What is baitless hooking? 5

The action of hook fishing and reeling back is generally the operator's left foot standing at the water's edge, moving back with his right foot, and turning to the right to point the rod tip to the left side of the air; The right hand holds the middle of the rod and the left hand holds the pay-off.

The wire bracket or twist of the device tightens the thread so that the wire reel no longer rotates; Then, the right hand swings the rod to the right, and the rod pulls the long line to drive the hook, and the person moves forward in the direction of standing; At this point, swing the rod slightly to the left; At the same moment, the left hand beats the winding bracket downward into a twisting reel, and wraps the remaining line on the rod into the ** coil slot. When the rod is swung to the right, the left hand stops the reel to stop the line, and the rod is dragged again, and the hook is dragged again, and it goes straight to the place where he is standing. The farther the hook is thrown, the longer the line is released, and the more times the rod is swung to reel in the line; Hooks and lines thrown out tens of meters to more than 100 meters away are quickly pulled to the shore by constantly swinging the rod left and right and reeling the line.

The above is the whole process of an operation.

Throw the hook out, people who are skilled and can play skill, can throw 50 meters at a time (this is the world record), and the general technology is not skilled enough, can only throw 20 meters to 30 meters away. The advantage of throwing far away is that it can be thrown to the center of the water body and to the nest where the fish heads are concentrated, so that you can hook more fish and hook big fish. This is because the season of hook fishing is also carried out in autumn and winter when the fish are in the mud.

If the fish does not stick to the bottom, it will not be able to hook the fish.

The key to hook fishing, the word "fast". Be "fast" in the speed at which the line is taken up. The two hands should cooperate dexterously and tacitly, throw the rod and turn the line to coil the line, to achieve the hook under the water like a sharp arrow, as long as it touches the body of the big fish, the sharp hook teeth, immediately hook the big fish.

In short, it is an anchor fish, generally played with a sea rod, and the hook is thrown out and quickly retracted to hang the fish, which is effective when the fish density is large, but this practice is not considered fishing, it should be regarded as a more cruel and immoral way of fishing.

Summary. In this method, a fishing line that is slightly shorter than a fishing rod is tied to the tip of a bamboo pole, and the other end of the line is not tied to the hook, but directly to earthworms, insects or vegetable bait. When fishing, the bait is thrown into the water, and the person squats under the grass or tree by the pond, watching the movement of the rod tip.

If there is no fish biting the bait, you can keep gently lifting the bait, once you find that the fishing line is pulled or straightened, it means that the fish is biting the bait, and the angler should immediately lift the fish ashore.

Dear, hello, thank you for your question, this side will serve you wholeheartedly, if the service is not good, please include more Oh dear, the question you asked was not answered as follows: Hello dear: What does the unbait fishing hook mean as follows:

The other end of the line is not tied to the hook, but directly to the earthworm, insect or plant-based bait. Tanner Trail.

This method of fishing involves attaching a fishing line that is slightly shorter than a fishing rod to the tip of a bamboo pole, and the other end of the line does not tie the fish to the hook, but directly ties the earthworms, insects or plant bait. When fishing, the bait is thrown into the water, and the person squats under the grass or tree by the pond, watching the movement of the rod tip. If there is no fish biting the bait, you can continue to gently lift the bait, once you find that the fishing line is pulled or straightened, it means that the fish bite dry and rush to pick up the bait, at this time the angler should immediately lift the fish ashore.

This fishing method is more common in China's Yunnan, Guizhou and other ethnic minority areas, and the fishing line used is fine hemp rope. In the rural areas of Jiangsu, Zhejiang and Anhui, there are also those who use this method for fishing. They often fish in rivers, ponds, lakes, etc., but the difference is that the end of the fishing line is tied to the fowl, small frogs and large green black earthworms.

Anglers put their bait in the gaps of aquatic plants or aquatic plants or in the stone caves by the river, and constantly pick up and put them gently, and the lead can often catch blackfish, seven-star fish, mandarin fish, etc. Once these fish bite the bait, they won't let go of their mouths for a while. Once the rod holder feels heavy, he can forcefully lift the fish ashore to kiss him.

