The branches of the spring flowers are planted directly in the soil, will they survive?

Yes, unintentionally planted willows and willows.

I can't live, how can I live without roots.

Can the flower cuttings next to Yingchun Min live?

Spring flower cuttings can live, and its branches are very bridge-core oak and easy to grow adventitious roots, so the survival rate is relatively high. However, it should be noted that the temperature is too high in summer and too low in winter, and these two seasons are not suitable for spring flower cuttings.

Propagation time of spring flower cuttings.

Spring flowers can be cut in March if they are hard branches that are more than one year old, and in April if they are soft branches that are not fully lignified.

Propagation method of spring flower cuttings.

Cut the sturdy shoots into cuttings, dry them, insert them into a loose seedbed, water them once to keep the soil moist, and then manage them in a cool and ventilated place to promote the rooting of the cuttings. Once the cuttings have taken root and started to grow steadily, they are ready to be transplanted.

Spring flower cuttings points.

1.What kind of soil should be used for spring flower cuttings? The substrate used for spring flowers should be loose and well drained.

You can mix river sand with humus, pure sand and fine sand, and if you don't have it, you can also use ordinary flower soil. 2.Spring flower cuttings can be inserted directly into the soil.

The prepared cuttings can be inserted directly into the bed, but the substrate needs to be disinfected and moistened in advance to facilitate its rooting. 3.How long does it take for Yingchun's bright flower cuttings to take root?

If spring flowers want to take root, they must pay attention to temperature control. Only with the right temperature can it take root faster. It's best to be between 15 and 20 degrees, either too high or too low.

It can take root and sprout after one month of maintenance. 4.How to cut spring flowers to take root?

When cutting quickly, make sure that the substrate has the right humidity. If the humidity of cuttings is too low, the cuttings will not survive properly due to lack of water. If the humidity of the cuttings is too high, it is easy to cause rot and lead to the failure of the cuttings.

Therefore, the suitable humidity environment plays an important role in the survival of cuttings. If necessary, the cuttings can be covered with a layer of plastic film to moisturize. However, it is also necessary to open the plastic film frequently to exchange air, otherwise it will also affect the survival of cuttings.

Spring flowers need to be cut every year, so as not to show aging and elongation of its branches, pruning time is generally in the spring after its flowers wither, at this time to truncate its branches, so that each branch only has 2-3 bud points, which is conducive to its germination of new side branches, but also conducive to its number of flowers in the coming year.

1. It needs to be trimmed

Spring flowers need to be pruned every year, so as to avoid the aging and elongation of its branches, which is conducive to its germination of new side branches, and its flowers grow on annual branches, so it is also conducive to the number of flowers in the coming year, and the pruning time is generally after the flowers wither in spring.

2. Pruning method

Pruning branches for spring flowers, generally to cut off its branches, so that each branch only has 2-3 bud points, if there are some old and sick branches should also be cut in time, and so that its new branches grow, you can also properly prune the shape, so that its ornamental value will be higher.

3. Cuttings of branches

After pruning the branches of the spring flowers, it is possible to propagate by cuttings, select strong and disease-free semi-lignified branches, with a length of 12-15cm, cut off the leaves at the bottom of the branches, and then insert them into the substrate to keep the substrate slightly moist, and the branches can take root in about half a month.

4. Post-cutting maintenance

After pruning the spring flowers, it is necessary to do a good job of maintenance management, at this time to avoid its wound contact with water, and wait until its wound heals to do paulownia, it needs to be diligent to apply thin fertilizer, so that the key has sufficient nutrients to grow, daily maintenance, to let the soil be in a slightly moist state, high temperature weather to cool down and shade.

Cuttings can be kept alive. The spring flower, also known as the golden belt, belongs to the family Rhinoceros, a deciduous shrub. The twigs are slender and arched and drooping, with four edges, 3 leaflets compound leaves, opposite.

