-
The root system of the cylindrical leaf is fragile and prone to decay. The reason is none other than long-term wet pot soil. If the potting soil is a long-term supermarket, it will inevitably prevent the root system from fully engaging in aerobic respiration.
Over time, alcohol and other toxins produced by anaerobic respiration will cause the root system to die and form a rotten root system.
Causes of root rot of the tubular leaf moss moon: The cause of the root rot of the tubular leaf mosaic root is that the potting soil is moist and cannot be distributed, and there are three reasons for the potting soil to be wet for a long time
1. Excessive watering, treatment method: reduce watering. The tube-leaved Mosaic is a relatively drought-tolerant variety, and the potting soil can be kept slightly moist during the growing season.
However, if you really can't grasp the frequency of watering, you can simply dry it and water it thoroughly. If it rains continuously, it will be exposed to the rain for a few days, and the roots are very likely to rot, so pay attention to rain during maintenance.
2. The soil is too firm or compacted. Treatment: Use loose and breathable soil and add an appropriate amount of granular soil.
Large-grained soils such as perlite, ceramsite, honeycomb, volcanic rock, etc., have strong air permeability, which can keep the soil loose and accelerate water evaporation. In this soil, the root system can breathe well and be healthier.
3. The air permeability of the flower pot is poor. Treatment: Use a flower pot with good air permeability for maintenance.
The air permeability of ceramic basins and plastic basins is relatively poor, especially those without bottom holes, which have poor air permeability, and novices should try not to use them. If you don't have a good idea of the dryness and humidity of the soil, you can choose to use a terracotta or stoneware pot with a bottom hole. These pots have good air permeability and faster water evaporation, which effectively reduces the possibility of suffocation at the roots.
If. What to do if the roots of the <> tube leaf flower moon are rotten: remove the tube leaf flower moon from the pot, clean it, and then cut off the rotten roots. If you notice mold in the roots, soak it with carbendazim for 15 minutes and let it dry for a few days.
At the same time, the potting soil is spread to dry, then repotted, and then placed in a cool and ventilated place. Please note that watering immediately after planting is not recommended. You should wait until the roots of the plant are stable before watering.
Usually, roots can form in about 10 days.
-
Cut it down and feed it to the chickens, because that's what my family does, it's a pity that I can't eat it if it's rotten, so I'll feed it to the chickens.
-
It needs to be loosened first and the plant removed from the pot. Then remove part of the old soil, cut off the rotten parts with sterilized scissors, and apply plant ash for disinfection.
-
The best way to deal with this is to fertilize the rhizome in all directions, and then water it frequently to make the soil fertile, in this case, to remove some of these phenomena well.
-
<> tube leaves are shriveled, if the light is too strong, you need to move the plant to a cool place to cultivate, every 2 3 days to spray the leaves with water. If it is caused by pests and diseases, it is necessary to cut off the rotten and necrotic leaves to improve the ventilation and light transmission of the plant. If it is caused by insufficient soil nutrients, it is necessary to apply nitrogen, phosphorus and potassium compound fertilizer in time.
If the light is too strong, resulting in the leaves of the cylindrical moon shriveled, you need to move the plant to a cool room for cultivation, spray water on the leaves every 2 3 days to ensure that the humidity of the air is about 50%, and the leaves will return to normal growth after 1 2 weeks of culture, and then transplant them to the sun to grow.
If it is attacked by diseases and insects, resulting in the shriveled leaves of the tubular leaf mosaic moon, it is necessary to cut off the shriveled and rotten leaves in time to avoid the whole plant will be damaged, prune the branches and leaves of the plant, adjust the distance of growth distribution, improve ventilation and light transmittance, and avoid growing in a humid and stuffy environment, which will breed a large number of germs and pests.
If it is caused by insufficient nutrient content in the soil, it is necessary to supplement nutrients, you can apply nitrogen, phosphorus and potassium compound fertilizer on the soil surface, or add the organic fertilizer and diluted liquid fertilizer to the soil, which can effectively improve the content of organic matter and minerals, and you can also add some dead branches and residual leaves for fermentation.
