I just learned how to spray why the old master of running against the wall, please tell me

Problems with continuous spraying;

Don't go fast when practicing spraying, you can spray it slowly.

The way to increase the speed is: press the time a little longer, +s tap to remember, the main thing is to be even

Even squirt fingering. C type D type.

Continuous spray double spray link spray fingering.

Novices are more likely to slip when learning to spray for the following reasons:

3. The rhythm is wrong.

The reason for hitting the wall is: the angle is not good, the head of the car is too slow, and it is not suitable to use even spray!

Of course, more practice is the best answer.

But if you pay attention, you should pay attention to the front when spraying, that is, the front of the car is not facing the wall. It turns out that when drifting, it is estimated that you are drifting with the front of the car against the wall, floating in the shortest distance. But even spraying has to be a little more distancing.

Try more.

Find a place without a wall to practice, so when will you learn to practice the edge?

I'll tell you the most common mistake newbies make:

1. In the case that the bend is not sharp and very long, (the second and third bends at high speed) the continuous spray speed is too fast.

2. The best angle into the bend was not found.

3. The first drift is not optimized enough to cause the speed to be too slow.

The key depends on the feeling, if you can't rush it, slowly get used to it, and slowly find the feeling.

Also pay attention to the optimization drift. Pay attention to the angle of the corner. The curved wheel that is too sharp should be a little narrower. Gentler bends are the opposite.

Find a place where there are no walls to practice.

Friend: I practiced for a month while I was spraying repeatedly.

Maybe people think I'm stupid.

But my efforts paid off

First of all, you should practice being able to connect the spray, don't deliberately pursue the angle, that will only make you go farther and farther, and wait for your spray to connect, and then pursue the angle of the spray, and the time difference between the two sprays, and the key point is to optimize the flow, which is also very important, the optimization of the flow, can allow you to go the longest in the shortest time, this needs to be honed by yourself, and you will not succeed without time

If you are not familiar with spraying, first rush the outer ring to start practicing, the technique is good in a little bit to the inner circle of the float, the technique is good in the inner circle of the spray, when the time is absolutely not hit, I used to practice spraying the outer circle little by little to learn to float inside!

First of all, you have to master the angle of entering the corner, this is very important, related to the continuous spitfire behind, in fact, the spitfire should be fast and rhythmic, more detailed you can go to the forum of running and running, where there are many masters to sum up experience.

The basis of continuous spraying is optimization, under the premise of optimization proficiency, contact continuous spraying, pay attention to the angle of pulling the head of the car when connecting, and pay attention to the coherence at the same time, and the feeling of the head of the car should be like the feeling of using the optimization to do the welt.

The angle of the float should be reduced as much as possible, and the speed of spraying should be accelerated.

The speed of the spray should be accelerated.

C-type continuous spray (horizontal continuous spray): This continuous spike mountain spray is the easiest to practice continuous spraying C-type continuous spray fingering: 1

shift (first drift) 2Pull back the head of the car ) step must be fast! 3.

shift ( second drift attention!) Here is not pressed ) 4.+ The first time you breathe fire, you must press first and then press ) 5.

shift 6+ The second Spitfire, must be pressed first and then pressed ) 7.The third spray guesses the middle fire ) D type continuous spray (oblique continuous spray):

Fingering of D-style spraying: 1shift (first drift) 2

Pull back the head of the car ) step must be fast! 3.shift ( second drift attention!)

Here is not pressed ) 4.For the first time to breathe fire, you must press the ) at the same time. 5.shift 6

For the second time you breathe fire, you must press the ) at the same time. 7.The third Spitfire ) Practice a lot to familiarize yourself with the track First of all, you must know that the sword Zen Sui will be sharp only after being honed.

1.The first is to press shift to enter the normal drift state (minimum seconds!). Same at once! ）

2.The second is to let go and shift to build. Press and straighten the front of the car (note: the first part can not let go of the accelerator to build).

3.At the end of the drift (that is, when the drift track is disconnected and the white light under the wheel table disappears), immediately release the throttle, and then press it immediately to complete a continuous spray!

Double spray method: 1Press shift to enter the normal drift state.

2.Straighten the front of the car (the first part can not let go of the accelerator).

3.Release the throttle and press only the two SHIFT keys to perform a second drift (note: this step is more critical!). If you press the throttle, it will lead to a premature fire-breathing! ）

4.I straighten the front of the car and breathe fire!

5.Let go, then quickly press for a second firethrow! (This step is similar to the fire-breathing step when spraying!) —Double spray complete.

Let me give you a brief explanation.

It is to float past the first time (when the second time is approaching) first click the arrow key, and then press the key. Be fast. Be fast. If it's slow, it's too big.

Double Squirt:

1.Press shift to enter the normal drift state.

2.Release and then [do not move], and straighten the front of the car (the first part cannot let go of the accelerator).

3.Release the throttle and press only the two SHIFT keys to perform a second drift (note: this step is more critical!). If you press the throttle, you can.

This can lead to a premature fire-breathing.

4.I straighten the front of the car and breathe fire!

Note: This is not about seconds between this and the previous step].

5.Let go, then quickly press for a second firethrow! [release and press the second]! Double Squirt:

Introduction: Lian Piao is to play the drift skills to the highest level. With the use of the continuous drift, it is possible to drift through the forest hairpin at a few small angles.

Large-angle corners, and can quickly accumulate N2O, so that you can really experience the joy of drifting! But there is a caveat!

Method:1It's still the same as before, press shift first to enter the normal first drift state.

2.Get on the right track! (Medium Don't let go!) ）

3.Press Shift to perform the first fire-breathing and start the second drift!

4.Get on the right track! (Don't let go either!)

5.Shift for a second fire-breathing and a third drift!

The third Spitfire.

The fourth drift ......[You're still breathing fire in the middle of the ticket].

In this way, a continuous spray is formed! It should be noted that the interval between steps 3 and 5 and shift is about a cabinet second. It's no different from pressing together!

Repeat 4 and 5 when you're done....Keep repeating! It's just a fake spray!

Many friends reflect that "when you are floating, you can't spray it like a master for a short distance", but it is actually very simple, but it is a spray first. Then a short drift and a fire-breathing! ～～

Some people said, "Yes, yes, but it won't hit the wall, and it won't hit it in a row." This is very simple, and students who will pay special attention to this.

Let's talk about the small medium u first; Because the little U can't be sprayed continuously.

The angle of one vote is 'about' about 26 degrees.

Spray once and then spray continuously.

The forward time is about a second less than that in the reverse.

Forward is not a matter of whether you have a reverse angle or a positive angle] for example.

'It's the opposite angle'<'

That is, positive angles.

Let's talk about U, the angle of one vote is about 22 degrees. Remember, the base degree reversal should refer to "Seconds" by multi-point. No short spray is required, direct spraying.

Big U,1 vote about 18 degrees,And then spray],

Spray 1+shift (optimized drift).

2.back direction).

3.+shift (two-key tap, the shorter the better)4+ Immediately return to the direction and breathe fire).

5.→+shift

.Repeat 3 or 4 steps.

Finally (continuous spraying is the continuation of double spraying, double spraying repeatedly).

Thank you for adopting. ^_

o W., 2008-07-29