The flowers are solitary in the leaf axils of last year's branches, first the leaves grow and then the flowers open, with narrow leaves, the corolla is 6-petaled, golden yellow, and the flowering period is February and April. During the Spring Festival, the cold and snow, the yellow flowers are full of branches, full of vitality, and it is a veritable flower of spring. There is another plant of the same genus named Tanchun is similar to Yingchun, and the two are easy to confuse, but Tanchun first puts leaves and then flowers, and the flowering period is May, and it is a yellow apical umbrella inflorescence, which can be distinguished.

Habits】 Spring flowers like sunlight, not only cold-tolerant, but also drought-resistant, and alkali-resistant, but afraid of waterlogging. The requirements for the soil are also not very high, as long as the loam is well drained.

Propagation】 It can be propagated by cuttings, ramifications or strips. Cuttings are generally carried out in early spring 2 March, the cuttings are about 15 20 cm long, inserted into the soil 7 cm deep, watered and shaded after cutting, and the survival rate is very high. It is better to divide the plants in the spring when the buds are just germinating.

Striping is more often carried out in the spring, and the planting can be carried out in the autumn of the same year.

Cultivation management】 Spring potted plants are generally potted after autumn, and each cluster can be 3 or 4 plants. The potting soil is made of garden soil and rotted cake fertilizer. After potting, cut off the branches above the rhizome (leaving only about 10 cm of the main stem) to allow the main stem to germinate new branches.

From spring to early summer, the spring branches grow vigorously, and the management should be plucked at any time, and the long branches should be cut off in time. At the same time, it is necessary to control watering and water less, which can reduce the effect of short branches and dense flowers. There is no choice for fertilizer, and it is not a big problem to apply less and more.

If you fertilize before flowering, the flowering will be more beautiful and the flowering period will be extended. In summer, put up the branches and tie them with ropes so that they do not fall to the ground. After autumn, cut the branches of the current year short, leaving 4 6 cm long each to ensure that the flowers bloom vigorously.

Placing it indoors in winter and controlling the room temperature at about 18 0C can promote early budding and flowering in winter.

I'm afraid it's more difficult to plug in directly, right? It is still necessary to prune, it is better to cut between the nodes, and then cuttings. Spring flowers are very lively.

Select 1-year-old branches, cut them into 15cm length, and fill them with water in the finished seedbed, and then take cuttings after water infiltration. It can also be dry cutting, that is, after cuttings in the whole seedbed, irrigation is permeable. Cuttings can be done from mid-October to mid-November or in the spring.

After rooting, it can be planted, and it can also be propagated by dividing or pressing strips. Searched on the Internet.

Yes, it is easy to take root in spring.

It likes light, and it is also slightly resistant to shade. It prefers warm and humid climates, and is also resistant to cold and dry air.

The soil requirements are not strict, and it can grow on slightly acidic soil and light saline-alkali soil, but it grows best on fertile, moist and well-drained neutral soil, which is more resistant to drought and barrenness, and is not tolerant of life. Strong germination and resistance to pruning. for deciduous shrubs.

The propagation is mainly based on cuttings, and both hard branches and young branch cuttings can be used. It can also be propagated by striping or ramification. Spring flowers grow strongly, adaptability is strong, maintenance and management is relatively simple, there are occasional aphids in cultivation, and 40 dimethoate 1500 times liquid can be sprayed for control.

It is best to use it in spring and plum season, if it is in the greenhouse, it can be at any time.

Press the main trunk of the spring flower, and pull the side stem down with force, and then the side stem will be torn off a long strip of ground, and then a third of the side stem will be buried, and the torn skin will be buried together.

Note: The width of the lateral stem should be 1 cm, the total length should be 2 to 3 dm, pinch off the rest, leave 2 to 3 buds, and grow normally for two months.

Dividing is usually done in spring and autumn, but it is better to do so in early spring before the flower buds germinate. In the early stage of seedling transplantation, it is necessary to use shade nets or reed mold curtains to shade for 5 to 7 days, and the seedling rate is high.

