How to remove rust and what method to remove rust

The frame can be treated separately, sandpaper to polish the rust, then clean the grease, spend a few dollars to buy a can of black self-spraying paint to spray it locally, pay attention to do a good job of protection, masks are essential, and pay attention to the brake disc next to it not to spray, let alone the exhaust!!

Stuff is rusty.

There are two ways that can be used.

It depends on the thing.

One is removed with a rust remover.

The other can be sanded away.

The best way to remove rust is as follows:

1. Use white vinegar.

Vinegar reacts chemically with rust on metal, breaking it down. You can soak the metal in white vinegar for a few hours and then wipe off the rust. If the item is too big to be immersed in the white vinegar, you can pour a layer of white vinegar on top and let it condense.

You can also soak a rag in vinegar and wipe the metal.

You can try dipping aluminum foil in vinegar and using it as a brush to scrub away the rust. Compared to steel wool, aluminum foil is less worn, but still has the ability to remove rust. You can use regular vinegar and let the rusty metal soak in the vinegar for up to 24 hours before it is cleaned.

This method doesn't require much scrubbing.

2. Make a paste with baking soda.

Mix the baking soda and water together until the mixture is thick enough to apply to the metal. Give it some time to condense before scrubbing it off. You can try using a toothbrush to brush off the baking soda and rinse it with water.

You can dilute the baking soda with water to your liking, and there is no set mixing ratio.

3. Transform the rust layer.

Buy rust converts, they will stop the rust area on the metal from expanding. Rust converting agents are similar to spray paint and can also be used as a primer protective layer. While it prevents the rust layer from expanding, it may not be effective in completely removing the rust layer from the metal.

This method only works if you intend to paint on metal. It will also leave a rough texture under the lacquer coating, as you would have just covered the rust with a layer of lacquer.

Vinegar can remove rust. If there is rusty metal, you can pour some vinegar to soak it or wipe it directly with vinegar. Salt and lemon to rust.

Apply the salt to the rusty area, then squeeze the lemon juice on the salt and let it sit for a few hours before wiping it clean with a dry cloth. Baking soda to rust. Mix baking soda and water together to form a paste and spread evenly over the surface of the rusty item.

After 1-2 hours, you can start brushing with a brush. <

1. Vinegar can remove rust. Vinegar is a very common thing, if there is rusty metal, you can pour some vinegar to soak it or wipe it directly with vinegar.

2. Salt and lemon to rust. The same goes for lemon and vinegar. Apply the salt to the rusty area, then squeeze the lemon juice on the salt and let it sit for a few hours before wiping it clean with something.

3. Baking soda to remove rust. Mix baking soda and water together to make a paste, and then spread the baking soda paste evenly on the surface of the rusty item, remembering that it must be completely covered. After 1-2 hours, you can start brushing with a brush.

4. Diesel rust removal. If the tool is rusty, you can directly put the tool into the diesel and run for a while before taking it out to wipe.

5. Use potatoes and baking soda. Soak the potatoes in soda for a while, then take them out and place them on top of the rust layer for a few hours.

6. Use oxalic acid. Mix 25ml of oxalic acid with 250ml of warm water, soak the item for about 20 minutes, and then wash it off with a rag or brass brush to remove rust stains.

The rust can be removed by adding salt to the sliced shallots, sliced potatoes or radish skins, and rubbing the rust vigorously to remove the rust on the metal.

Rust is a chemical reaction between metal and oxygen, and in life, the most common is rust, which produces a brownish-red thing, which is not as hard as iron, but will absorb water more easily.

How to remove rust: You can first use a cut onion and the skin of a sliced potato or radish to add a little salt, and then rub the rust to remove the rust on the metal object.

The method of rust prevention: one is to smear the cut ginger slices on the metal object, the second is to wipe the metal object with the tea residue in a gauze bag, and the third is to soak the cleaned metal iron in the rice washing water, and then dry it.