Can the computer trick machine be restored to factory settings?

Zuqi pattern machine to restore factory settings: press 8 to turn on, and then press 1 to select"221dss-dhs-5000"After that, press Enter, press 2, 8 number keys to select 039, press left and right expansion keys to press 2, press enter keys twice, press 2, 8 to select 064, press the bottom line count key to press 2, press enter twice, press power off, and you're good to go.

Re-set the parameters, and then save them after playing the board.

Hello,I also pressed the factory reset settings.,Now I can't the board.,May I ask God.,How do I operate to recover?

Hello, the factory reset method is as follows:

1. Before booting into the system, press F8 to enter the advanced boot options of Windows 7 and select "Repair Computer".

2. Select the keyboard input method.

3. If there is an administrator password, you need to enter it; If you don't have a password, just "OK".

4. Once you are in the System Recovery option, select "Dell DataSafe Restore and Emergency Backup".

6. Select "Restore My Computer" and click "Next".

7. After selecting the correct factory image, click "Next" to start restoring the system to the factory state.

Note that the notebook needs to be connected to an adapter during the recovery process. When you're done, restart your computer.

In the case of determining that the power plug is plugged in, check whether the power switch is excellent touch, whether the fuse on the power board is blown out, assuming that the above two items are good, that is, the 15W 20N cement resistance on the power board is damaged, just replace a resistor with an appropriate resistance value. The circuit board with small cement resistance value is stingy and easily damaged by the impact of large current, and the circuit board with excessive resistance value is recommended to be slow when starting.

This should be that the sensor cannot sense the origin, to the left is generally the X sensor has a problem, it is recommended to check whether the sensor is good.

E-01 disk has no pattern.

e-02 Disk is bad or no disk.

E-03 disk type is unknown.

e—04 write-protected or diskless.

e-05 The disk directory is full.

E-06 disk space is insufficient.

e-07 format failed.

e-08 has no correct input, or the output times out for 2 seconds, and the pattern end code e-11 is not read

Drive before the function confirmation light is on.

E-12 backs off.

E-14 data processing board content is partially lost.

E-15 mechanical control board content part of the loss.

There is no pattern in the memory of the E-16 computer embroidery machine.

The E-17 computer has run out of pattern numbers.

The E-18 pattern does not exist.

E-19 does not have enough memory.

The parking position of E-51 is abnormal.

E-52 embroidery frame exceeds the limit.

E-53 stepper motor over-current protection.

E-54 color change exceeds the limit.

e-55 color change timeout.

E-56 color change semi-rotation abnormality.

E-57 needle position is abnormal.

E-58 main motor timeout.

E-59 main motor reverse.

E-60 main motor reverse.