Striping or cuttings are generally carried out in about a week after flowering. When pressing the strip, first cut the cortex of the branch buried in the soil with a knife to facilitate rooting. Cuttings can be carried out in the hotbed, or directly in the open field cuttings, choose 2-year-old strong branches as cuttings, the length of 15 cm to 20 cm is appropriate, bury 1 3 branches in the soil, keep the soil moist, 2 weeks to 3 weeks can take root, when the young roots turn from white to yellow-brown, start transplanting.

The spring flower, also known as the golden belt, belongs to the dead leaves or semi-evergreen plants scattered shrubs in the jasmine genus of the family RhinocerosIn the early spring, the flowers bloom before the cold leaves, and the brilliant eye, and Liu Ping, daffodils, and camellia are collectively called "four friends in the snow". Spring flowers have strong adaptability, good germination force and Wanrun power, easy to breed, and resistant to shearing and repair. Generally, cuttings, decorative strips, and heading methods are used to breed pre-seedlings.

Cuttings are easy to use and have a very high survival rate, so you can choose one-year-old thick branch cuttings before the bud stage from February to March, or you can choose semi-lignified (semi-hard) cuttings in rainy season.

The moisture is too wet for a long time when the branches of spring flowers are cutting, and there are no rhizomes on the cuttings. At the time of budding, the nutrients extracted from the bud point are not digested and absorbed according to the rhizome. Instead, the residual nutrients on the branches are extracted.

After budding, the branches decay without the rhizome digesting and absorbing nutrients. Eventually the buds dry and the branches wither. When the soil layer is wrong when cutting the branches of the spring flowers, why do you always pay attention to the downhill pile, or when cutting the branches, you must use the ash compacted pile.

Cuttings pass through a period of time, gradually growing roots and budding. The basal fertilizer in the soil will kill the young rhizomes that have just come out. In the absence of roots, the buds are dried and the branches wither.

Wash off the soil layer of the cuttings directly with drinking water, and all the rhizomes are exposed. Then prune the crossed roots between the plants moderately, and the rhizomes are too long. The spring will be immediately planted into a soil layer mixed with pastoral soil, humus soil, and freshwater river sand.

Mixed soil is loose, breathable, does not store water, and is slightly acidic and alkaline. It is especially suitable for spring growth and development.

After planting, it is necessary to water enough, which is called fixed root water, and then replenish the water again within about 1-2 days, to be watered, and then it can be seen that the dry and wet water is replenished, and in addition, when the temperature is high, you can spray some water on the leaves moderately to avoid large evaporation and leaf withering. After planting, the spring flowers should be reasonably shadedOr put it in a ventilated area, avoid sun exposure, and moderate reception of direct sunlight in the morning and dusk, and try to shade the sun for other hours.

Spring flower cuttings can live, its branches are easy to grow adventitious roots, so the survival rate is relatively high, but it should be noted that the temperature is too high in summer and too low in winter, and these two seasons are not suitable for spring flower cuttings. Spring flowers can be used in March if they are more than a year old for hard shoots, and in April if they are soft shoots that are not fully lignified. Cut the growing and robust branches as cuttings, dry them and insert them into the loose cuttings, water them once to maintain the moisture of the soil, and then place them in a cool and ventilated place to manage them to promote the rooting of the cuttings.

The substrate used for spring flowers needs to be loose and drainable, and can be used for river sand mixed with humus cuttings, pure sand and fine sand can also be used, if there are none, ordinary flower soil can also be used. If you want to welcome the spring peanut roots, you should pay attention to temperature control, the temperature is suitable, in order to take root faster, it is best between 15-20 degrees, too high or too low, and the maintenance can take root for about a month.

Able to survive. Its branches are easy to grow adventitious roots, and the survival rate is relatively high, so you need to pay attention to avoid summer and winter as much as possible, because these two seasons are not suitable for spring flower cuttings.