Is Tiandi s home decoration really as good as it says on the Internet?

It is hoped that the relevant departments can seize the home improvement company of Tiandi's family pit.

Not to mention the cost of adding left and right, 65% of the project payment was collected in the first phase, and the construction period of three months was said to be good, but it was delayed for 5 months and less than half of it was completed. Before the floor is finished, I am in a hurry to urge you to pay another 30% of the project payment. The construction is all outsourced, with an average of less than a day of construction a week, and now it is completely suspended for more than a month, and the wardrobes and bookcases that are customized in other homes cannot be installed because they are suspended and cannot be installed in the warehouse.

Countless times of questioning, all kinds of excuses said that the door ordered four months ago has not been produced by the manufacturer so far, and the other projects in charge of the foreman have not been completed......It's completely the posture of the uncle who has received the money. was waiting to renovate the Spring Festival and live in a new house, but now it is far from the end of work. I hope the relevant departments can help solve it.

It's really good, my home is also this, I think it's more convenient, one stop all-inclusive, just check in with your bag.

The contract lasted 90 days in black and white, and it could be completed in 8 months (more than 240 days), and it was when I complained to the Consumer Association twice. **Advertise 80,000 all-inclusive, the contract is actually 180,000, left plus right, pay the deposit and you are a sheep to be slaughtered!

Looking for Tiandi's home decoration, looking for Ma Fan, the routine is deep.

Upstairs is really Tiandi's family invited God to comment, if it's a layman, then don't say it, insiders won't be deceived by you Of course, I was also deceived by Tiandi's family, and now I should spend money to buy back smart, and people who don't believe in it will experience it themselves Don't block it

Bathroom waterproofing construction steps:

The first step is ground leveling. If you want to replace the floor tiles in the bathroom, after removing the original floor tiles, you must first level the floor with cement mortar, and then do waterproofing treatment. The joints should be painted in place, because the joints between the wall and the floor of the bathroom and the joints between the water and sewage pipes and the ground are the most prone to water seepage;

In the second step, a waterproof coating about 30 cm high should be applied to the wall treatment to prevent stagnant water from penetrating the wall. However, if the bathroom wall is a non-load-bearing lightweight wall, the entire wall should be coated with waterproof paint. If there is a shower room in the bathroom, the two walls that are connected should also be painted; In the case of a bathtub, the height of the waterproofing coating on the wall adjacent to the bathtub is higher than the upper edge of the bathtub;

The third step is that the waterproof experiment must be done carefully. After the construction is completed, all the sewer in the bathroom is blocked, a wall about 20 cm high is built at the entrance, and then water about 2 cm high is poured into the bathroom, and the surrounding walls and floors are checked for leakage after 24 hours. The waterproof test is the key to ensure the quality of the toilet waterproof project, and it must be done.

The base layer should be treated first: remove the original decorative materials, clean up the floating soil and cement, and require a smooth and dry surface.

Paving waterproof coating: brush a layer of modified asphalt on the base layer of waterproof treatment, spread a layer of glass wire cloth, and then repeat the brushing, and finally paint again on the second layer of glass wire cloth, and the waterproof treatment is completed. The waterproof coating should be evenly painted, the glass cloth and the waterproof layer should be tightly closed, and there should be no leakage, bulging and falling off, otherwise the waterproof effect will be affected.

If polyurethane is used as a waterproof coating, there is generally no need to add glass cloth, as long as it is repeatedly painted 2-3 times. Note: Please refer to the Tips section under the page.

Do "closed water" test: closed water test is an important inspection means to check the quality of indoor waterproofing. After the waterproof project is completed, seal the door and the drain, fill the room with water to reach a certain liquid level height, and if the liquid level does not drop significantly within 24 hours, it is qualified.

Make another layer of protective layer: make another layer of cement mortar protective layer on top of the waterproof coating layer, taking care not to destroy the waterproof coating layer that has been made. After the protective layer of cement mortar is dry, you can pave the wall and floor tiles or spray paint on it for normal decoration.

Closed water test practice:

Make a 30 50 mm high water retaining strip (ridge) at the door of the room with a waterproof layer of yellow clay, low-grade cement mortar and other materials, and block the floor drain tightly. After the ground is blocked, then the water is released on the ground to form a small pool with a depth of 20 30 mm After the water is stored for 24 hours, it is checked on the lower floor slab to see if there is any leakage. If there is leakage, redo or repair the waterproof layer, and then do the closed water test in the above order.

Until no leakage is qualified. Hopefully mine will bring you a reward.