Why can t the car get into the water The water in the car can t find the reason?

The whole car has been treated with anti-rust treatment, and if you get water from the inside, it will start to deteriorate from the internal materials of the car. And the car can't get into the water when it's started.

Water inlet means that the water enters the air intake of the engine, and the cylinder is dead when the water enters the cylinder.

If the engine is soaked, it is best not to turn it on, because the car may have a circuit failure after soaking in water.

Go to the 4S shop to clean the vehicle after driving through the stagnant water and rain, because the rain has a certain corrosiveness, although the car will spray some anti-corrosion materials on the car body and ZD chassis during the production and manufacturing process, but the long-term invasion and soaking will cause serious corrosion to the vehicle chassis, and it must be cleaned with fresh water.

Serious wading refers to the vehicle driving into the waterlogged road section, due to the engine water or exhaust pipe water after causing the ignition in the water, regardless of whether the vehicle has a second start, whether there is a whole vehicle power failure, it is serious wading.

In the alternating season of summer and autumn, it can be said that there are frequent rains and typhoons, and the most feared thing for vehicles is that the car will be flooded when it is not driving.

For the problems related to the flooded car, many prospective car owners or new car owners are very worried and worried about such a problem, in fact, there is no need to worry about this situation, when the car is flooded, you should avoid the second start, even if the water recedes, it is necessary to prevent a little is to avoid starting.

Because once started, it will inevitably cause the vehicle's engine to be bent off due to water problems, resulting in the circuit will be on fire due to poor contact, so for the car, even if the water recedes, it cannot be started, first of all, the water will enter the car, and secondly, the computer in the car.

Even the exhaust pipe has been inside the engine will have the phenomenon of water ingress, after the water recedes, it is necessary to replace the engine oil, spark plugs and even various parts, etc., only in this way can other accidents be avoided.

Don't start again. Disassemble the flower plug to start draining, install the spark plug and try to start. The engine cannot be forced to start after water ingress, and the water cannot be compressed in the cylinder to prevent the connecting rod from deformation.

The intake duct needs to be cleaned. Air grid. Remove the spark plug, hit the motor, and drain the water in the tank!

If the vehicle is wading in water, and the water has already overflowed the door and entered the car, then your car is already soaked. This is when you need to determine one thing: whether the mechanical parts of the vehicle are still in working order.

If the car can be driven without any faults, then the water in the car must be dealt with first. This is done by removing the floor mats from the interior of the car until the steel plate under the car is exposed. There will be drainage holes on the steel plate under the car, and after draining all the accumulated water, wipe the bottom plate.

Then it is necessary to strengthen the ventilation of the interior of the car for a period of time, and you can also place a bag of lime powder to absorb moisture.

1. Remove the negative wire of the battery as soon as possible to avoid short circuits caused by water ingress in various electrical appliances on the car.

2. Check the engine immediately, first check whether there is water in the engine cylinder, which will cause the connecting rod to be bent and damage the engine.

3. Check whether there is water in the oil, which will cause the oil to deteriorate, lose its lubrication effect, and make the engine wear excessively.

4. Check whether the gearbox is flooded, and the gearbox water will cause the gear oil in the gearbox to deteriorate, resulting in gear wear.

5. Check the brake oil, the water in the brake oil will deteriorate the brake oil, resulting in brake failure.

6. If water enters the exhaust pipe, the stagnant water should be removed as soon as possible to avoid impurities in the water blocking the three-way catalytic converter or damaging the oxygen sensor.

7. Check whether the battery is full of water, and replace the electrolyte if necessary.

8. The automatic transmission car should check whether the automatic transmission and the transmission control computer are flooded.