The drift with bait is divided into double bait and single bait with teasing, among which the advantage of double bait is that the weight of double bait is considered, and you can fish float or bottom fishing. Hookless drifting is the best way to use light bait, especially insect bait, which can be used to hang insect bait with double hooks to the end, which is very suitable for bottom fishing crucian carp.

Empty hooks. The empty hook is the most basic of the fluting and scattering. The method is to determine the mesh, hang the double-limb bait to weigh the bait, see how many meshes are left in the middle of the water after hanging the double bait, and determine how many meshes are fished when fishing the bottom according to this mesh.

Depending on the number of meshes, change the condition of the double bait at the bottom of the water. The empty hook drift is basically suitable for any fish situation, but the disadvantage is that if the bait weight is not mastered enough, the drift can not be accurate, and even the situation that you have to fish how many mesh to catch the bottom is, but it is basically enough for wild fishing. (The most agile fishing mesh = tuning mesh - double bait weight).

The air hook drift method is to hail this half-water air hook, first to determine the mesh, and then hang the double bait, the weight of the source Xun bait, to see how many meshes are left after hanging the double land stool bait in the semi-water state.

No hook adjustment method, basically do not use, the current commonly used table fishing drifting method is, half water air hook drifting method and half water bait drifting method. The hookless standard adjustment method is only suitable for bottom fishing, and the adaptability is too poor in the actual fishing process, and the effect is not very ideal; The half-water air hook drifting method and the half-water bait drifting method can not only fish the bottom but also fish the float and play the stroke, so it is the most commonly used two methods. Among them, the half-water air hook drifting method is suitable for drifting where there are small trash fish hooks, and on the other hand, the half-water bait drifting method is suitable for drifting where there are no small trash fish hooks.

1. When you arrive at the fishing spot, open the bait according to the type of fish you are targeting.

2. Select the buoy for the target fish.

3. Increase the weight of the lead skin, first use the lead sinker to find the bottom, find the solid bottom, pull down the buoy to the length of a buoy, and gradually trim the lead skin, if your buoy is nine meshes, then first adjust a five-mesh, if the buoy is fifteen meshes, adjust an eight-mesh, that is to say, generally first adjust to the position of more than one-half of the number of buoy tails. (Of course, this refers to the situation of rubbing the bait, pulling the bait or hanging bloodworms and earthworms, and then add a note at the end, which is not explained together, otherwise it is easy to be confused).

4. Hang the bait on the hook above the double hook, the size of the bait must be basically the same as the size of the normal fishing, throw the bait into the water to see how many meshes are left of the buoy, this process is to weigh the bait, that is, to see how many meshes a bait can pull down the buoy, if the buoy is still directly under the bottom after hanging a single bait, and the number of meshes is not exposed, it means that the buoy is small, at this time, even if you cut the lead skin, the remaining buoyancy of the buoy can not bear the double bait again, the best way is only two: one is to change the big buoy, the second is to add light bran bait to the bait to reduce the proportion of the bait; My personal habit is to switch to a larger buoy.

5. The best state of drifting with bait is to expose the buoy in half of the water after the double hook with bait, and then gradually move the buoy up until the buoy exposes two or three eyes, so that you can start fishing, and then slowly move the buoy up or down according to the situation of the fish mouth and the hit rate of the fish in the rod, so that the signal can stabilize the fish as the best state.

Finally, this is for rubbing the bait for the buoy method, if it is to pull the bait or use bloodworms, earthworm fishing, the buoy should not be adjusted in this way, otherwise your bait may never reach the bottom, pull the bait or use bloodworms, earthworms and other light bait fishing, the buoy can be adjusted into flat water or a eye, fishing one eye to three eyes on it, the fishing process of the fish mouth situation and the hit rate of the fish in the rod and then slowly move up or down the buoy, in order to have a signal to stabilize the fish for the best state.

The above are some of my personal understandings of buoy fishing, and you can communicate again if you have any questions.

Actually, it's all the same, you think for yourself, fish hooks and fish food have weight.

It's usually a hook tune.

