FC GA 8TX Motherboard How to Wiring and Jumper Power Switch Wiring 5

There are English abbreviations on the motherboard, two wires when the computer switches and switches the button, and the corresponding needle on the motherboard is power restart

HDD light hddled

Speaker speaker

On the motherboard, it is all abbreviated in English, and it will definitely be no problem to follow this connection.

Teach you a general method (hehe, you can also go to repair after learning!) Don't connect the hard disk first, connect the power supply, and then use scissors or screwdrivers to short the two adjacent skipping stitches, and the two that can be turned on are connected to the power switch. Then use this method to find out the two that restart, and the rest is the power supply, hard disk LED light and speak, these three are not important, if you are sure that you want to connect it, you have to try again.

If the motherboard is not 486 class (I guess it won't be, the last one is all PCI slots, so no matter how old it is, it won't be much older). There will be relevant wiring instructions in the empty space on the motherboard, so look carefully.

Don't worry, it won't be bad, at most you can't turn on the wrong phone.

PWRBTN is connected to Power SW (power switch) and PLED is connected to Power LED (power light).

HDLED connected to Hddled (hard disk light).

Reset is connected to reset sw

Assembling a computer, motherboard power cord connection skills.

Just on the corner of the motherboard, the JFP1 pin, as shown in the red box below.

The interpolation is as follows:

There is a row of sockets below.

Power on switch Power SW

Reset Restart switch: reset sw

Power indicator: +-

Hard drive status indicator: HDD LED

Alarm: Speaker

1. Commonly used 9-pin boot wire connection.

2. Commonly used 20-pin boot wire connection.

Install it according to the letter next to the socket on the motherboard, which corresponds to the letter on the plug.

Various motherboard models are different. But the wiring of the motherboard is marked, like the power button, power indicator, hard disk indicator, reset key, etc., these motherboards are marked, it really won't, you just connect 1 group of 1, first see that the power button is on the motherboard, and then find out the power key plug on the chassis, plug it in, 1 by 1 are connected, rest assured that there is no big problem with the wrong connection, the motherboard is protected.

Be careful, these plugs are very small, and some have positive and negative poles, but they are all marked on the motherboard.

You look carefully at the port you want to wire, and there are English instructions on the side.

810 is from the boss, generally look at the motherboard has a mark!

Well, I'm going to go to a place where the computer is repaired, or a related company.

Look at the printed circuit of the PCB board, and then use a multimeter to measure the shortness, and check the voltage to know the same.