9. Dry the soaked items (seat covers, floor mats, etc.) in the car as soon as possible to avoid mold.

If the vehicle has been blistered, it is recommended not to drive or use it again. Be sure to use it after inspection and repair. According to the different time of the vehicle soaking in water, it can be divided into the following situations:

1. In the process of using the car, if there is water soaking. Depending on the degree of immersion of the vehicle, if the vehicle has entered the vehicle or the vehicle is in a very high position. In this case, be sure not to move the vehicle when entering the vehicle. The vehicle needs to be towed to the maintenance facility for inspection and repair as soon as possible;

2. If the vehicle is driving on a wading road and stops at the time or is blistered, it must not be driven. The repair facility should be contacted immediately for processing. Because the biggest reason for this situation is that the water has passed through the intake system of the engine, and has seriously entered the combustion chamber of the engine, resulting in the flameout.

If you continue to drive or start the vehicle, there is a high chance that the engine will be damaged.

The car can not be used immediately after being flooded, and the whole car line needs to be overhauled, and due to water ingress in many places after wading, it may affect the performance of some parts of the car, which can seriously cause the car to not be able to open normally.

First of all, we need to check the circuit, because turbid rainwater is the best conductor, and the circuit is very likely to cause a short circuit when it encounters water. The second is to check whether the braking system is flooded, because the braking system has a very strong adsorption force, the rain is very easy to enter the brake fluid, which will affect the braking effect, and may seriously cause brake failure and cause accidents.

If it is immersed in a water level of more than 30 cm for a long time, it may cause harm to the circuit board in the car, and the water immersion will cause damage to the bus, wiring harness interface, computer module and circuit part, and the module operation will be distorted after the circuit is oxidized, and it needs to be replaced.

For vehicles with a water immersion depth of more than 50 cm, all kinds of hidden dangers can only be eliminated by replacing all electrical appliances and circuits.

If all or most of the whole vehicle is flooded, it is necessary to comprehensively disassemble, clean, and dry the seats and carpets of the whole car in the 4S shop, as well as overhaul the electrical appliances and wiring of the whole car.

Hello, the car is flooded, that is, to drain the water in time, and then check whether it can be used normally.

If the car is flooded, you can clean the water in the water wheel and release it, if it can start, it means that the car is not damaged, and it can be used normally, if your bike has not been able to start, it means that it needs to be repaired.

What should I do if my car gets into water? Does it work? If the car is flooded, it must not be used normally. Because the engine is flooded. A second start can cause serious damage to the engine.

The car is flooded and cannot be used normally. It must go through a regular repair department. Carry out a major overhaul and thoroughly clean the car from the water. Change the oil, petrol or diesel in the car, only then do you install it from scratch. before it can be used normally.

If the car is flooded, it is necessary to take a picture of the water in time, and then check whether it can be used normally.

If the engine is flooded, remember not to ignite immediately, and the engine will not damage the engine if it is cleaned up and then ignited.

I don't know what kind of situation you are talking about when this kind of car goes in and out, is it the kind of water that wants to be bigger? If it's a soaking truck, there is really a high probability that there will be a problem, and if it's just a little bit of water on a rainy day, it doesn't matter if you do a good sealing treatment.

The car can not be used normally if it is flooded, and it can not be ignited after the water is entered, and the engine will be burned out if it is ignited again.

Regarding the issue of insurance compensation, there are two types of insurance related to vehicle wading, one is the most common car damage insurance, and the other is called engine special loss insurance, commonly known as wading insurance. Among them, the scope of application of wading insurance is small, generally due to the various expenses incurred by the engine entering the water under normal driving conditions, provided that the engine must not try to start the vehicle after the water penetrates, but there are still relatively few people on the wading insurance.

The car machine got into the water. Be sure not to use it right away. It can only be used normally after the water has dried.

It may be caused by turning on the air conditioner, especially when the external circulation is opened, the hot air outside combines with the cold air in the car to form water droplets, and water will generally flow out at the air conditioning filter outlet.

If you can't see any problems on the outside, go to the 4S store to check it, it may be that the sunroof is blocked, or the air conditioner drain is broken, there are many reasons to check it well!!

