Can a new car run at high speeds, what is the effect on the car

Hello, the new car within 3,000 kilometers belongs to the run-in period, in order to keep the vehicle in good condition in the future driving and use, reduce the failure rate, it is necessary to do a good job of the run-in of the new car, the run-in time of each part of the vehicle is different, the run-in time of the general engine will be longer, the speed of the engine during the run-in period should not exceed 4,000 rpm, and the speed should not exceed 100 km h, and it is best to gradually increase. Don't rush to the gas pedal, slam on the brakes, it's best not to drive with a full load, and don't drag other vehicles.

There is a difference between running on the highway and running at high speed.

As long as the new car is not overloaded, the speed is not more than 3000rpm.

For AT cars, it is difficult to get up to 3000rpm if you step on the accelerator slowly (it is estimated that the new car is reluctant to step deeply).

Recommendation: First 500km

Try not to run on the highway because of the run-in brakes, because there is less chance of applying the brakes on the highway than running below. In this way, it is not possible to run in well and praise the brakes. If you really want to run on the highway with a new car, you should appropriately lengthen the number of kilometers of running-in brakes, such as 700km.

During the run-in period of the AT, I personally think the best way is: 500km maximum speed run 80-90 yards; 500-1000km, 90-100 yards at the highest speed; 1000-15000 top speed 100-110 yards; After 1500km, you can let go of the run, step on the throttle deeply, and control the gear shift at 2000-2500rpm.

No problem at all!

I'm not worried about new cars, I'm worried about new drivers!

Don't drive tired, don't speed, just overload!

New cars are not suitable for long-term safe driving on highways. After the car is withdrawn, each of its parts is to be solved through the run-in period, although the car manufacturer has carried out a very great inspection, but at this time to run fast is very easy to cause irreversible damage, endangering some car parts to prolong life, so it is best not to drive safely on the highway after the new car is bought, if it is necessary to go, the time can not be too long;

The high speed of a new car will affect the service life of the car engine. The vast majority of new cars have the speed ratio requirements of the car engine during the run-in time, and we must run on the highway for a long time, which will easily cause the car engine to cause excessive load. Under normal circumstances, domestic cars cannot exceed 75% of the required load, and imported cars cannot exceed 90% of the required load, if the degree of exceedance will cause damage to the automobile engine;

Driving on the expressway is very easy to cause insufficient gear speed ratio running-in period. Because each gear corresponds to a different car speed, the speed on the highway is relatively stable, whether it is a manual or automatic car car is not easy to add and subtract gears casually, which also causes the speed ratio between the gears to run in the period is not sufficient, in the long run, there may be a sense of frustration in safe driving in the middle and late stages, so the new car does not have to be at high speed.

Whether it is running fast or daily driving, we should slow down when the car is cold for a period of time (the speed does not exceed 60km h), and wait for the water temperature of the car to achieve normal operation and then carry out rapid driving; To prevent violent safe driving and lack of driving, it is proposed that the speed ratio of the new car should not exceed 3000 rpm when accelerating, and it is also very easy and pleasant to run 120 at high speed when the new car accelerates slowly;

To prevent long-term fast running, it is generally recommended to run for two or three hours, if you must continue to run fast, then it is recommended to go into the high-speed service area every 4 hours to take a break; The application of gasoline and diesel with safety guarantees, different car compression ratios are not the same, so we must strictly implement the manufacturer's requirements for filling gasoline and diesel, in addition to the need to go to a professional gas station when fueling, to prevent poor quality and no guaranteed vehicle gasoline from being filled by oil vendors or black merchants.

In fact, the development trend of automobile technology is very fast, and the precision of mechanical equipment is already very high, and some manufacturers do not need to spend too much thought on the run-in time in order to better buy the car, and carry out the "cold running-in period" solution before the car leaves the factory, that is, put the car engine on the professional bench to promote the run-in period.

But even then, it is still proposed that there will still be a period of running-in during the new car period, so it is necessary to use appropriate and safe driving methods even at high speeds, otherwise it will still cause irreversible damage to the car.

I think this is because it is best not to run at high speed when the new car is in the run-in period, because it will bring some irreversible damage to the new car; The high speed of the new car may affect the life of the engine, increase the load on the engine, and will lead to insufficient gear run-in of the new car, which will affect the comfort during driving.

The main thing is that when running at high speed, you need to have a certain speed to defend yourself, so it is best not to run high speed when the new car is ruined, it is very likely to cause harm to the car, and it will also affect the sex of the car.

This is a book because the new car is in the run-in period, if it runs at high speed, it may damage the car parts; For the damage of car parts, the impact on the car is very great, which will affect the engine of the car.

If you just buy a new car and run a high-speed sliding potato, it may cause very much damage to the car. In particular, it will wear out our tires, and it will also have a great impact on the start of the token machine; The high speed of a new car can cause too much carbon deposit in our engine. And some new cars can be very difficult to grasp the speed, and they are also more prone to traffic accidents on the highway.

There is no effect on the new car running at high speeds.

There is no problem with buying a new car directly on the highway, the impact on the vehicle is actually negligible, of course, if it is on the highway, the impact of violent driving on the power system of the vehicle is still very large. For the power system, it is easy to produce irreversible wear, affecting the service life of some automobile parts.

The benefits of high speed on a new car

After the highway, the various parts of the new car are a kind of running-in, and the new car will undoubtedly accelerate the run-in between vehicles after the high-speed, although the current automobile manufacturing level and technology are constantly improving.

