Where is the Tiida position light insurance, and where is the Tiida top light insurance

Tiida position light insurance, located under the hood of Tiida, inside the Tiida engine compartment, inside the black fuse box next to the Tiida battery on the left side of the Tiida engine, the specific operation steps to find the Tiida position light insurance are as follows:

1. Open the driver's door of Tiida.

2. Pull the hood switch on the left side of Tiida's driver's leg.

3. Lift up the hood of Tiida's engine.

4. Use the support rod to support the hood of the engine of Tiida, and ensure that the support is firm to avoid danger during operation.

5. Tiida position light insurance, located under the hood of Tiida, inside the Tiida engine compartment, and inside the black fuse box next to the Tiida battery on the left side of the Tiida engine.

Generally, there are three reasons why the reversing lights do not light up

1. The front or rear circuit of the reversing switch (hereinafter referred to as the switch) is broken;

2. The switch is damaged;

3. The reversing bulb (hereinafter referred to as the bulb) is damaged.

1) Cause of failure: Generally, the reasons why the reversing light is not lit are.

Three: 1. The front or rear circuit of the reversing light switch (hereinafter referred to as the switch) is broken;

2. The switch is damaged;

3. The reversing bulb (hereinafter referred to as the bulb) is damaged.

b) Exclusion method:

1. Preliminary preparations:

1. Put the power supply in the ON state (check whether the circuit is in the ON position by honking the horn or turning on the headlamp);

2. Jack up the carriage and fix it.

2. Inspection methods and steps:

1. Put the gear lever in the reverse position, if the light is not on, remove the cover of the lamp holder and check whether the bulb is in good condition;

2. If there is no problem with the bulb, check whether the two bulbs are well grounded;

3. If the grounding is good, the two external binding posts on the switch are short-circuited, if the light is on, it means that there is a problem with the switch; If the light is not on, the front and rear circuits of the switch are open;

4. Check the switch and the front and rear circuit breaks

1) Use a 2m long wire, one end is lapped at the total power outlet end of the fuse box, and the other end is connected to the inlet post of the external terminal post of the switch. If the light is not on, it means that there is an open circuit in the switch and the circuit from the switch to the bulb;

2), the same (1) but connect the other end of the wire to the outlet post of the external terminal post of the switch, if the bulb is on, it means that the switch has a problem; If the bulb does not light up, there is an open circuit in the back-end circuit.

To do car insurance, the most important thing is to learn the terms and related preferential discount policies, as well as the model configuration, the same model of the model, due to different configurations caused by the insurance amount is also different, such as Nissan Tiida, manual, automatic, standard, comfortable (generally with leather seats), luxury (generally with sunroof, navigation), the difference in car price is more than 10,000. Only by knowing the model to determine the insurance amount, knowing how to use the rate to calculate the premium, and accurately reporting to the customer, can we win the trust of the customer. There will be more and more customers.

Terms and rates can be found online, but the discount depends on the rules of the company you work for. There is also a job of car inspection before underwriting, and now there are some blacklisted customers in the society who specialize in making money from insurance companies. It is necessary to do a good job of underwriting and prevent "illness from entering the mouth" in order to get the company's benefit award, if any.

I don't know which insurance company you entered, but now each company has a group training, I think maybe you can ask him for information!

There is a black box next to the battery, called the smart power supply, and the small light insurance is in it.

Under the instrument panel, on the side of the main cockpit, open the door to see a curved plastic trim on the side of the dashboard, and the fuse can be seen by prying out the plastic trim with the interior pry plate, and the fuse comparison table of the corresponding position is on the plastic trim.

It's under the main driver's cover.

Headlight fuses, and wide-sight light fuses, in a black square box behind the engine compartment battery. Press and hold 4 clips to lift up, and in turn you will see the fuse. If you don't have a testing tool.

Just unplug each one and take a look, and replace the bad ones. The market is about 5 cents a piece. If you still hold the same fuse.

It is necessary to check whether there is a short circuit in the corresponding line, which is generally caused by accident maintenance.

At the bottom left of the steering wheel, a plastic plate over there can be found by pulling it open and comparing it to the instructions above.

I just changed the fuse, although it was a cigarette lighter, but the night light is the same reason, please see the specific introduction, only a few dollars?? 1500, is it killing pigs??

Do-it-yourself--- change Tiida fuses.

As far as I know, there are only two reasons why cars spontaneously combust. First of all, the engine room oil leakage, more common in second-hand cars and vehicles that have had major accidents, because the temperature is very high during the operation of the engine, so once the flammable liquid leaks, spontaneous combustion accidents will inevitably occur, such as gasoline, engine oil, glass water, etc., but the probability of occurring in a new car is very low, lower than the probability of a small bump; In addition, it is to change the circuit without permission, load electrical appliances that are not used in the original car, etc., causing cross-linking of the line, short circuit, resulting in overload and heating of the wiring harness, spontaneous combustion, which is mostly seen in the installation of additional anti-theft alarms, the installation of xenon headlights, the installation of floor lights, etc., and the installation of oil-to-gas equipment in many vehicles at present, also increases the possibility of spontaneous combustion.

For Qida, I think this friend can think like this, after all, the car is an industrial product, the product must have excellent and defective products, most people are lucky, the car they buy are qualified cars, excellent products, and a very small number of bad luck, buy defective products, encounter troubles is understandable. I haven't seen the news you said, but I think that if the spontaneous combustion of Qida does not have a man-made factor, I think I can only blame the owner for his bad luck.

I advise you to trust in your own vision and luck!

It's really hard to say, but 1500 is too dark for the wife, and you don't need 1500 for a headlight assembly

Ask other car owners.

The F9 fuse in the large power box between the left front shock absorber and the battery is the fuse of the fog lamp, but the power box is upside down, and it only looks like the back.

It should be in the fuse box in the engine compartment, which one is best to check it out at a 4S store near you.

Also, can you see if there is a description in the manual?

The policies of each company are different, so the regulations are different.

Memory issues. Unplug the memory and wipe it. It is best to use an eraser. Plug it in. Remember to turn off the power when you unplug it.

Look in the fuse box in the engine compartment, there should only be a small light fuse [If there is a problem with the car, ask the car master. 4S shop professional technician, 10 minutes to solve. 】