What to do if the bathroom floor drain is dirty, and the toilet floor drain is back to water

Carry out post-inspection and repairs.

Check the floor drain for any blockages, and if so, clean it up;

The floor drain releases dirty water, mostly because the height difference is not enough, so that the water will come up; Just like a river, if the dam height of the river is not enough, heavy rain and so on will appear on the dam, the reason is similar; The root of this problem lies in where the water trap of your floor drain is, that is, where is the excuse for your floor drain sewage pipe to be connected to a thicker sewage pipe, whether the height difference is too low, so that the water will come up, this must be rectified by yourself; Generally, the sewerage of the commercial house is in your house, but the interface with the general sewage pipe is in the one downstairs of yours, and the height difference is 40cm high, so it will not lead to backwater;

If you can't solve it, and you don't want to reverse the water, you can only close the floor drain, or buy a good anti-water floor drain, and raise the height of the floor drain here.

First of all, recall whether the water in your unit has been blocked before, and ask if the second floor of your house is also flooded, and if the other house does not have water, check whether there are obstacles in the sewer pipe from the ground to the ceiling on the second floor.

Some residents are troubled by the blockage of sewers, so they install cross forks on the section of the sewer that passes through their own houses upstairs (the sewer pipe is unobstructed at the bottom of their house), and liquid water and urine can pass through, but the paper and feces are trapped in the pipe and cannot pass through, and can only be flooded out from the entrance of the sewer pipe upstairs.

Addendum: To enter the door to the bathroom to check, if the downstairs does not let you, you can find the property to coordinate.

In addition, if there is a blockage once every few months, it is also possible that sometimes the cross fork is not installed in the pipe downstairs.

Also, go to the first floor and ask if there is any blockage or backwater.

Through your explanation, there should be a hard object in the middle of the main bar above the ground on the 2nd floor, between the main pipes below your house. After a long time, some grease and debris are bonded together, and the pipe is blocked. When dredging, debris and grease fall off, and the pipe is opened.

After a long time, it was blocked again. It is recommended to find a professional dredge to pull the main bar you add to the first floor, and the problem will be completely solved.

If the main pipeline is semi-blocked, when the household water is large, the water will come out of the floor drain when the water flow is not enough, it is best to take a look at the main pipe of the building. It is normal for the pipes to be rusty for a long time, and it is normal for the hair to be half-blocked by the pipes, so it is recommended that the property should clean up the main pipes, and then check the pipes at home, and if they are dredged, there will be no problems.

It is estimated that the pipes between the 2nd and 3rd floors are blocked, so the floor drain on the 3rd floor will be anti-dirty water. Household dredging tools can be bought online, if the picture is convenient, call the dredging master to come to the service.

I live on the 2nd floor, what should I do if there is dirty water in the corner of the wall below.

Kiss! Hello, happy to answer your <>

If the water drain in the wash basin is backwatered, it may be caused by a blockage under the main sewage pipe, because once the sewage is not smooth, the sewage will return to the nearest outlet from the blockage. If there is a situation in the process of use, then you can only find a professional person to dredge the pipe. : 1, the water dredging method first check to see if the drain is blocked, if it is blocked, you can open the tung burn to clean up the blocked place first, and then put water into the drain, and wait until the height is about the same time you can find the position of the water trap according to the water storage situation.

2. Pumping and dredging method Pumping pump dredging method is a more common treatment method, when dredging, you can put the hose of the pumping pump into the drainage pipe, and then seal the drain, and then put enough clean water to use this space to quickly pump air into the sewer, so that it can be dredged soon, and there will be no backwater. 3. If the soda and vinegar dredging method is blocked and causes backwater, you can try to dredge it with high-concentration vinegar and cooked soda powder. First put the baking soda powder into the floor drain, and then pour the vinegar into the drain, at this time, the baking soda powder and the strong vinegar together will produce a very strong chemical reaction, and some of the oily things in the pipe can be removed.

4. Log dredging method is simply put, it is to put a diameter of wood similar to the sewer pipe near the floor drain, and then release the water, and constantly pump the log up and down, so that the dirt in the pipe will be sucked away<>

Do you have any other questions?

The toilet uses a lot of water, so it is necessary to install a floor drain. What should I do if the floor drain in the bathroom is backwater? PChouse will take you to find out.

1. Water pipe problems.

First of all, it is necessary to find out the cause of leakage and backwater, the drain position of the bathroom basin or washing machine is the same as the floor drain, and the drainage pipe is not arranged, and there will be backwater. You can give up the floor drain function to plug it, and you can knock out all the ground and redo the water pipe installation.

2. Water discharge and dredging method.

Check it first to see if the floor drain is blocked, if it is blocked, you can clean up the blocked place first, and then put water into the floor drain, and wait until the height is about the same, you can find the location of the water trap according to the water storage situation.

3. Pumping and dredging method.

Pump dredging method is a more common treatment, when dredging, you can put the hose of the pump into the drainage pipe, and then seal the drain, and then put enough clean water in, use this space to quickly pump air into the sewer, so that it can be dredged quickly, and there will be no backwater.

