-
The dripping of the indoor unit of the air conditioner may be due to the following conditions:
1. The press touched the S-tube when it started.
2. The offset position of the fan causes it to rotate irregularly when it starts.
3. The installation is not firm.
If this is the case in recent days, there are several cases:
1. The blades are broken.
2. There is a bit of a problem with the chassis of the press.
3. The motor is broken.
If it is not the above situation, it is better to call the manufacturer to ask them to come to the door for inspection!
The whirring sound is the sound of the wind, and under the automatic wind speed, Gree will automatically adjust to the high, medium and low wind, and when the wind and air friction is large at high wind speed, it will make a whirring sound.
As long as the wind is not very loud, it is normal. Don't worry too much .
Air conditioner bearings lack lubrication, resistance and noise. Electric fans need to be maintained frequently, otherwise they will squeak, rust, wear out the bearings and even damage the motor.
You can use fully synthetic electric fan lubricants from Hotolube or Kluber. Fully synthetic base oil production, clear and transparent, colorless and odorless, low temperature resistance, no dust.
-
When the Gree air conditioner is in standby mode, two beeps are normal operation prompt sounds. This is the sound of the air conditioning system in order to remind the user that the air conditioner is operating normally. [Click to enter the official website to learn more].
Standby mode means that although the air conditioner is turned off, it still remains charged so that it can enter the working state at any time. In standby mode, the air conditioner will monitor the indoor temperature, and once the temperature exceeds the set turning on temperature, the air conditioner will automatically turn on and work.
The function of Didi is to remind the user that the air conditioning system is still in working condition, which is to remind the user that even if the air conditioner is not directly turned on, there are still some safety precautions to be paid attention to, such as not letting children and pets approach the air conditioner to avoid accidents.
If you feel that the sound of Didi is too loud or have other problems, it is recommended that you contact the after-sales service center of Gree Air Conditioner, and they will provide you with more detailed answers and solutions. Over the years, Gree Electric has continuously optimized the quality management system, innovated the quality control model, promoted the reengineering of the system process, and built a unique "Let the world fall in love with Made in China" Gree perfect quality management model, which effectively solves the problem of the path and method of quality innovation of the organization, and promotes the continuous improvement of the quality level of the enterprise. In 2018, Gree Electric won the 3rd China Quality Award for its adherence to quality.
-
Reasons for the ticking sound of the indoor unit of the air conditioner:1. When installing the air conditioner, forget to vacuum the pipeline;
2. The suspension of the machine is unstable and shaking;
3. The blades of the internal machine are rotten, and the friction with other parts inside produces a sound.
Purchase pointsA good air conditioner can last up to 10 years, and it is not low. Therefore, you must not be greedy for cheap air conditioners, and you must look at the quality of the product when you buy air conditioners
1 Whether to use a brand-name compressor, the compressor is the heart of the air conditioner, and a good heart is of course important.
2. Whether to use high-quality and high-efficiency heat exchangers, such as hydrophilic membrane trapezoidal aluminum sheets, internally threaded copper tubes, etc.
3. Whether to use unequal distance through the flow blade large wind wheel and stepper motor.
Drive the wind pendulum to achieve an ultra-quiet design.
-
If there is such an abnormal sound, first check the computer board of the indoor unit, and clean the filter of the indoor unit.
-
The dripping sound of the indoor unit of the Gree air conditioner may be in the following conditions:
1. The press touched the S-tube when it started.
2. The offset position of the fan causes it to rotate irregularly when it starts.
3. The installation is not firm.
If this is the case in recent days, there are several cases:
1. The blades are broken.
2. There is a bit of a problem with the chassis of the press.
3. The motor is broken.
These are just speculations, you better call the manufacturer after-sales service and ask them to come to the door for testing.
-
The reasons for the rattling sound of the indoor unit of the Gree air conditioner are:
1. Whether the filter screen is cleaned regularly, if the filter screen is too dirty, the air inlet is blocked, which will not only make the internal machine noisy, vibrate, low wind sound, and the wind speed can not be raised, but also when the outdoor ambient temperature is not too low, it will make the indoor unit evaporator overheat protection and frequent standby, generally about 10 minutes.
