Dongfeng Scenery 330 reversing image does not show what s going on

There are many reasons for the problem you described. For example, 1, motherboard compatibility problem 2, line failure, whether there is a virtual connection problem, etc. 3, camera failure 4, circuit problem, voltage stability or not, whether the line has a short circuit, etc. It's a good idea to have it checked at a specialist shop.

Hello! Whether you install or the original car reversing image, the general reversing image is not displayed because of the reversing camera or the line failure of the camera to the host, and in a few cases, the host will also cause.

There are many possible reasons why this motor vehicle reversing image does not show, generally speaking, the camera may be burned and needs to be replaced.

There are many reasons for this, such as camera damage, line failure, loss of reversing signal, etc.

It's possible that the line is faulty, or the camera is broken.

The reversing image does not show the settings first, followed by the camera, the fault of the line.

It's best to check inside the store, it's usually a wiring problem, or the camera is damaged.

Check out camera damage, line failures, system issues, and more.

Hello, this may be caused by a damaged camera or a faulty line.

It should be a problem with the line connector, or the camera is broken.

First of all, it is recommended to check the wiring harness, and then there is the lens problem

It should be caused by damage to the reversing image probe or line failure.

Add it later, check the line fault, I hope the answer is satisfactory.

There may be a problem with the wiring or camera, so go to the store and check it.

It's possible that the camera is broken or the wiring is faulty.

If the reversing image does not display, it may be that the camera is broken or there is a problem with the line connection, so check it specifically.

Hello, the reversing image does not show you to check whether there is a problem with the camera or a fault with the line.

Hello, it is recommended that you check the wiring to see, or the camera is broken.

Hello, I am glad to answer the Dongfeng scenery 330s reversing image adjustment this fast, you can refer to the following, reversing image left and right adjustment method: if the reversing image appears left and right upside down, one is to install the front rock gear rear camera upside down, that is, the front camera is mistakenly installed in the rear of the car, the biggest difference between the front view car camera and the rear view car camera is the image of the imaging, if the rear view camera is used with the front view camera, then the image on the display screen, the left and right are the opposite. The other is that this can be re-hung into the reverse gear, find the setting button in the navigation device in the mode of reversing image shooting, find out if there is a mirror adjustment or reversing mirror function, and then click to turn it off.