How long was the break in period for Fox? 10

Usually 3000 kilometers for the first insurance, after the first insurance every 5000 kilometers to change the oil. The problem of quality during the run-in period is straightforward. However, during the run-in period, the speed should not be higher than 80km h, and it is best not to accelerate sharply, and it is best not to brake suddenly.

Tips: Don't pull any car at high speed The run-in period is generally 5000 kilometers, but practice has proved that 7000 kilometers is considered the run-in period The run-in quality is not very good to detect As long as you are within these 7000 kilometers, don't often run at high speed, don't be fully loaded, don't always turn off, don't brake suddenly, it's OK

No matter how many times I said it, no one believed it... Now the process of automobile production can ensure the degree of coordination, and there is no need to run in like the previous cars.

In the past, the number of miles that a gallon could run before and after the car was run in could be three or four miles, which means that the engine clearance was not well run in at the beginning, and a lot of energy was wasted on friction. The difference between the miles before and after the current car "running-in" is less than half, which also shows that the cooperation of the engine has been done well enough when it leaves the factory, and there is no need to go through the so-called "running-in".

Now the new big-brand cars that need to be run in are just brake skins. Disc brakes don't even have to run in.

How many times have I said this "new common sense" and no one believes it, it's really frustrating... I'm here in the United States, and I've never seen anyone buy a new car and run in...

Many old drivers think that the new car should be run in at high speed, otherwise it will affect the performance of the car in the future!

Actually, this is misleading!

In the past, due to the limitations of the engine manufacturing process, the precision of machining was not high enough! Therefore, there needs to be a break-in process between the various parts of the engine! But now the machining technology has been greatly improved!

It can fully meet the operation between various parts of the engine. But many old drivers still use the old set in their new cars. thinks that the new car must be run-in, and the novice has a blind superstition because he does not understand the car.

Therefore, the so-called new car must go to Lala Expressway to a certain number of kilometers, in fact, it is dangerous and damaging to the car!

The car is just a means of transportation, as long as you drive normally, there is no run-in problem! In order to run in, looking at the tachometer every day, long-term low-speed driving is not safe and bad for the engine!

The run-in period is 5000 km. Before the end of the run-in period, pull the high speed for about 1 hour.

Change the whole car oil for 2000km below 60, change the flush once 90-100, and then keep driving below 80 to 5000km

After 5000km, it's OK to break the meter once you break it, hehe, don't try it if the technique is not good for the last time.

4s says 3000 km run-in and then go on the high speed to pull it, but it is best to do the first oil change at 2500 is to do the first oil filter.

After 3000 to the first insurance, you can open it casually after 5000!

If the Focus is well maintained, it can be driven all the time, and it will be no problem to drive for more than ten or even fifteen years, and 60w kilometers will be no problem.

The new Focus was launched in November 2018 and is equipped with two engines, and in terms of appearance, the new Focus adopts a new family design, with a large number of black parts in the center grille, sports bumper and rear spoiler, and the new car is equipped with two-tone 18-inch wheels. Its LED headlights have a sharp shape, and the L-shaped daytime running lights are particularly eye-catching. The rear of the car is fuller than the current model, and the LED taillights display effect is very eye-catching.

Fox interior, the center console design has a stronger three-dimensional sense, the floating 8-inch central control screen is quite eye-catching, and it is equipped with the Sync 3 multi** system, which supports CarPlay and CarLife functions. Powered, it's mated to an eight-speed automatic gearbox and offers three driving modes.

Introducing the 2021 model year

On July 11, 2019, Changan Ford's new generation Ford Focus 2020 model was officially launched, with a manufacturer's suggested retail price of 10,000 yuan. The 2020 model of the new generation Ford Focus has been upgraded in appearance and configuration, and all models meet the China VI emission standard. At the same time, the new generation Ford Focus 2020 model also provides a five-year or 200,000 km engine ultra-long warranty policy.

On August 16, 2019, Changan Ford Focus ACTIVE was officially launched with a price of 10,000 yuan. As a crossover model based on the new Ford Focus hatchback, the Ford Focus Active adds a more dynamic body package to the Ford Focus hatchback, and the power is the same as the hatchback Focus, still equipped with one engine.

Changan Ford Focus was launched at the Guangzhou Auto Show on November 20, 2020, and the all-new Ford Focus family with the SYNC + Zhixing infotainment system and the Danish national treasure B&O luxury audio system, with digital as the core, uses the Ford Focus to highlight the true personality and attitude of the new Pan 95 post-95, bringing more fresh fun that makes life unlimited and life more faceted.