Soda and vinegar can be poured into the blocked Shengxiang floor drain to remove the grease adhered to the pipe, so as to dredge the pipe; The caustic soda can be thrown into the sewer pipe and transported into the hot water before pouring, so that the oil scale of the pipeline can be dissolved and discharged along the water; You can use a pump capsule to be stuffed into the sewer and add water to pump up the pipe. Here's how:

1. Soda plus repentance and vinegar dredging.

Pour a small half cup of cooked soda into the blocked floor drain first, and then pour half a cup of vinegar, the soda reacts with the vinegar to remove the grease that adheres to the pipe, thus playing a role in unclogging the pipe.

2. Caustic soda dredging.

Throw the caustic soda into the sewer pipe, and then pour some hot water into the pipe, the caustic soda will undergo chemical changes when it encounters hot water, so that the temperature in the pipe rises rapidly, and the oil scale in the pipe will melt and be discharged along the water.

3. Dredging of the pump.

Stuff the hose of the pump into the drain, then put in a small amount of clean water, and keep pumping the pump in, and the pipe can be unblocked.

Change the floor drain to prevent water reverse.

The principle of automatic sealed floor drain: it is a kind of upper and lower brake opening and closing device that uses water energy in reverse. It uses advanced science and technology and ingenious mechanical principles.

The main feature of this product is that it achieves many functions with a unique piston structure and does not require a water seal. The product is installed at the drain, when the water flows in, the rubber gasket at the bottom of the device is opened, and the water is unimpeded, and after the water supply is interrupted, the rubber gasket at the bottom is closed, forming a complete seal, and the gas below the floor drain cannot come up.

It completely prevents the reverse flow of sewer that often occurs in family homes, and can completely resist harmful gases, harmful bacteria and pests from entering the room through the drain. Find a tool to poke and try, maybe something is blocked, it is not good to ask the master for help, after all, in the summer, if you want to change a floor drain, you can try the Titan's bathroom, the drainage effect is good, and the smell is prevented.

It is a very common problem that the toilet floor drain destroys the slag and dates and backs water, which not only affects the use of the toilet, but also brings a lot of inconvenience to life. The causes of floor drain backwater are more complex, and may be caused by blocked pipes, blocked sewers, bent drainage pipes, etc. Therefore, solving the problem of floor drain backwater requires careful analysis and treatment of the causes.

Here are some commonly used ways to deal with it:

1.Clean up the pipes.

If the floor drain backwater is caused by a clogged pipe, then the drain needs to be cleaned first. You can use professional sewer cleaners, pipe pipes or pipe drags, pipe chases and other tools to clean and dismantle the fibers. Before cleaning, turn on the faucet and floor drain to let the water flow out of the floor drain, so that the dirt in the pipe can be washed away.

2.Replace the floor drain.

If cleaning the pipes is ineffective, the floor drain may be damaged or deteriorated and needs to be replaced. When purchasing, the beam hail should be made of solid material, reasonable structure and long service life, and the appropriate size of the floor drain should be selected to ensure the use of the floor drain.

3.Retrofitting sewers.

If the floor drain is caused by a poor sewer, then the sewer needs to be reconstructed. You can use tools such as professional sewer dredging machines to clean the sewers, and you can also replace some equipment such as anti-sewage solenoid valves to improve the patency of the sewers.

4.Install anti-water counterparts.

If you often encounter the problem of backwater from floor drains, you can install anti-backwater devices on floor drains and drains to prevent sewage from backflowing and extending. Anti-backwater device can effectively reduce the odor of sewage, maintain indoor environmental hygiene, and at the same time prevent backflow water from polluting the surrounding environment.

In short, to solve the problem of floor drain backwater, we need to take corresponding methods according to the specific situation, in general, the toilet floor drain backwater can be treated by cleaning the pipe, replacing the floor drain, renovating the sewer or installing anti-water devices. The most important thing is to keep the bathroom clean and hygienic, pay attention to hygiene and cleanliness in daily life, and avoid throwing large items or paper towels into the toilet at will to avoid clogging.

The problem of dirty water from toilet floor drains is one of the more common problems in family life, and it is not difficult to solve. The main workarounds can be divided into the following:

1.Clean the floor drain.

First of all, keep the floor drain dry and clean, you can clean the floor drain with hot water or detergent to remove the accumulated dirt. In addition, you can also use hooks or pliers to clean up hair, confetti and other substances that have accumulated inside the floor drain.

2.Repair floor drains.

If dirty water still flows backward after cleaning, it may be caused by poor sealing of the floor drain or poor unclogging of pipes, and repairs are needed. You can use sealant to reseal the floor drain and the ground joint, or find a professional pipe maintenance engineer to overhaul it.

3.Retrospective backflow preventer is installed.

Installing a backflow preventer on the floor drain outlet can play a role in preventing sewage backflow. Backflow preventers are generally simple to install, and usually only need to install a device similar to a filter on the floor drain to prevent the backflow of sewage.

4.Practice good hygiene.

In family life, we should pay more attention to maintaining good hygiene habits, such as not throwing away garbage, hair and other stool materials at will, and not discarding a large amount of grease and other items in the toilet to avoid blockages in the pipes.

In short, it is necessary to maintain good toilet hygiene habits, clean and maintain frequently, and if the problem still cannot be solved, you need to find a plumbing maintenance personnel in time for maintenance and treatment.