In general, there are three types of reasons why water ingress is more common in cars. Category 1: Sunroof sewer blockage or sunroof door seals are not tightly sealed. The second type of vehicle chassis is blocked by rubber seals, and when wading in the water, it will enter a part of the rainwater, and the third category.

Summary. Hello, I am happy to answer for you your car master exclusive technician concentrate on the heart and sincerely answer your car questions, for you to find solutions and methods to ask questions, the car engine water is not able to hit the car, after the water enters the cylinder, because the water can not be compressed, when the engine runs the piston up, the water is not compressible, if you force the car will cause the connecting rod to bend, resulting in engine damage. Whether the automatic transmission vehicle is D, R or N, as long as it is pushed by external force, it can move, but the P gear cannot move.

Hello, I'm helping you sort out the answer to your question, please wait a while Why is it still in D gear when the engine of the automatic transmission is damaged by water ingress.

You can still walk with people pushing.

Hello, I am very happy to answer for you Your car master exclusive technician concentrate on your heart and sincerely answer your car questions, for you to find solutions and methods to ask questions, car engine water is not a taxi, after the water enters the cylinder, because the water can not be compressed, when the engine runs the piston up, the water can not be compressed, if you force the car will cause the connecting rod to bend, resulting in damage to the motive of the silver change. Whether the automatic transmission vehicle is D gear, R gear front pin or N gear, only the beam can be moved if pushed by external force, but the P gear cannot be moved.

If it refers to the water intake in the car, it does not matter much, but if it is a chassis engine, the water intake is very large.

If there is water in the car, simply remove all the water inlet areas and dry them directly in the sun. At the same time, it is necessary to keep the room ventilated. If it is designed for a production line, it is best to retest the production line in a 4S store.

However, if the chassis engine is flooded (i.e., wading, most of the wading positions are in one-third of the tire, even if it is Zheng Qingqiao's wading car), the relationship is very large, and it may cause engine failure, short circuit, drive system damage, etc. These reasons are related to the degree of damage to the car after the motor vehicle is soaked in water, the height of the water, and the immersion time.

Because today's cars are basically composed of a wide variety of electronic equipment, unless it is a special car (professional off-road vehicle, military vehicle), the electronic equipment on the car is rarely waterproof, shouting keys, so the water in the car is easy to cause a short circuit and burn out the line.

At the same time, the ignition of the engine is also adjusted according to various electronic components of the differential shed. If there is a problem with the sensors on the engine. The engine cannot be ignited normally, and there is a risk of spontaneous combustion.

And if the engine gets water (or the oil pan gets water, and the oil pan directly under the engine is filled with gasoline), only a major overhaul of the engine can be carried out.

After the car is soaked in water, it will cause great damage to the car, so you should immediately go to the car repair network to deal with it.

Millions of car purchase subsidies.

If Huai Zheng is properly handled, the car can still be driven normally in the future: 1. During the wading process of the vehicle, if the engine is turned off, the double flash should be pressed immediately, the engine should be turned off and the key door should be closed. Do not try to start the engine again, because starting the engine again is very easy to cause fatal damage to the engine, and Cong Tan This kind of man-made secondary damage to the engine, whether it is car damage insurance or wading insurance, will not be claimed;

2. If the vehicle is soaked in water when the basement or parking lot is stationary, the vehicle should be locked with the lead family, do not try to start the engine, and try to seal the vehicle;

3. Move the vehicle to a high place as much as possible to minimize the damage to the vehicle caused by stagnant water. If the water flow is large and the water is deep, the owner should first ensure his personal safety and call a professional rescue team in a safe area on higher ground to rescue the vehicle;

4. Do not stay in the car soaked in water, after the vehicle is soaked in water and turned off, the car is the most unsafe, if the water level rises quickly, the door switch is blocked, after the vehicle is powered off, the occupants will be trapped in the car and suffocated;

5. After the vehicle is sent to the 4S store, a comprehensive wading fault detection should be done, and the water-related fault points mentioned above should be investigated one by one to avoid hidden dangers threatening future driving safety.

Millions of car purchase subsidies.