Can the car pass the annual review with scratches and dents?

Whether the car can pass the test if the car has a depression depends on the degree of the depression, and the small depression can pass the annual inspectionBecause the annual inspection mainly inspects the safety and modification of the car. However, if the dent is more obvious and the damage is relatively large, the car cannot pass the examination, and the staff will let you go to the 4S shop to do a good job of repair and maintenance and then come back for inspection.

New policy for annual inspection of private cars.

1. Safety defect recall: A new "safety defect recall" link is added to the network inspection project, that is, when the car is checked online, the staff will remind the owner of the current recall situation of the car.

2. Appearance inspection: The new regulations clarify the scope of automobile appearance modification, which indicates that the luggage rack and the grille are stated.

Pedals, bumpers.

Alterations are allowed to be made to the wheels.

Slight scratches are fine, if the scratches are particularly obvious and the area is large, it may be considered unqualified by the inspection end of the vehicle management, and the appearance of the vehicle during the annual review is only taken from a few angles, and there is a certain probability to avoid the degree of scratches when taking pictures. As for the depression, it also depends on the degree, not obvious can generally pass, communicate with the staff when inspecting the car, they will have a way to avoid unqualified, and even have scalpers to deal with this kind of situation, just to spend a little more money.

As long as the iron plate is not exposed, there are scratches and dents, and the vehicle can generally pass the external inspection.

The scratches and dents are large, and they need to be repaired before going to the inspection line for inspection.

It mainly depends on the size of the scratch and depression area, whether it is serious. If the damage is not serious, the area is small, and the annual review will not be affected.

Under normal circumstances, slight scratches and dents will not affect the annual review of the vehicle, from the ** you provide, your scratches have been damaged to the bottom paint, should be repaired in time, otherwise it will cause corrosion to the iron sheet of the door (now it is yellow and rusty).

Generally, if you don't pass the annual inspection, you're stuck in the **? Today, Dr. Dou will conduct an in-depth analysis with you.

The vehicle lights are not up to standard.

1) The brightness and transmittance of the lights are insufficient. The vehicle may be used for a long time, due to the aging of the circuit and other reasons, there is insufficient power or poor light transmittance of the bulb, resulting in dim lights, if this is the case, it needs to be repaired and replaced in advance.

2) The tail lights must be on. The brake light needs to be lit when the brake is applied, otherwise it is not allowed to be detected online, so you must check the brake light yourself before going to inspect the car.

3) Modify the headlights without permission. After modifying xenon headlights or personalized headlights, when its appearance is different from the driving license, it will affect the annual inspection, and the lights should be changed back to the original style to meet the testing requirements.

The brake system is not up to standard.

Vehicle brake failure is one of the main reasons why vehicles fail to pass the annual inspection.

1) Worn brake pads. The general recommendation is to replace the brake pads at 10-120,000 kilometers, but it is still necessary to replace them as early as possible according to their own driving habits, such as the wear of the brake pads is more obvious.

2) Handbrake. It is easy to ignore the handbrake during maintenance, and the occasional negligence at the start may cause serious wear and tear of the handbrake function, so you should pay special attention to the maintenance at ordinary times, and pay more attention to the warning of the dashboard when using the car to prolong the service life of the handbrake.

The appearance of the vehicle is not up to standard.

1) The color of the body has changed, but it has not been filed with the DMV.

2) There are labels or sprayed patterns on the body, more than 30% of the vehicle area.

3) Obvious retrofitting. Such as the rear wing, pedals, bumpers, large surrounds, wheel modifications, etc., the obvious installation behavior does not meet the vehicle inspection standards.

4) Tire size and tread. The size of the tire must be consistent with the registration certificate, and the pattern must be coaxial (i.e. the two front wheels are the same, and the two rear wheels are the same).

The exhaust gas is not up to standard.

The state vigorously remediates emission pollution, and the testing standards are becoming more and more stringent, and the unqualified exhaust gas test is also one of the main reasons for the unqualified annual inspection.