Today's car technology is not like before, if it is well maintained, it can be driven all the time, from the country has not implemented mandatory scrapping of private cars.

I don't know how many years the Focus can be driven, because the domestic production has been on the market since 06, but 8 years have passed, and the 06 Focus is still running normally on the road, don't worry.

My 06 years automatic.

Fox is 15 years old. Ready to do it for another 5 years. There's nothing wrong with the car.

I've been a manual transmission car for 10 years, and now it's 11 years.

It depends on how you drive, if you drive well, you can drive up to 6o thousand kilometers and be scrapped.

Normal opening and normal maintenance, 10 years can still be opened normally.

If it is well maintained, it can be driven for about 60w kilometers.

with a run-in period.

Generally, it is between 2500 and 3000 kilometers, and the speed of the car is controlled at about 2500 rpm during the run-in period, which is the basic mileage to ensure the full contact, friction and adaptation of all parts. Run-in is not only a run-in of the engine, but also a comprehensive process of grinding the gearbox, grinding the steering, and grinding the brakes. The gearbox is an important link in the run-in after the engine.

Fox Features:

The interior style is also very much in line with my heart, it can be said that it is both inside and outside, and the comfort of Xiaofuzi is really good, and the power and handling are of course to be boasted of.

The handling is very good, the direction is quite light, it's nothing more than that I'm a man, the interior materials are good, the design is also very high-end, the configuration is very high, and it's not expensive.

In addition, the interior of the whole car is very practical, and I like the style very much, it looks very high-grade, the materials are also very particular, and the power of this car is excellent, and the handling performance is very reliable.

The Ford Focus has a run-in period of 3,000 km. Because the work of new automobile machinery and equipment is not comfortable enough, resulting in unsatisfactory friction of metal materials and a slight shaking feeling of shifting. Car buyers must keep the following common questions in mind.

1. Do not brake urgently.

Emergency braking damages the braking system that is in the run-in period, and at the same time harms its own safety.

2. The loading should not be too heavy.

The load quality of the automobile exceeds the fixed value of the simplified model, and the fuel or electricity consumption is aggravated, which is also likely to lead to the rupture of cylinder components and automobile leaf springs. The cross-sectional quality of the vehicle cannot exceed 70% of the required load capacity.

3. Prevent long-term and long-term load driving.

Long-term high-speed rotation driving will increase the load on the engine and the impact of its transmission shifting. The engine speed ratio is proposed to be kept within 3000r min.

4. Apply high-quality fuel.

The application of fuel from the refueling station, the fuel that does not meet the requirements will lead to carbon deposition on cylinders, automobile spark plugs and other parts.

5. Heat up the cold car before starting.

The function of car heating is that the engine degree slowly rises to the operating temperature, and the grease is not yet in time to cause the parts to be polished.

6. The gear should be suitable.

This is mainly for models with manual transmissions. Beginners are inexperienced and it is not easy to switch into the matching gear at the right speed ratio. The gear change is carried out according to the sound effect of the engine operation, and the speedometer of the dashboard of the car is more accurate.

Millions of car purchase subsidies.

The new Fox break-in period is as follows:

500 kilometers for the initial run-in, at this time the speed should not be too fast, generally 70-80 kilometers below, the speed should not exceed 220 is the best.

2.500-1000 kilometers is the mid-term run-in, the maximum speed can be appropriately increased, generally can reach 90-100 kilometers, and the speed is still below 2500 rpm. Increasing the speed appropriately will not only not affect the engine, but can promote the running-in, and you can see if there is any abnormality when the speed is increased again.

3.1000-1500 km is the later run-in, and the speed can be increased to less than 120 km. Because running-in is a gradual process, it must be gradually increased. The speed should not exceed 3000 rpm.

4.When all cars are driving at low speed, the actual burden is greater than that of medium speed, so the run-in period should not be run in below 60 kilometers per hour for a long time. The speed must be increased gradually.

At the same time, if you have been running at a speed of 80 kilometers per hour after the run-in period, a sharp increase in speed will make the new car unadaptable, so it is necessary to gradually increase the maximum speed during the run-in period.

5.Do not drive at a fixed speed for a long time during the run-in period, and there should be a speed change.

