Can you use mineral water for flower awakening, can you use bottled water for flower awakening Can y

OK. For clean water, you can use unpolluted mineral water, or tap water that has been left to stand.

If you want to wake up the flowers, you need to cut the lower end of the fresh cut flower branch into a 45-degree oblique mouth, and then insert it into a vase filled with two-thirds of the water, so that the plant can absorb enough water, wait for 1 to 2 days, the fresh cut flowers can wake up successfully, at this time the plant withered and yellowed petals should be removed, so as not to lose excess nutrients.

Precautions: When hydroponic breeding of fresh cut flowers, it is necessary to remove all the residual petals and dead petals of the plant after the successful awakening of the flowers to avoid the loss of excess nutrients, and the fresh cut flowers should be moved to a ventilated environment for maintenance, so that the flowering time of the plant is extended, and the fresh cut flowers should receive scattered light to make the color of the flowers more gorgeous.

When maintaining fresh cut flowers, it is necessary to change the culture water every other week, and when changing the water, add nutrient solution or diluted phosphorus and potassium liquid fertilizer to the water to provide the nutrients needed for the growth of fresh cut flowers, and regularly spray potassium dihydrogen phosphate on the flowers of fresh cut flowers to make it more ornamental.

Waking up is a more important link, but also an essential step, many people will wake up at home. Awakening generally requires clean water, and warm water should be used, usually can be used with bottled water or purified water, both of which are relatively clean, and the awakening effect will be better.

Can you use bottled water for awakening.

OK. Before the flowers are awakened, you need to prepare a deep bucket, a blackout cloth and a clean pure water or mineral water, do not use tap water, rainwater, river water and other water quality, the bucket should be the same height as the flower branches, so as to facilitate the flower branches to absorb water.

Soak all the treated flowers in the bucket, keep the flower heads exposed outside the water surface, and can not contact the water, otherwise it is easy to turn black and rot, the soaking time is about 3-4 hours, and the specific control should be reasonably controlled according to the type of flowers, and cover with a blackout cloth during soaking to avoid sunlight.

Can you use purified water to wake up the flowers?

Purified water can be used.

The process of getting flowers from the planting base to the retail store or directly to the customer can take up to two days at the earliest, and even longer if the flowers are shipped from a wholesaler. Flowers in a long time in the transportation will be serious lack of water and lack of nutrients, and so on when receiving the flowers a little wilted and not spiritual, even some of the outermost flower mold which petals are withered, rotten, some people look at the flowers inside must not be good, in fact, this is a normal slow simple image, so after receiving the flowers must be awakened first.

Common lilies, roses, peonies and hydrangeas and other flowers need to be awakened, the flowers are seriously dehydrated and need to be soaked for more than 8 hours, and the flower buds can not touch the water, but the buds of peonies and hydrangea balls can touch the water. Later maintenance of flowers, need to change the water regularly, if added preservative, generally 1 2 days can be changed 1 time, if no preservative is added, need 1 day 1 change.

How to wake up the flowers.

1. Prepare materials: A container should be prepared when waking up the flowers, you can use buckets and other tools, to ensure that the flowers can be put in, add tap water to the bucket, pour it to two-thirds of the depth of the bucket, and then add the special nutrient solution for plants.

2. Pruning flowers: When waking up flowers, all the buds and flowers that do not grow well should be removed, and then the buds and leaves at the bottom of the stem should be cut off to avoid soaking in water for too long to make the flowers and leaves rot, and the bottom of the flower roots needs to be pruned out of a 45-degree slope.

3. Treat the branches: After pruning, the branches should be disinfected, and then the branches should be placed in a cool and ventilated place, and after the incision is dried, the branches will be put into the prepared container for soaking, and the branches generally need to be soaked for about four hours, and the flowering process can be completed.

Fourth, the later maintenance: after waking up, the flowers need to be placed in a semi-shaded environment, and the leaves are watered once or twice a day, keep for a week, the flowers can return to normal growth rate and respiration.

Awakening is a more important part of flower raising, it is necessary to soak all the flowers in water, so that the fresh and losing flowers can quickly recover their vitality and maintain the best state. You need to use clean water for all kinds of awakening flowers, and you need about 50 degrees of water, after using it once, this water can also be used for a second time, but it is best to add a little hot water to keep the temperature appropriate.

As long as the water quality is clean, you can use the empty section once and then use it a second time.

The purpose of awakening the flowers is to allow the flowers that have been dehydrated during the long distance to absorb the water again and become full and straight.

The effect of awakening the flowers is very good, because after purchase, the flowers will be dehydrated for almost 2-3 days, so they will become very soft when they go home. Therefore, after waking up at this time, the flower will slowly drink enough water and wake up. When you wake up, you need to soak in water for 4-5 hours.

If the soak is relatively short, the effect of waking up may not be very good.

The time it takes to spend waking up should not be too short. In general, it takes at least 4 to 5 hours, but no more than 10 hours. The time it takes to wake up is related to the degree of dehydration. When the flowers wake up, they can be placed in a vase for maintenance. Light exposure and the addition of nutrient solutions can prolong flowering.

When you receive the flowers, you will notice that the flowers are a bit careless. Don't worry too much. This is a normal phenomenon, especially the protective petals of the outermost layer of the rose, which are yellow and broken.

