How effective is the heating effect of the Belita electric heating stove?

First of all, you have to confirm whether it is a good brand, and the other is quality assurance and after-sales maintenance services.

That's ok. Home will be home service.

Summary. Dear, hello, the installation steps of Belita electric heating furnace are as follows: 1. Before installation, check in detail whether the power cord, current, voltage, meter capacity, and use environment meet the requirements of the machine. 2. To connect the power cord, it must be connected to a special automatic leakage switch and AC contactor.

Install a reliable grounding wire. 3. The product must be installed upright, and the heating system must be equipped with an automatic exhaust device. It is strictly forbidden to debug without water and operate without water.

4. Commissioning can only be carried out after the waterway is connected. The water inlet must be equipped with a debris filter, and the water inlet filter must be cleaned regularly to remove swag. The product must not be installed too close to flammable materials and magnetic fields.

Dear, hello, the installation steps of Belita electric heating furnace are as follows: 1. Before installation, check in detail whether the power cord, current, voltage, meter capacity, and use environment meet the requirements of the machine. 2. To connect the power cord, it must be connected to a special automatic leakage switch and AC contactor. Install a reliable grounding wire.

3. The product must be installed upright, and the heating system must be equipped with an automatic exhaust device. It is strictly forbidden to debug without water and to run the group without water. 4. Commissioning can only be carried out after the waterway is connected.

The water inlet must be equipped with a debris filter, and the water inlet filter must be cleaned regularly to remove swag. The product must not be installed too close to flammable materials and magnetic fields.

Belita electric heating furnace installation steps: 1. The stove shall not be installed in the bedroom or the room together with the bedroom, all horizontal pipes shall be laid at a slope of 1:100, the stove shall be placed at the lowest place, the exhaust pipe shall be set at the highest level of the system, and the system shall not store gas.

It is strictly forbidden to install any form of valves on the main pipe, air supply box and exhaust pipe. The automatic exhaust valve should be more than 30cm higher than the water tank, and the exposed part of the room should be insulated to prevent freezing. In any case, the system must be done with an atmospheric unobstructed source.

2. Valves are installed on each group of radiator pipelines to adjust the temperature, and the shut-off valve is prohibited. A blowdown valve can be installed at the lowest point of the system. Try not to turn the chimney when installing it, and not to change the diameter at will so as not to affect the use effect.

If possible, the chimney can be insulated to prevent condensation from corroding the stove.

3. It is strictly forbidden to block or replace the explosion-proof valve and the anti-brigade explosion-proof valve. 4. When installing floor heating, or when the system circulation resistance is too large due to the pipeline being too long, the pipeline is too thin, and the flat slope is installed, the circulating pump should be used. The water pump should be installed at the water outlet, and if the pressure head is dismantled, the boiler water should be pumped to the heat dissipation system, and it is strictly forbidden to pump water into the stove, otherwise the stove will be pressurized and dangerous.