2. Whether the inner cover is tightly covered, sometimes the inner cover is not tightly covered after cleaning the filter screen or after cleaning, resulting in the vibration and sound of the air conditioner when working; When the air conditioner is just turned on, in order to make the room heat up (cool down) quickly, use the high-efficiency key, the indoor unit runs at high speed, the noise may be a little louder, and after working for a period of time, the air conditioner turns into normal operation, and the sound is naturally smaller.
3. It may be caused by improper installation.
4. The reason for the sudden change in temperature, in order to make the room heat up (cool down) quickly when the air conditioner is just turned on, use the high-efficiency key, the indoor unit runs at high speed, and the noise may be a little louder.
5. It is the sound of refrigerant flowing in the machine and the sound of freon reflux in the machine, which are normal sounds and not noise.
6. The gap between the piston and the cylinder wall is too large; The piston pin assembly is too tight or the connecting rod bearing is assembled too tightly; The gap between the tappet and its guide hole is too large; The profile of the valve cam is worn; Sometimes, the starter grip comes loose and the pulley makes a sound (noticeable when the speed changes).
7. The connecting rod bearing is loose, the bearing is melted or the size does not match and rotates; loose crankshaft bearing or bearing burning capacity; The piston pin is broken; The crankshaft is broken.
8. When the engine has abnormal noise, it will inevitably produce a certain degree of vibration, and the cause of abnormal noise can be assisted in diagnosing according to the characteristics and parts of vibration.
If the air conditioner is noisy, after eliminating the above reasons, the fault is still the same, you should find a professional maintenance personnel for maintenance.
-
The first point remote control reason:
1. The screen appears garbled or frozen. Press the reset button to disarm, or the battery is low.
2. The temperature is not displayed. In air supply or automatic mode, the remote control does not display the temperature.
3. If the receiving head is broken or cannot work normally due to moisture, check the transmission of the remote control signal. Use a digital camera (mobile phone is also available) to point at the transmitter port of the remote control, and press any button on the remote control to see if there is an infrared signal emitted.
4. The remote control mode is incorrect, or the temperature setting does not meet the boot conditions. When cooling, the set temperature should be less than the indoor temperature, and when heating, the set temperature should be greater than the indoor temperature.
5. The battery of the remote control is low, which will cause the remote control distance to be short or unable to be remotely controlled. It is recommended to remove the remote control battery when the air conditioner is not in use, and reinstall or replace it when in use.
The second point is the power reason:
1. The power supply is not connected or out of power, the power conductor socket is not in good contact, or the power conductor wire diameter is thin or aging.
2. The power supply voltage is low. Starting voltage of fixed-frequency air conditioner: 187V, voltage fluctuation range: 198-242V, starting voltage of inverter air conditioner: 156V, voltage fluctuation range: 176-264V, it is recommended to install a voltage regulator at home.
The third point of protection function:
1. Delay protection. In order to protect the life of the press, a protection circuit is designed in the control circuit of the air conditioner computer board, and the press is started after a delay of 3 minutes.
2. Prevent heating and cold air. When the air conditioner is heating, when the temperature of the indoor unit coil is lower than a certain value, the internal unit does not run, and generally after 3-5 minutes of preheating, the internal unit starts to work.
3. The computer program of the air conditioner is chaotic, which makes the machine unable to work immediately.
4. Function lock protection. Some brands or models have a child lock function, if you are in lock mode and cannot perform any operation, you can refer to the manual to cancel.
For more information, please contact us.
-
1. Check whether the remote control is faulty.
Normally, the air conditioner does not respond when it is powered on, it is likely that the air conditioner remote control is damaged, at this time, you can carefully check the air conditioner remote control, if the remote control can turn on the air conditioner at this time, it proves that it is not a problem with the remote control. If the remote control can't turn on the air conditioner, then press the manual power button of the air conditioner, if it still can't turn on, it proves that there is a problem with the connection between the power button and the motherboard.
2. Voltage problem.
The air conditioner does not respond instantaneously after powering on, it may also be a problem with the voltage at home, and all kinds of large household appliances are frequently used in summer, which is likely to cause the voltage overload operation and unstable situation at home, which in turn affects the normal use of the air conditioner. At this time, you can ask a professional air conditioner master to check the voltage problem.