Most of the vehicle exhaust is unqualified, and most of them are old vehicles. These models should be regularly maintained when they are usually used, and it is best to use high-standard gasoline before annual inspection. If the test is not qualified, there are several ways to deal with it, such as replacing the spark plug, cleaning the air filter, cleaning the throttle and three-way catalytic converter and other components.

As long as the appearance of the damage is not large, it does not affect the annual inspection of the vehicle, and there is no problem. The appearance of the motor vehicle should be neat and tidy, the parts should be intact, the connection should be fastened, and there should be no defects".

From the end of the 19th century to the beginning of the 20th century, automotive designers devoted their main energies to the development and innovation of automotive mechanical engineering. In the first half of the 20th century, after the basic structure of the car has been invented, automobile designers began to improve the external shape of the car, and successively introduced the concepts of aerodynamics, fluid mechanics, ergonomics and industrial styling design (industrial aesthetics), and strive to make the car can meet the different needs of people of all ages, all classes, and even various cultural backgrounds from the appearance, so that the car becomes the best performance image of the combination of real science and art, and finally reaches the most perfect state.

In ancient China, there was the word "sedan", which refers to a sedan chair drawn by a mule. When Western cars entered China in large numbers, it was when closed square cars became popular in the West. At that time, the shape of the car was similar to the "sedan" in ancient China, and it was as glorious as the "sedan".

As a result, people called the cars of that time sedans. The earliest appearance of the car, its body shape basically followed the form of the carriage, so it is called "horseless carriage" English name sedan refers to a kind of luxury carriage used by European nobles, not only decorated, but also enclosed, can prevent wind, rain and dust, and improve safety.

After the car was introduced to the United States in the 18th century, it was only available to wealthy people in a few large cities such as New York and Philadelphia. When Ford introduced the Model T in 1908, the body was changed from the original open type to a closed type, and its comfort and safety were greatly improved. Ford referred to his "enclosed car" as a sedan.

The famous Ford Model T is the standout of the horse-based cars.

In 1915, the Ford Motor Company of the United States produced a different kind of car from the horse model, which was similar to a large box and equipped with doors and windows, and people called this type of car "box car". Because the shape of this type of car resembles the "sedan chair" type light seat used by European ladies for group trips and other occasions, it is named "sedan" in the catalog.

In 1934, Professor Lei Yi of the Fluid Mechanics Research Center measured the air resistance of various car bodies using the method of model cars in wind tunnels, which was a historic test. In 1934, the Chrysler Corporation of the United States first adopted a streamlined body shape design.

In 1937, German design genius Fernand Porsche began designing cars that resembled the shape of a Beetle. Beetles can not only crawl on the ground, but also fly in the air, and their physical resistance is very small. Dr. Porsche maximized the strengths of the Beetle's shape, making the Volkswagen a masterpiece of streamlined cars of its time.

In the 20 years from the 30s of the 20th century when streamlined cars began to be popularized to the end of the 40s, it was the "first era" of Beetle cars.

In our annual inspection, the main test is to check whether the lights and brake system of the vehicle are qualified, as long as the appearance of the vehicle is not too serious, there is no problem, and whether there is a problem with the engine is not detected, so I think as long as the lights and brakes can pass.

There is no breakage and the damage is very serious, and it can be inspected annually.

It's not very run-down, it doesn't matter.

If it is more obvious, the car will not pass the review. It is recommended to go to the 4S shop for repair and maintenance.

The precautions for the annual inspection of automobiles are as follows:

1. Body appearance. If the vehicle is too dirty, it will affect the inspection of the appearance and chassis part, and the car inspection needs to be photographed, so it is too dirty for the inspector to not take pictures. There are also many car owners who are accustomed to putting some personalized stickers on the body or the logo of the car club.

Any car sticker or car mark, even if the area is small, is not allowed to pass the car inspection, but there are exceptions, such as "internship" signs and other legal car stickers that have been approved by the public security organs are allowed. In addition, cars that have been cosmetrically modified cannot pass the vehicle inspection. To put it simply, as long as it does not match the driving book, it is regarded as an appearance modification.

2. Triangular window film. According to the regulations, the glass film does not affect the car inspection, but the corner of the front window triangle window can not be filmed, here it is necessary to leave a good light transmittance for the driver to observe the rearview mirror on both sides to provide convenience, so once the film is pasted here, it will not be able to pass the car inspection.