6.When driving during the run-in period, it is necessary to avoid sudden braking and rapid acceleration.

In the case of automatic transmission, the run-in specified gear cannot be determined by manual gear shifting, so it can only be achieved by driving speed. In short, the run-in should be driven at a constant speed, and the level of 30km h km h and 80km h km h must be stable running-in. It is recommended to get the run-in period on the flat highway at about 10 o'clock in the evening, and the car can be said to be a later "manufacturing" process, grinding the car, after the run-in, the vehicle is powerful, the parts are running normally, and the machine life is longer, and the grinding is not good.

Nowadays, the cars that leave the factory are treated by a cold grinding process, so there is no need to deliberately run in. It should be noted that the control speed of the vehicle within 3000 kilometers should not exceed 80% of the maximum speed of the car.

The run-in period is 3,000 kilometers or no more than three months, during the run-in period of the new car, the speed of the engine should not exceed 3,000 rpm, the speed should not exceed 100 miles, do not accelerate or decelerate sharply during driving, and do not overload driving.

Soul about your question, the new car can be used normally after 2000 kilometers of normal driving. During the run-in period, you need to pay attention to the following points:1

The engine speed should not be too high, preferably not more than 3000 rpm. 2.There should be a process of warming up the car during the cold start, and driving on the road after the water temperature changes, generally about 5 minutes.

3.The hail load must be reduced according to the load regulations of the model, and it is advisable not to exceed 70% of the specified load capacity. 4.

The impact damage of the new car's engine, braking system and chassis is great, and the situation should be dealt with in advance during driving, and the deceleration and gear reduction are chaotic. 5.Avoid rushing to refuel and brake suddenly, and try to maintain a constant speed.

The maximum speed of the vehicle within the run-in period should not exceed 90 kilometers per hour, but it is not allowed to drive at low speed for a long time. 6.According to the time and mileage specified by the manufacturer, go to the 4S store for the first insurance.

Register now to ask questions to get free tickets to the Beijing International Auto Show!

Before starting a new car, wait until the engine temperature comes up and walk, pay attention to the instrument, and the speed of the car should not be too fast.

Have you ever run in for your new car?

That's a tough question! I'll take my Xiaofu as an example, let's talk about experience, don't blame the master.

1: Generally speaking, the run-in period is divided into 100 kilometers in the initial stage and 3000 kilometers in the run-in to form an oxide film, of course, this is not absolutely accurate. Just like the sales told me when I picked up the car:

Run-in 1500 kilometers, the speed does not exceed 3000, the speed does not exceed 80 per hour, and then pull down the high-speed, after 3000, you can come to the first insurance. It is recommended that you refer to the owner's manual, and the data provided by the manufacturer shall prevail.

Second: pay attention not to hang the high-end at low speed during the run-in period, because frequent setbacks will also damage these parts in the cylinder. In addition, stepping on the accelerator should also be uniform and gentle, especially novices should pay attention not to slam the accelerator and slam on the brakes, which will cause great damage to the new car.

In addition, the vehicle should be warmed up when it starts, which is good for the vehicle's motor and engine. At this point, our Xiaofu has an advantage, because Xiaofu's engine is made of all-aluminum alloy, so when starting, the all-aluminum engine heats up quickly, and the hot car time is very short, which saves the fuel consumption caused by the hot car for too long, and the all-aluminum is light in weight and has better heat dissipation.

Three: during the run-in period to avoid high-speed driving, generally controlled at 40-70 kilometers, domestic cars are generally like this, in addition to the driving to observe the engine tachometer and speedometer, so that the engine speed and speed are working at medium speed. This not only facilitates running-in, but also saves fuel.

In addition to running-in, the other is to pull the high speed. The main purpose of pulling the speed is to allow the new piston and camshaft in the engine to try to work quickly for the first time, so that they can have better contact with each other. There is also to let the gears in the gearbox try to rotate at high speed, so that the new gears and the bite between the gears are smoother, so that the car has better power performance in the future driving, and the gear shift is smoother.

In addition, pulling high-speed is not fast or pulling high-speed, nor which gear is called pulling high-speed, but each gear must be pulled, so that Xiaofu can fully move its muscles, after maintenance, the performance of power and fuel consumption is more outstanding!

Although there are many precautions for the run-in period and pulling the highway, the landlord does not have to worry too much, because now for the run-in of the new car, it is not "mandatory", just a suggestion. Just take care of your car!