Since they are fresh-cut flowers, in order to protect the flowers from damage during transportation, the outermost petals are kept as the protective petals of the flowers, which are gently removed when they are received without affecting the beauty of the flowers.

Prune the flower branches: The flowers after waking up should be pruned again, and the lower end of the flower branches should be cut diagonally to remove dead leaves and withered and rotten outer petals.

Prepare the vase: Select the appropriate vase according to the branches. In general, choose a slender transparent vase and clean the vase in advance.

Fill with water: Prepare water and fill the vase. The water level should not be too high. You can use purified water or tap water that has been sitting for a few days.

Flower arrangement: Insert the flowers into clean water, drop a small amount of preservatives, and change the water regularly. Place the flowers in a place of astigmatism and avoid direct light.

Hello, I am happy to serve you and make the following answer for you: you can reuse flower water, but you need to pay attention to the following points:1

Keep the flower water in a cool place away from direct sunlight to avoid spoilage. Wheel 2Every once in a while, the flower water is replaced to avoid damage to the flowers caused by the spoilage substances in the flower water.

3.Clean the flowers in the flower water to avoid damage to the flowers caused by the putrefactive substances in the flower water. 4.

Clean up the spoilage in the flower water, and pat it to avoid the spoilage in the flower water from causing harm to the flowers. 5.Clean up the spoilage material from the flower water and add fresh flower water to maintain the freshness of the flower water.

6.Clean up the spoilage in the flower water and add the right amount of nutrients to meet the nutritional needs of the flowers. 7.

Clean up the spoilage in the flower water and add an appropriate amount of disinfectant to kill the germs in the flower water. The above are the steps to reuse flower water, as long as you follow the above steps, you can reuse flower water to make flowers healthier.

Waking up is a more important step and an indispensable link, and many people will wake up at home by themselves. Awakening generally requires soaking the flowers in water to restore the flowers to their best condition, and the water after awakening is generally reusable and will not have any effect.

Generally, as long as the water quality is clean, it can be reused, and there is basically no impact.

In the process of awakening the flowers, it is necessary to use hot water at a temperature of about 50 ° C and immerse the plant in water for about 4 hours, which can speed up the speed of life activities, promote the faster return of the plant to normal growth, ensure the relative balance of its own body and the normal process of transportation of water and nutrients.

When awakening a flower, the plant first needs to be pruned. Cut off 2 3 cm from the roots, at an oblique angle of 45 °, so that 3 4 leaves are close to the corolla and cut off all other leaves and lateral branches to reduce the consumption of plant nutrients. Put the treated plants into a container filled with hot water, and make sure that the water level does not exceed the leaves at the bottom of the plant, so as to prevent the leaves from rotting and necrosis after soaking for a long time, and even infect the whole plant, affecting the normal growth and development.

Soak in water for about 4 hours.

Flowers bought online should be awakened for about 4-12 hours.

The time when the flowers wake up is not absolute. It needs to be determined according to the degree of water scarcity. If the dehydration of the flower is mild, the time for the flower to wake up is generally maintained at about 4-6 hours.

If the flowers are severely dehydrated, the time it takes for the flowers to wake up can be extended to about 6-12 hours. To awaken the flowers, first prepare a large container, put clean water in the container, open the package wrapped around the flower branches, and cut diagonally at the roots of the flower branches to better absorb the water. Then put the flower branches in the water.

The flower head should not be soaked in water. After absorbing the water sufficiently, wake up the flowers and remove them.

1.Pruning the branches: The flowers should be pruned again after waking up, and the lower end of the branches should be cut obliquely to remove the dead leaves and the hollow petals of the withered and rotten outer segments.

2.Prepare the vase: Select the appropriate vase according to the branches. In general, choose a slender transparent vase and clean the vase in advance.

3.Fill with water: Prepare water and fill the vase. The water level should not be too high. You can use purified water or tap water that has been sitting for a few days.

4.Flower arrangement hydroponics: Insert the flowers into clean water, drop a small amount of preservatives, and change the water regularly. Place the flowers in a place of astigmatism and avoid direct light.

You can use tap water to wake up the flowers, but before using tap water, you need to dry it two days in advance, so that the chlorine in the water volatilizes, when you wake up the flowers, you should prepare a pot of hot water of about 50 °, and then soak the roots of the plant in hot water for 4-5 hours, which can speed up the flow of the branch slurry and promote the faster recovery and growth of the plant.

1. You can use tap water

Tap water can be used to wake up flowers, but tap water is rich in chlorine, chlorine can accelerate the oxidation of plants, when using tap water to wake flowers, it should be exposed to the sun in advance, and then let it stand for 24 hours to let the chlorine in the water volatilize.

2. Hot material digging and water wake-up flowers

In the process of awakening the flowers, the cold water should be heated to about 50 degrees, and then the roots should be soaked in hot water, and then taken out after 4-5 hours, so that the plants can adapt to the surrounding environment and make the water and nutrients spread and circulated normally.

3. Awakening method

When waking flowers, the plant needs to be pruned, cut a 45° oblique opening about 3-4 cm close to the root system, so that the roots can better absorb the water and nutrients in the soil, and after pruning, spray carbendazim disinfection solvent on the incision to avoid the growth of bacteria.

4. Precautions

When waking flowers, it is necessary to ensure that the water quality is clean, if the water is polluted, the plants will carry germs, and before waking flowers, the branches should be placed in a cool place to dry for a period of time, and then soaked in water.