3. Check whether the refrigerant is used up.
In the case that the air conditioner does not respond after powering on, in addition to checking whether the circuit can be short-circuited, it is also necessary to check whether the air conditioner refrigerant is used up. If it is determined that the air conditioner cannot operate due to lack of refrigerant, then you need to buy refrigerant and add it yourself.
-
If the indoor unit has a clicking sound similar to a mechanical timer, and it continues, it is likely to be an installation problem, at this time, press the shell of the indoor unit of the air conditioner with your hand, and the sound is reduced or disappears, indicating that the installation base plate of the indoor unit is not well attached to the wall, or the wall is uneven.
It is necessary to close the bottom plate to the wall, or to trim the wall flat, so that the indoor unit of the air conditioner and the wall are tightly fitted to solve the problem.
If the air conditioner has an abnormal noise, it can be dealt with according to the following methods:
1. Listen to the sound: judge whether it is from the internal or external unit of the air conditioner, the compressor is generally the sound of vibration, and the fan is generally the sound of the wind, find the source of the abnormal sound, and deal with it accordingly.
2. Touch the outside of the air conditioner with your hands: If you feel the vibration is strong, it means that the air conditioner is loose, and you can check whether the air conditioner screws are fixed firmly.
3. Check whether there is dust or foreign matter on the evaporator: if there is, it should be cleaned, rinsed with clean water, and if it will not be disassembled, you can ask a special person to clean it.
4. Compressor damage: It is recommended to contact the local service provider on the manual directly and replace it.
-
Gree air conditioner dripping non-stop screen display is also continuous flashing Hello dear, the air conditioner always dripping, it should be the main control board of the air conditioner emergency switch failure. 2. Air conditioning is the process of manually adjusting and controlling the temperature, humidity, cleanliness and speed parameters of the ambient air in a building or structure. These devices typically include most of the cold and heat source equipment, cold source heat distribution systems, terminal equipment, and other auxiliary equipment.
It mainly includes water pumps, fans, and ductwork. The terminal is responsible for using the supplied heat and cold to treat the air specifically so that the air parameters of the target environment meet the requirements. The bearings in the wind turbine motor are worn out, and only the bearings need to be replaced.
3. The drainage pipe is blocked or foreign matter accumulates, resulting in poor drainage, and the water generated by the indoor unit cannot be counted, which will also cause the alarm to drip sound. Fourth, press the remote control and it will ring, and it will also tick. Fifth, it may be the reason for the refrigeration of the machine, the lack of refrigerant, etc., will also alarm dripping, affecting our use effect.
Sixth, it may be the cause of the current that causes the air conditioner to make a ticking sound, and it is recommended to remove the power plug from the stove, and then turn on the machine to try how the effect is. I hope I can help you! If my answer is helpful to you, please give a thumbs up (comment in the lower left corner), look forward to your like, your efforts are very important to me, your support is also the motivation for my progress, and finally I wish you good health and a happy mood!
The high standby power consumption is the power consumption of the control board. >>>More
E and K generation ** force air conditioners are different series. where K is the charm series, and E is the new Qingfeng series.
For those commonly used modes on the remote control of Gree air conditioner, especially the cooling mode and heating mode, we are no longer familiar with it, using the cooling mode in summer and the heating mode in winter. Everyone is no stranger to snowflakes and the sun, the snowflakes represent the cooling mode, and the sun represents the heating mode. There are also water droplets that represent the dehumidification mode, which needs to be practical in spring and autumn when the indoor humidity is too high. >>>More
Everyone knows that the air conditioner is controlled by the remote control, and if you are not careful, you will press the wrong button, and the air conditioner remote control will generally have a lock button function to prevent accidental contact and change the operating status of the air conditioner. I don't know if you have encountered the phenomenon of air conditioning being locked in the use of air conditioning, if you encounter this phenomenon of air conditioning locking, how should we solve it? The following will introduce to you the method of air conditioner unlocking, and after learning the method of air conditioner unlocking, you can unlock the air conditioner by yourself. >>>More
Gree air conditioner heating mode is not.
The causes and solutions of heating are as follows: >>>More