However, in the manufacturing and production process of parts, there will still be some errors in its manufacturing, and the installation error of these parts will produce gaps and burrs, and the burrs can be quickly cleaned after the new car pulls the high speed.

After high-speed operation, the gap between the parts will be smaller, forming mutual friction or occlusion, so that the contact surface of these parts will become smoother, and the matching gap will be tighter, so as to achieve the best operating state of the whole car as a whole.

Precautions for new cars when running at high speeds

First, it is best to maintain a reasonable speed, and the reasonable speed mentioned here is not that the car runs at a speed, like a cruise at a fixed speed, but that the car should neither drive at a low speed nor accelerate sharply at high revs. The speed of the vehicle is best controlled within 100km h, and the engine speed and speedometer should be observed during driving, and the engine speed should not exceed 3000 rpm.

Second, during the driving process, do not start "floor oil", brake to the end, emergency braking will affect the braking system, but also increase the impact load of the chassis and engine. You know, being gentle with your car is the only way to get a long-term plan.

Third, manual transmission models should use the gear reasonably, do not drive in low gear for a long time, in addition, high gear and low speed and high speed and low gear are not the best plan. It is best not to rely on "D gear to go all over the world", and the reasonable use of such as S gear, manual mode, etc., is beneficial and harmless to the gearbox.

Fourth, don't drive with full load and don't overload, because this will cause damage to your car's parts. In addition, if the new car is used in the northern winter, it is best to give the engine a sufficient lubricating time before starting, and it is also beneficial to warm up for a short time.

There is an impact, and the new car running at high speed has a certain impact on the car.

When a car engine is driving at high speeds, the internal machinery will suffer a lot of wear and tear because it is a new part. In addition, the engine oil used in new cars contains a lot of metal shavings, which will increase the wear and tear of the engine at high speeds.

Therefore, it is recommended that car owners need a period of run-in after buying a new car. If the new car cannot avoid high-speed driving, control the driving speed of the car within a reasonable range, and be careful not to pull the speed too high, so as not to damage the engine due to high-speed driving.

What should I pay attention to when the car runs at high speed? Before getting into the car, pay attention to check the hidden dangers, concentrate on driving, avoid fatigue driving, maintain a safe speed, ask for instructions early and report late, drive carefully at night, and handle flat tires correctly. It should also be noted that motor vehicles that meet the scrapping criteria are not allowed to drive on the road.

The new car running at high speed has a certain impact on the car, but the impact is not large, and it will not affect the normal use of the car: 1. There are many car owners who think that the new car can not be driven at high speed during the run-in period, because the engine is running at high speed, the mechanical wear and tear inside the engine will be great, and the oil used in the new car is the most metal chips. It may cause the vehicle to not reach the best condition after the break-in period;

2. Some car owners think that the new car can run at high speed, because the engine quality produced by the car manufacturer is very reliable, and the engine technology is also improving.

3. Although these two statements are more reasonable, it is recommended that the owner needs to go through a period of run-in after buying a new car, if you really need to run at high speed, the speed of the car should also be controlled within a reasonable range, and do not pull the speed of the car or the speed of the car too high to avoid damage to the engine.

Millions of car purchase subsidies.

The high speed of the new car has a certain impact on the car, but the impact is not large, and it will not affect the normal use of the car. There are many car owners who think that the new car is in the run-in period is not able to drive at high speed, because the engine is running at high speed in the situation of bending, the mechanical wear and tear inside the engine will be great, and the oil used in the new car is the most metal chips, with these oil with a large number of debris to pull the high speed, it will increase the loss of the engine, and in serious cases, it may bring irreversible losses, which may lead to the vehicle not reaching the best state after the run-in period. Some car owners think that the new car can run at high speed, because the quality of the engine produced by the car manufacturer is very reliable, and the engine technology is also improving, many car owners believe that the current engine does not need to go through the run-in period, and the new car has gone through the cold run-in before leaving the factory, so they think that the new car can run at high speed.

Although these two statements are more reasonable than carrying Jane, it is still recommended that the owner needs to go through a period of run-in after buying a new car, if you really need to run at high speed, the speed of the car should also be controlled within a reasonable range, do not pull the speed of the car or the speed of the car to avoid damage to the engine. For more information about the impact of the new car running at high speed, enter to see more content.

The high speed of a new car will not affect the vehicle. High-speed driving is beneficial to the car under the right circumstances, such as the highway can provide a wide amount of space for the car to perform better and achieve better fuel consumption. However, if the car is driving at extremely high speeds all the time, certain problems can arise such as the car's braking system overheating, overheating the tires, or excessive wear.

In addition, an important note for driving at high speeds is that regular maintenance must be carried out and that the car is in good mechanical condition, which can reduce the occurrence of overheating of the vehicle or other technical problems. Keeping your car running and brightening the oil and coolant is new, and putting high-quality fuel in the tank can also help your car perform better on the highway. In addition, drivers must be careful not to speed on the highway and drive safely to reduce the risk of accidents.

In conclusion, driving on the highway, like driving in other road conditions, does not affect the car and is a method that can help improve the performance and fuel consumption of the car. However, it is essential to pay attention to the maintenance of the vehicle and the safety of the driver when driving on the highway to ensure the safety and performance of the vehicle at high speeds. <>

There is no effect on the new car running at high speeds.

When driving, you only need to pay attention to avoid violent driving such as overloading and sudden braking, and comply with the regulations.

After a period of operation and friction of the new transmission parts, the contact between the joint and the meshing surface is very consistent, and the surface is very smooth, which is called running-in.