If there is too much water at the bottom, the root system is rotten, resulting in the drying of the leaves of the tubular leaf flower moon, you need to dig the soil at the bottom to the surface, after the sun drying, accelerate the evaporation of water, check the growth of the root system, when the phenomenon of rot and necrosis occurs, it is necessary to prune the bridge plum in time to ensure the normal growth of the answer.
-
Don't ignore the rotten roots of golden branches and jade leaves, and dispose of them in time, otherwise a large area of plants will be infected.
-
Here's how to deal with root rot:
Peel the flower roots out of the soil.
Rinse with clean water until there is no clinging of soil to the roots.
Using gardener's shears, start from the bottom of the flower roots, and cut the small vine paths one by one.
Dump all the soil from the original pot and fill it with new soil rich in nutrients.
Implant the flower roots in the soil and water them with a small amount of water.
The main reason is that there is too much moisture in the soil, and the soil will maintain a high humidity for a long time, so whether it is in the daily watering or in the choice of soil, do not water with high frequency and quantity, which will not make the plants grow more lush, but only worse.
-
If you water too much, change the pot and try it, this is the only way.
-
Watered too much, and secondly, did not see photosynthesis.
-
Excessive watering We should know that even if it is a moisture-loving flower, if it is watered too much, after water accumulation, there may be root rot, too much water in the soil, and the root system cannot breathe normally, which will lead to root rot.
Unreasonable fertilization Many flower friends will have a misunderstanding, that the more fertilizer, the more vigorous the growth of flowers, you know, for some flowers and plants that are not particularly fertilizer-loving, too much flower fertilizer may be a burden, sometimes a little careless, it will burn the root system of the plant, resulting in rotten roots.
Bacterial invasion Some flower friends do not pay attention to the cleaning of the potting soil in daily maintenance, which is very easy to cause the breeding of bacteria, which invades the root system, causing wound infection, and root rot.
For root rot is not very serious, it can be sprayed with fungicides in time for prevention and control; First of all, clean up the root soil of the flowers, then check the roots, cut off the rotten roots with a disinfected knife, and then wash them with clean water, put them in a ventilated place to dry, and after the wound dries, prepare new sterilized potting soil for replanting.
In fact, the root rot phenomenon of flowers should be based on the prevention of daily normal maintenance, and in daily maintenance, pay attention to the appropriate amount of watering and control the amount of water; Reasonable fertilization, for flowers that do not like fertilizer, adhere to the policy of diligent application of thin fertilizer; In addition, it is necessary to pay attention to the timely replacement of potting soil, daily attention to the cleaning of potting soil rotten leaves, and do not put unrotted substances in the pot, which can effectively avoid the emergence of rotten roots.
Dear flower friends, have you learned? In order for flowers and plants to flourish, we must pay attention to these points!
The cylindrical moon prefers warm, dry and sunny environments, is drought tolerant and semi-shaded, and is not cold tolerant. >>>More
Don't be afraid of rotten roots and rotten leaves, use a little "it", recover quickly, and grow roots and leaves directly!
After the flowers rot the roots, it is necessary to remove the plants from the pot in time, remove the soil attached to the root system, and cut off all the rotten roots. Then put the pruned plants in the diluted carbendazim solution for disinfection, take them out after 20 minutes, put them in a cool and ventilated place, wait for the wound on the root system to dry, prepare the moist soil, replant the plants after drying into the damp soil, put them in a cool and ventilated place to slow the seedlings, and wait for the seedlings to be successfully maintained normally. >>>More
In fact, orchids like a moist environment, but the fleshy roots of orchids are afraid of waterlogging, so it is easy to rot roots if they are too wet or rainy, leading to many diseases. So how can you prevent orchid root rot? >>>More
In the process of cultivating jade trees, if the roots rot, we must pay attention to not watering too much water to ensure the ventilation of the leaves. Breed excellent breeds.