Install win7 blue screen appear 0X00000007B and choose safe mode and the last entry is also a blue s

Friend, the causes of the computer blue screen are complicated! It's a conflict between software! (Refer to Section 3, Software Incompatibility).

1。If this is an accident, usually restart the computer and the symptoms will disappear!

2。Incomplete anti-virus (use anti-virus software, full scan and custom scan)!

3。Software conflicts, incompatibilities: redundant similar software installation, (360 Butler, software uninstall, find uninstall, again:

4。The computer system has stubborn viruses and Trojan horses or worms interfere with, or the system files have been lost (360 system emergency.

Rescue box or Kingsoft first aid kit, Kingsoft net shield, etc., any of them, full killing, and then: system repair).

6。There are new vulnerabilities waiting to be installed in the system (patched for high-risk and important, others are set to: ignore).

7。Graphics card or memory CPU, or fan is in poor contact and loose or has dust covered, (unplug the eraser) Note is: Desktop!

8。The memory CPU is overheated, and the heat dissipation is not good! (Don't turn on for too long, turn off and dissipate).

9。There is a bad comment plug-in on the computer! (Scan it out, clean it up immediately).

11。If it still doesn't work, the system files are missing! Or maybe there's a serious error in the system memory!

12。Try to press F8 after booting, press Enter, Enter, enter into safe mode, configure correctly for the last time, and press down.

Try it! Or, go into safe mode, go to the desktop, and get a full antivirus!

13。Playing games on the blue screen, generally the system does not support this game! (Change the game version or change the XP system).

15。If it still doesn't work, you need to "one-click restore" the system or "reinstall the system"!

This answer is not copied from the Internet, all of it is me: "Liwang History", I have been "knowing" for a long time to summarize and practice myself, as well as the experience of the majority of netizens!

Hello, computer blue screen, mainly: "memory error" or "software incompatibility" caused!

1。Try to boot up, after the computer brand is out, press F8, Safe Mode, Cursor Select: Last Correct Configuration, Enter, Enter, Press Down! [Critical step].

2。If it still doesn't work, you need to "one-click restore" or "reinstall the system"!

3。If there is a problem with the hardware, send it for repair!

After investigation, the reason for this blue screen error** is:

**： 0x0000007b

Cause: File name, directory name, or repository volume label syntax error.

References: Blue Screen Failure.

If this appears after booting, you may want to repair the disk boot.

References: Blue Screen Shutdown Code.

When you encounter a blue screen, you can't exit automatically, you can press and hold the power button to exit the system first (blue screen). Restart the computer and press the F8 key to select the safe mode to deal with faults such as driver exceptions, update errors, etc.

The method should be correct: press F8 without moving immediately after booting or not turning on the first press and hold F8 without moving on at boot, to the advanced options in the release of the hand, use the up and down keys to select the options mentioned above and press Enter (my computer is like this, some computers are continuously clicking F8 immediately after booting).

If there is a hardware, take out the motherboard battery and put it on the charge, plug and unplug the memory, clean the graphics card, check whether there is a problem with the hard disk, and if it doesn't work, just overhaul it.

It's really not possible to reinstall the system.,If you can't turn on the machine by any method.,It's a sudden shutdown.,Caused by disk damage.,One is to deduct the motherboard battery and put it down.,One is to put it on for a period of time to try it on the start.,Or can't you just repair it.。

BIOS battery discharge method: Discharge the CMOS memory through the jumper: pull out the jumper cap next to the CMOS battery, insert it into another pin for a few seconds, and then pull it back into its original position, or take out the CMOS battery, short circuit the positive and negative poles on the battery for a few seconds, and install the battery.

Do you have a restored disc? Generally, you will have it when you buy a computer, and it is good to restore it.

There is no other solution than reloading.

1.Start with the software first, if running the Mo software causes an error, it is recommended to reinstall the software, which can generally be solved.