3. Whether the insurance expires. The time of car inspection and the expiration of the insurance is a time, it should be noted that many friends have extended the insurance of the new year before the expiration of the insurance, and the old insurance may not expire when the car is inspected, and the new insurance has not yet taken effect, at this time you must bring the original policy that is still in effect, that is, the old policy to inspect the car, otherwise the insurance that has not taken effect can not pass the test.

4. Tire size. Under normal circumstances, the vehicle will face the replacement of tires for about 70,000 kilometers, at this time, many car owners will replace different brands, or more targeted functional tires to improve their different driving needs, it should be noted that the replaced tires must be exactly the same as the size and model of the original car, otherwise even if the wheel style remains unchanged, the model changes, and can not pass the car inspection.

5. Violations. If the violation is not cleared in time, although it can be detected by appearance, exhaust gas, etc., the final "inspection" word mark can only be received after the violation is processed.

If the car has a dent, whether the car can pass the trial depends on the degree of dentation. Under normal circumstances, small depressions can pass the annual inspection, because the annual inspection mainly detects the safety and modification of the car. However, if the dent is more obvious, the damage is relatively large, and the car cannot pass the review, and the staff will let the 4S shop do a good job of repair and maintenance, and then come back for inspection.

The following is an introduction to the annual audit of the vehicle: 1. Check whether the engine, chassis, body and its ancillary equipment are clean, complete, and whether the effective paint surface is uniform and beautiful, whether the main assemblies are replaced and whether they are consistent with the initial inspection records; 2. Check whether the braking, steering maneuverability, lights, exhaust and other safety performance of the vehicle are in accordance with the requirements"Technical conditions for the safe operation of motorized chasley vehicles""requirements; 3. Check whether the vehicle has been modified, modified, transformed, driving license, number plate, vehicle file, all registrations are consistent with the current vehicle condition, whether there is any change, and whether the approval and change procedures have been handled; 4. Whether the license plate, driving license and the enlarged words of the license plate printed on the car are damaged, altered and the handwriting is unclear, etc., whether they need to be replaced; 5. Whether the large car is spray-coded with Chinese characters on both sides of the door in accordance with the regulations, or the name of the street, township, town where the vehicle is located and the number of people in the cab is limited; Whether the outside of the rear tailgate of the truck (including the rear tailgate of the trailer) is sprayed according to the regulations, and whether the car number magnified by 2 or 3 times is sprayed on both sides of the car door of the individual or joint household""Individuals""Words. "

It's completely possible, a depression the size of a fist in the trunk, no paint damage, measured and inspected, coordinates Beijing. There are no examples of paint damage.

If there are small scratches on the body, it is recommended that you repair it, or find a scalper to pass. Personally, I don't think it's okay.

It depends on the severity of the scratches on the body, if it is only a very slight scratch, it can generally pass the annual inspection, if it is more serious, it is necessary to deal with the scratches first, and then inspect last year.

The circumstances that affect the annual inspection of vehicles are:

1. Add surrounding.

2. Body color.

3. The color of the glass sun film explosion-proof film should not be too dark (the items in the car can be seen clearly from one meter away; It mainly refers to noodle trucks and trucks, and it doesn't matter if you have a car with less than 5 seats).

4. Vans and trucks should have tail enlargement numbers.

5. The number of spring bow pieces cannot be increased or decreased.

6. The van seat can not be more or less, and there must be a fire extinguisher.

7. The van compartment can not be modified (can not open the side door, can not open the roof, can not add the tail plate) 8, the size of the tire can not be changed, the pattern of the coaxial tire should be the same 9, the vehicle has unprocessed traffic violations, or the vehicle is seized by the court, can not be reviewed annually.

You're talking about the kind of stickers that you practice, theoretically you don't need to tear them off, and as long as the area of the film or color change does not exceed 30% of the area of the vehicle, it is legal! But in the actual operation process, it is difficult to say, I have many friends who go to the car to review the external inspection to tear off, otherwise not to let it!