-
How to make bubble liquid yourself:Quasi-beam answer shop oak car materials: toothpaste, water, detergent.
The first step is to pour the prepared water into the glassware, as shown in the figure below
The second step is to pour some toothpaste into the poured water after raising your fingers, as shown in the figure below
Step 3: Pour in a little more detergent, as shown in the picture below
The fourth step and the final stirring can be completed, as shown in the following figure:
-
Bubble liquid self-made step method:
Whether it is an adult friend, children will especially like to play the game of blowing bubbles in the hot summer, when they are young, they always feel that the bubble rope is particularly magical, as long as they dip it, they can blow colorful bubbles, and children like to play bubble water.
1. The basic raw materials are as follows, dish soap, tap water, sugar, glycerin.
2. The ratio of tap water, dish soap and sugar is half a cup of water, one-third of a cup of dish soap and half a spoon of sugar.
3. Stir thoroughly. Make your own foam-blowing utensils with old wires.
4. The bubbles that are blown out, but there is a disadvantage that the water evaporates quickly, so it must be blown in time. To solve this problem, you can add an appropriate amount of Ganzi laughing oil, which can form a chemical bond with water, thereby slowing down the evaporation rate of water.
5. The bubbles blown out like this are big and attractive. If you want to blow out colored bubbles, you can add paint of your favorite color.
Bubble blowing water method and recipe 2
1. Pour the tea leaves into the cup, make the tea with hot water, cover the lid and soak for a while. The tea leaves are then strained out, leaving only the tea.
2. Mix bubble water, cool and bottle.
3. Blow bubbles. Prepare a straw and cut a small piece to blow bubbles. Dip the straw in bubble water and blow it safely. This bubble water is environmentally friendly and safe, and there are no other added ingredients, so adults can rest assured that children can play.
-
Laundry detergent, soap, laundry detergent, shower gel, dish soap, etc
1. Take a cup and pour boiling water.
2. Add 1-2 tablespoons of sugar to an empty cup, pour in some detergent, pour boiling water, and stir with chopsticks.
The bubble water is made, and the bubbles blown with this bubble water are large and not easy to break.
-
How to make bubble liquid:
Method 1: 1. Pour in water.
Prepare a small clean bowl and pour some water into it.
2. Pour in the sugar and mix.
Then pour some dish soap into the water, then pour in some sugar and mix well.
3. Stir well with a spoon.
Take a spoon and stir them well with the spoon until the tung orange bubbles.
Method 2: 1. Prepare a bowl.
Prepare a small bowl and pour clean water into the bowl.
2. Pour in hand sanitizer.
Then pour in some common hand sanitizer at home, and take a clean chopstick after pouring it all.
3. Stir well with chopsticks.
Use chopsticks to stir the contents of the bowl so that they can blend together.
Method 3: 1. Pour the water into the bowl.
Take a small, clean bowl and pour water into the bowl.
2. Pour in the shower gel.
Then shout and pour some ordinary shower gel at home, so that the three can be mixed together.
3. Stir with a straw.
Take a straw and stir the mixed water with the straw until dense bubbles emerge.
-
Here's how to make bubble liquid:
Materials: bottle, sugar, dish soap, straw, water.
1. First of all, take out a plastic bottle, you can do anything, and unscrew the cap.
2. Pour some warm water into the bottle, the temperature should not be too hot, a little higher.
3. Put more sugar in the bottle.
4. Put more dish soap in the bottle.
5. After the sugar and dish soap are fully integrated, tighten the cap and shake it until it is shaken out into a dense foam.
6. After the bottle stands, observe that there is no unmelted white sugar in the water at the bottom, and the bubble liquid is ready.
7. Apply some made bubble liquid on the table, and then Feng will spread the liquid evenly with his hands.
8. Use a straw to dip the bubble liquid, and the bubbles blown out are round and large and not easy to break.
The formation principle of bubble liquid and precautions for use
Bubbles are formed due to the surface tension of water. This tension is the mutual traction force that exists inside the object and is perpendicular to the contact surface of two adjacent parts when it is subjected to a tensile force. The mutual attraction between water molecules on the surface of the water is stronger than the attraction between water molecules and air.
These water molecules are like they're glued together. However, if the water molecules are over-bonded together, bubbles will not be easy to form. The soap "breaks" the surface tension of the water, reducing it to only 1 3 under normal conditions, which is the optimal tension required to blow bubbles.
Precautions for use: Do not play with bubble water in an open flame: If there is an open flame in the place where the child plays bubble water, it is easy to ignite, which will harm the child's health, and if it is in a sealed space, it will cause a fire.
Rinse immediately after playing with bubble water**. Be sure to rinse contact with plenty of water immediately after your child's exposure**.
Don't let young children play with bubble water by themselves, younger children must play with bubble water under the supervision of their parents, once the child eats bubble water by mistake when playing by himself, and the parents do not know, what will happen is unimaginable.
-
You need to prepare: a glass of water, glue, straws, slag sugar, hand sanitizer.
1. First of all, take out a glass of water and a bag of sugar, and pour the sugar into the water as shown in the figure below.
2. Next, take out a liquid glue and drop the glue into the water cup as shown in the figure below.
3. Then take out another bottle of hand sanitizer and pour the hand sanitizer into the water cup as shown in the picture below.
1.How to make styrofoam without glue:
1) Prepare the container, add salt and purified water to melt the salt. Prepare another empty container and pour in the detergent. >>>More
Homemade pickled pepper recipe one, material.
Kimchi jars. The ratio of water and salt is about 1 kilogram of water to 60-80 grams of salt. >>>More
Pour about 1 3 pieces of water into a container, then add half of the glue to the water. Add a little glycerin (optionally) and stir well. After forming, it can be drawn repeatedly, and the blistering effect is very good. >>>More
I made chocolate again, and the family double-clicked to follow a wave.
How to make chili sauce:
Raw materials: green and red peppers, green onions, ginger and garlic, sugar, salt, high liquor, star anise, cinnamon, bay leaves, Sichuan pepper, onions. >>>More