2.Consider whether other software is running at the same time, causing conflicts, or if the host configuration memory is too small, resulting in memory overflow or exhaustion (for example, if the XP system is used, it is recommended to configure more than 512MB memory or 512MB).

3.Check whether the driver or BIOS has been reinstalled or upgraded recently, then it is likely to be caused by driver incompatibility, just uninstall and reinstall the original driver.

4.If you exclude the first three points, you can basically tell you that it is unfortunate! It's probably a hardware issue. To determine whether it is a hardware failure, it is recommended to format the hard disk, reinstall the system, see if it is normal, and rule out viruses and system-related faults!

5.Hardware problems, I explained above, mainly check the memory, check whether the memory metal strip is oxidized, if more than two memory are installed, remove one or change the memory slot. Other motherboards, power supplies, heat dissipation, etc. will not be introduced one by one!

Solution, find a computer with a normal system (win7 32 or 64, pay attention to the number of bits in the system), enter the system, and open the C: Windows System32 CodeIntegrity folder (C: corresponding to the Windows 7 installation partition).

There are two files in this folder: and , copy these two folders and put them in a USB flash drive. Start the blue screen computer with a USB flash drive, go to PE, and put these 2 files into C:

Windows System32 CodeIntegrity can replace these two files.

There are many reasons for the blue screen, most of which are software incompatibilities, and a small number of hardware incompatibilities. Often the blue screen is better than reinstalling the system. If you reinstall the system or the blue screen, you should find a place to repair the computer to check whether the memory is broken.

If it is a blue screen caused by playing a game, it is recommended to replace the graphics card driver.

Seeking a solution to the office is to develop theoretical things.

There are four main possibilities.

The first is the first alternation of the old and new motherboards.

The second is that there are viruses that interfere with the operation of the system.

The third is the error caused by the hard drive mode.

The fourth is that the installation environment is wrong, try both ghost and setup.

Solution: In the BIOS, set "SATA Operation" to "ATA", and then install Windows XP to let the hard disk work in "ATA" mode;

Extract the SATA driver from the RCD to the floppy drive, and press F6 to install the SATA driver during the installation of Windows XP.

Use the Windows XP CD containing SATA driver for installation, the original Windows XP CD of the 755 machine, etc.;

Set the BIOS to "ATA" mode, install Windows XP, and then manually install the SATA driver (this process is more tedious), and then change the BIOS back to "AHCI" mode.

Analysis: Because Dell computers use SATA hard drives, we know that SATA hard drives currently work in two modes, one is "ATA mode", the second is "AHCI" mode, in BIOS, you can choose between these two modes.

If SATA Operation is set to AHCI mode in the BIOS, SATA drivers are required to install Windows XP. If the customer buys Windows XP and installs it with the included XP CD, it can be installed smoothly;

However, this problem can occur if the customer is purchasing a Vista or N system and using an XP disc that does not contain SATA drivers (such as the Windows XP disc that came with an earlier Dell machine).

Note: Since Vista natively supports AHCI, installing Vista generally does not have such problems.

Your blue screen is 0x0000007b

This indicates that Windows is unable to access the system partition during the boot process. This error is often due to the boot device (hard disk) boot failure. If this error occurs during the system installation phase, it may be caused by an incompatible disk, a virus, or a hard disk damage.

1. Reinstall the operating system and install the drivers of each device correctly2. Use the disk detection program to check whether the disk is faulty, if so, send an order. Faulty parts: hard disk 1, if it is a boot device boot file error, please boot file 2, if it is generated after adding hardware, please remove; If a new driver is added, uninstall or disable it.

If you cannot enter the system, please restart the machine and press F8 to enter the "Last Correct Configuration Mode".

3. Use the latest version of antivirus software for antivirus.

4. At the command prompt, run"chkdsk /f /r"The command checks and fixes file errors.

5. If the above operation is invalid, it is recommended to repair and install or reinstall the system.