Taiwan fishing is sprinkled with hook drifting, and the hookless adjustment method is not suitable for Taiwan fishing.

Hang double hook (empty hook), trim the lead skin when ensuring that the double hook is not at the end, so that the float is exposed to the water surface 4 mesh, and then the double hook hangs the bait to try to drift, because the bait has a certain weight, so the float is not 4 mesh at this time, it may be flat water (such as the float or 4 mesh indicates that your float is too indiscriminate), and then adjust the position of the float until the float is exposed to the surface of the water 2 mesh, the hook is in the end, you can fish.

1. First of all, use three fingers to pinch the fishing line to divide the line, and hold the rod handle tightly with two fingers and palms. With the other hand, rub the bait into a long strip between your middle and index fingers, cut the bait through your thumb and cut it in half. Then put the bait on the bottom hook and rub the line, and the other bait can push the bottom hook and pull the line to rub the bait.

2. In addition, there is a fast bait rubbing method, which is more difficult in rubbing bait, and it can be practiced for at least two years or more. After casting, observe the float while taking the bait, and then according to the feeling and experience of the wide and slow shiver, roll it into a long bait of the appropriate size, and then clamp it between the middle finger and index finger to watch the drift. If you have already caught the fish, directly stab the fish, pick the fish directly with the bait with the other hand, and then guide the hand to rub the bait after the fish is finished, and start to cast the rod when rubbing the bait.

Hello. In fact, you can rub the bait into a small ball, and then divide the bait into several strips, so that it is easier to hang the hook by dividing the bait into several strips. It should be noted that part of the bait is in the fingers, and the other part is on the nail cover, and then the bait in the fingers is rubbed on the hook, and then the bait on the nail cover is rubbed on the other hook.

For the method and shape of rubbing bait, many professionals mainly divide the shape of rubbing bait into spherical, drop-shaped, pyramidal, long ovate, flat ovate, etc. However, the most common of us are spherical and pear-shaped, after all, the spherical shape is suitable for fishing for carp, grass carp, crucian carp, etc., while the pear-shaped shape is suitable for fishing bream, white stripe, etc.

As for the definition of rubbing bait, rubbing bait refers to the sticky bait hung on the hook by hand, and wheat protein fiber can be added to the bait or without wheat protein fiber.

Wrap the hook: Wrap the bait whole around the hook. When the fish to be caught is relatively large and the bait is relatively large, you can use this method of blocking early. Hook tip: Hang the bait on the tip of the hook.

When the bait is relatively small, you can use this way to talk about it. When using this method, try to choose a long hook. Hook Bend: Hang the bait on the part of the hook** curve. It is also recommended to use this method when the bait is small.

1. How to make fishing bait.

1. When making rubbing bait, you need to prepare the basic bait and flavor bait, and the specific choice of which bait to match needs to be decided according to the specific preferences of the fish, and these baits can be purchased in the store.

2. After preparing the bait, you can make specific adjustments. It is necessary to mix enough water according to the specific ratio on the package. Wait a while for the water to be fully absorbed.

The amount of water added must be well controlled. If the amount of water is not enough, the bait will easily form lumps. After adding water, it is also necessary to stir well at speed.

3. To judge whether the state of the bait is good, you can see it from the feel and the residue on the hook. Rubbing the bait is easier to attract fish and is of great help to fishing.

Second, how to hook up the fishing bait.

According to different bait conditions, there are the following hooking methods can be adopted:

1. Wrapping hook: The most common way to hook the finch is to wrap the whole hook with the bait. If the bait is large enough, this method is more suitable.

Specifically, there will be differences in shapes, such as triangles, drops, and so on. For some larger fish, this hooking method is more likely to attract them.

2. Hook tip: This method refers to the hook method in which the bait is hung on the hook tip. When the bait is relatively small, it is more suitable to hook it in this way.

When fishing for smaller fish, you can use the tip of the hook. When choosing a hook, you need to pay attention to the use of long hooks as much as possible.

3. Hook bending: This method refers to hanging the bait on the bend part of the hook. This can be done when the bait is relatively small. However, you need to be careful when hanging, otherwise the bait will easily break.