbles, you can pull up the toilet plunger to unclog it. If it doesn't work once, you can try it a few more times.

3.The plastic wrap completely covers the toilet bowl, sticking to the edge of the toilet bowl and does not leak. Press the flush button after sticking, wait for the plastic wrap to slowly expand to a certain height, and then gently press down with your hands until the plastic wrap is flush with the toilet.

Remove the crisper bag at the end, and you'll notice that the clogged toilet becomes unobstructed.

Second, what should I do if the toilet is blocked and the water is slow?

1.Pour some plumbing unclogging agent into the toilet bowl and use some unclogging tools to quickly fix the clogged toilet.

2.Prepare a small glass of soda and the other half of white vinegar and pour it down the toilet. When there are no bubbles at all, pour boiling water into it and you can dredge it.

3.Pour an appropriate amount of dish soap and boiling water into the toilet, and then use a leather slap to break up the clogged grease in the toilet. Wait a while, press the flush switch, and the clogged toilet will naturally be unblocked.

Hello, you have to use something that can be as thick as possible, completely crowd the toilet eye, otherwise you can't without enough pressure, there are several ways:

1. The oldest kind of cloth-strip mop, after being dipped in water, can be poked a few times in the eyes of the toilet, which can have an effect.

2. You can use a small basin or something similar, buckle it upside down, press it hard, and you need to wear gloves 3. Find something like wire to dredge.

Hope it works for you, hope

Go to the supermarket to buy a very cheap one, both of the picture can be, you can also have a pump at home, block it with a cloth to pump it in.

The toilet is clogged and can't be flushed, teach you a trick, dredge it quickly, and don't cost a penny.

A toilet plug or toilet plug is the most common tool that comes to mind, and it is also the work that many people will prepare at home. This tool is indeed the first choice, as it can be done 90% of the time.

If you can't unclog the toilet with a wrench, you can go to the kitchen and get some dish soap and squeeze some of it out into the toilet. Wait about 5 to 10 minutes so they have time to move from the sewer to the blockage.

If the toilet is not only clogged, but also full of water, another option can be used. Start by emptying the water inside, but keep some of it. Subsequently, pour a cup of baking soda and a cup of vinegar into the toilet drain.

When vinegar and baking soda are combined, the natural chemical reaction bubbles up and loosens the blockage. After about half an hour, pour some more hot water into it and see if it drains.

If you don't have a wedge at home, you can also try using a plastic water bottle to unclog it. But considering that plastic water bottles are generally not that long, you should wear a rubber glove first. First, remove as much water as you can from the flush toilet.

Fill a large plastic bottle with warm water. Place your thumb on top and place the top of the bottle into the outlet at the bottom of the toilet. Remove your thumb and hold the bottle tightly with both hands.

Squeeze the bottle and let the water drain into the toilet drain. The pressure created in this way may clear the blockage. When doing so, it is best to wear a mask and goggles to protect against splashing water.

Then pour hot water into the toilet, and if the water level drops, the blockage has been cleared.

Good morning, dear, glad to answer for you: Toilet blocked solution: 1

Mild blockage: Prepare a plastic bag to wrap your entire arm, put a toilet brush into the toilet, and pump down against the hole to unclog it. 2.

Moderate blockage: Prepare a plastic bottle, cut the cap tightly under the cap, when the toilet is blocked, put the hollow position at the bottom of the plastic bottle into the hole of the toilet, and quickly pump it up and down to help dredge the blockage. 3.

Severe blockage: Pry the sealing strip under the toilet bowl with a knife, remove the entire toilet base, lift it up to take out the blockage inside, and then reseal the toilet bowl with hot melt adhesive. I hope I can help you, if there is anything unclear you can consult further, and finally I wish you good health, a happy family, and a smooth work<>

Summary. Hello, dear. 1. The best way to dredge the toilet is to use a pipe dredging agent, pour some pipe dredging agent into the toilet, and then use some dredging tools to quickly get the toilet clogged.

Usually, this method is also the most commonly used, it can not only dredge the toilet, but also clean the toilet odor, truly killing multiple birds with one stone. 2. Hot water The first step of dish soap is to pour an appropriate amount of dish soap into the toilet, and the second step is to add boiling hot water, and then use a leather puff to decompose the grease blocked in the toilet, just like dissolving the grease in the kitchen sink. First of all, hot water is needed to activate the dish soap to accelerate the dissolving effect, wait for a while, press the flush switch, and the clogged toilet will naturally be dredged.

Hello, dear. 1. The best way to dredge the toilet is to use a pipe dredging agent, pour some pipe dredging agent into the toilet, and then use some dredging tools to quickly get the toilet clogged. Usually, this method is also the most commonly used, it can not only dredge the toilet, but also clean the toilet odor, truly killing multiple birds with one stone.

2. Hot water The first step of dish soap is to pour an appropriate amount of dish soap into the bucket of Ma Youzheng, and the second step is to add boiling hot water, and then use a leather spoon to pick it up, and the dish soap can decompose the grease blocked in the toilet, just like dissolving the grease in the kitchen sink. First of all, hot water is needed to activate the dish soap to accelerate the dissolving effect, wait for a while, press the flush switch, and the clogged toilet will naturally be dredged.

Kiss, three, plastic wrap This trick can be called the nirvana of dredging the toilet, the first step is to use the plastic wrap to guess the part of the toilet seat as a whole, the need to be careful is not to leave a little gap, to wrap tightly; The second step is to press the toilet switch, which is to observe the plastic wrap bulging; The last step is to press down, and by using the principle of air pressure, you can press down the clogged dirt in the toilet, and then the toilet will be dredged.

When the toilet is blocked, the effect of air pressure can be used to make the blockage expelled. In addition to the toilet skin stopper, the solution to the problem of toilet blockage can also be covered with plastic wrap, which is as follows:

1. Wipe the edge of the toilet bowl with a "rag" first.

2. Then wrap the upper surface of the toilet bowl tightly with "plastic wrap" to ensure that there is no air leakage.

3. After pressing the "flush" button, press and hold the plastic wrap firmly with your hand until it reaches the lowest point.

4. In this process, the pressure of the plastic wrap is converted into "air pressure", which directly acts on the blockage point, and after this high pressure, the blockage will be dredged.

Notes:

1. It should be noted that when using the toilet, do not discard sundries that should not be discarded. Even paper towels should not be thrown too much at once, but should be done in small quantities many times.

2. The reason why the toilets in many families are frequently clogged is often the lack of regular cleaning and dredging. Therefore, it is necessary to develop the habit of cleaning the toilet once in a while, which is also the easiest daily maintenance method to deal with the toilet blockage.

3. In addition to remembering to clean regularly, the toughness and thickness of toilet paper are also a key factor affecting the smooth performance of the toilet bowl.