Where is the old Teana hot water tank?

Updated on Car 2024-07-21
5 answers
  1. Anonymous users2024-02-13

    If the temperature in Changzhou is below 0 degrees, it is best to add antifreeze. The car can reach -1 degree, or the water tank may freeze in 5 hours without a temperature of -1 degree. The way antifreeze is added:

    1.Unscrew the lid on the top of the tank firstAfter emptying the water in the tank, tighten the bolt (the water bolt is under the water tank, you may need to use a pliers, and some can be unscrewed directly by hand), and completely drain the water in the tank before 3

    Unscrew the small water drain screw on the thermostat with a screwdriver or a suitable wrench (on the thermostat, the one with a diameter of about 8 mm, varies from car to car) 4Add antifreeze to the water tank, add it to the small drain screw on the thermostat and run water, that is, tighten the small drain screw 5 on the thermostat. Continue to add antifreeze to the mouth of the tank until you can't add it, and then unplug the rubber air drain tube next to the tank cover.

    6.Start the engine, generally step on the throttle to more than 3000 rpm, until the radiator fan rotates to dissipate heat, that is, loosen the throttle, (at this time the water at the mouth of the water tank will drop some) let the engine idle running, and then continue to add antifreeze to the mouth of the water tank, until the pipe of the exhaust air flows, let the water flow for about 3-5 seconds, that is, plug in the tube of exhaust air, and then step on the throttle to more than 3000 rpm, that is, loosen the throttle, let the engine idle running, and then add antifreeze to the mouth of the water tank, add until it can not be added again. (Be sure to repeat this procedure once, otherwise there will be bubbles in the circulating tube of the engine body, which will seriously affect the heat dissipation of the engine, be sure to exhaust the air) 7

    I tighten the tank cap and am done! Note: Generally, the volume of the water tank of the small car is about 2 kg, and the antifreeze **10-50 yuan is between a bottle, in addition to the antifreeze can increase the freezing point of the water in the tank (the freezing point of the water is 0 degrees, and it can not freeze at -25 degrees in winter after being added), it can also increase the boiling point and remove the scale in the water tank.

    Buy a bottle of about 2 kg of antifreeze, if it's not enough, add a little purified water, there is no need to buy 2 bottles.

  2. Anonymous users2024-02-12

    There is no water plug on the car water tank, and if you need to drain water, you can remove the sewer pipe to drain the water.

  3. Anonymous users2024-02-11

    The Ethereal water tank is located on the right side of the engine next to the booster oil tank. The automobile water tank generally refers to the automobile radiator, the radiator belongs to the automobile cooling system, and the radiator in the engine water cooling system is composed of three parts: the water inlet chamber, the water outlet chamber, the main piece and the radiator core. The steps to add water to the car water tank are as follows:

    1. Turn the pressure cover in the counterclockwise direction, if you hear a hissing sound, wait until the sound disappears and then slide the filial piety branch to open;

    2. Fill an appropriate amount of coolant into the coolant expansion tank to reach the position between the max and min scales of the expansion tank;

    3. Start the engine when the coolant expansion tank cover is opened;

    4. After starting the engine, the coolant in the tank will slowly decrease, and then add an appropriate amount of coolant to the expansion tank until the liquid level reaches the position between the max and min degrees of the coolant expansion tank;

    5. Reinstall the lid carefully and make sure that the pressure cover is tightened by hand and fully in place.

  4. Anonymous users2024-02-10

    The Ethereal water tank is located on the right side of the engine next to the booster oil tank. Automobile water tank generally refers to the radiator (automobile radiator) The radiator belongs to the automobile cooling system, and the heat dissipation infiltration hall in the engine water cooling system is composed of three parts: the water inlet chamber, the water outlet chamber, the main piece and the radiator core. The steps to add water to the car water tank are as follows:

    1. Turn the pressure cover in the counterclockwise direction, if you hear a hissing sound, wait until the sound disappears and then open the shouting stove;

    2. Fill an appropriate amount of coolant into the coolant expansion tank to reach the position between the max and min scales of the expansion tank;

    3. Start the engine when the coolant expansion tank cover is opened;

    4. After starting the engine, the coolant in the tank will be slowly reduced, and then add an appropriate amount of coolant to the expansion tank until the liquid level reaches the position between the max and min degrees of the coolant expansion tank;

    5. Reattach the lid and make sure the pressure cap is tightened by hand and fully seated.

  5. Anonymous users2024-02-09

    Nissan Teana water tank in**? The Nissan Teana water tank is located in the front compartment of the engine, next to the power tank. The car water tank generally refers to the radiator.

    The radiator belongs to the automobile cooling system, and the radiator in the engine water cooling system is composed of three parts: the water inlet chamber, the water outlet chamber, the main piece and the radiator core. The maintenance of the car water tank is as follows:

    1. Stop the vehicle and turn off the engine, and after the coolant temperature drops down, prepare the brigade to open the expansion kettle and fill the water tank cleaning agent;

    2. Start the engine until the cooling fan is working, and then idle and run for 5-10 minutes;

    3. Turn off the ignition and remove the front bumper of the vehicle. When disassembling, make sure that all the fixing screws have been unscrewed, and then slowly disassemble from both ends to the middle, and do not break the fixing buckle;

    4. Ensure that the coolant temperature is completely cooled, and then drain the water tank cleaner along with the coolant, and finally replace the engine coolant with a new one.

Related questions
13 answers2024-07-21

1. Insert the key into the keyhole to power up the vehicle. There is a button in the lower left and lower right corners of the dashboard, press the left button. The left button is the selection key, and one click is the adjustment hour. >>>More

8 answers2024-07-21

The 13 models are the Ethereal and the 14 are the Dukes, with a long wheelbase and more luxury.

3 answers2024-07-21

The size of the earth heating tank depends on the actual situation, and the bigger is not always better. >>>More

12 answers2024-07-21

It is recommended to buy Magotan, and Ruizhi is fortunate to be a rear-drive Tian Lai does not have anything to do with these two cars. Magotan and Ruizhi are sporty, and Teana is a more business car. Others think you're the driver. >>>More

12 answers2024-07-21

In this car, the new car has a feeling of throttle lag, which may be related to its electronic throttle. The accelerator pedal of the electronic throttle is a "false throttle", just a receiver, after he receives the driver's action of stepping on the accelerator, it will transmit the power, amplitude and other data of the action to the control unit for analysis, and then summarize the driver's intention to step on the accelerator, and then the control unit controls the throttle motor to work according to the actual throttle opening and closing instruction after calculation. >>>More