Hello, my car is Benben mini, would you like to ask if the car needs to step on the clutch when igni

Hello! In general, you can refer to the following speed shifts (provided that the vehicle is either fully loaded or fully occupied).

1. The first gear is added to the second gear, 20km; The second gear is increased by the third gear, 30km; 3rd gear increased by 4th gear, 45km; The fourth gear is increased by the fifth gear, more than 55km;

2. When the engine speed is heavy, try to increase the speed by 300-400 rpm and then increase the gear, so as to ensure the smooth driving of the vehicle and ensure the perfect combination of engine and gearbox torque;

But if the above is prematurely increased, is it possible? If it is a light load, it can be increased by about 5km in advance, but in the case of heavy load, it must be increased at the required standard speed! Pay attention to this!

3. The general vehicle is the most fuel-efficient in the case of 60km-90km per hour, and your Benben mini is the most fuel-efficient speed under normal circumstances because of the small displacement, 50-70km per hour under normal circumstances!

By the way, it should be clarified here that it is not the most fuel-efficient for the vehicle to coast in neutral, because the vehicle still burns fuel when the vehicle is in neutral, but the vehicle suddenly changes from high speed to low speed while driving, which will cause the engine water temperature to heat up rapidly, the oil temperature to rise, reduce the economy of the vehicle's driving fuel, affect the service life of the engine and seriously affect the safety of the vehicle in an emergency; The best way is to coast in gear, in this case, the amount of fuel burned by the engine is the lowest, and the effective use of the engine drag can ensure the stability of the vehicle driving and the stability of the temperature! This method is the safest and most economical! ~

Believe you're right!

Hello, shift gears to see the speed, according to personal habits, I am shifting gears at about 2300 rpm, in fact, the five-speed car should be 15 shifts to 2 gears, 40 shifts to 3 gears, 60 shifts to 4 gears, 80 shifts to five gears, you can see that they are almost all around 2300 rpm, and 90 speeds are the most fuel-efficient.

Don't step on the clutch, that's wrong. The clutch is used when shifting gears. The car should step on the accelerator when starting, and generally the car should not start immediately after playing, let it start in place for a few minutes, which is a maintenance method for the car; Drivers should know how to maintain their cars.

Generally, the car can be changed to the second gear immediately after the first gear starts, and the third gear can be changed to 30 yards, and the fourth gear can be changed to 40 yards; Fifth gear is the speed gear, in fact, it is better to listen to the sound of the engine. You hear that the engine is without Bailey, and you can shift gears. The car is generally most fuel-efficient in neutral, but if you are still a novice, it is better not to use neutral.

Driving experience is the most important thing, and after a long time, I will gradually become more experienced. Have a good day, peace!

The lower the speed, the more fuel-efficient the gear shift, but to ensure that you do not turn off the ignition after changing gears, do not shake, and it is best to have a speed of 80 miles in 5th gear.

Are you still tinkering with the positive and negative poles yourself? I'm not afraid of burning the starter... Talent, the battery is used with a multimeter to measure when it is started, and you will know that many cars are not bad, they are not open, and they are not open, and they are called, who makes you not drive.

1. Reduce the wear and tear of the vehicle and improve the probability of successful starting.

Pressing the clutch when the car is igniting can reduce the burden on the engine and reduce the wear and tear on the battery, starter and other parts. When the vehicle is in neutral mode, although the input shaft gear of the engine is not engaged with the power take-off gear of the gearbox, a part of the power of the engine is still consumed by the clutch driven disc, clutch output shaft and other components after the clutch driven part, especially in the case of high viscosity of the gearbox lubricating oil in winter, this power consumption is particularly obvious. When stepping on the clutch to start the vehicle, the parts behind the clutch follower are cut from the engine power, so the pressure on the battery and the starter is reduced, and the start is smoother.

2.Prevent accidents.

Some manual transmission drivers like to use a different gear when parking to prevent the vehicle from rolling, and when starting the vehicle, they often forget that the vehicle is still in gear. If you do not have the habit of stepping on the clutch when starting the vehicle at this time, it will often cause the vehicle to diverge, and in serious cases, traffic accidents will occur.

When driving a lighter, should I step on the clutch?

When the manual transmission car is ignited, the clutch must be stepped on to prevent misalignment, otherwise the car will suddenly drive out as soon as it is ignited.

Stepping on the clutch will cut off the connection between the gearbox and the engine, and if you don't step on the clutch when ignition, the starter will carry the engine, the engine will carry the clutch plates, and the clutch plates will run with the shaft.

The clutch is not a brake, if it is a purely automatic car, there is no clutch, only the brake and the accelerator.

The clutch can not be used as a brake, if you press the clutch when going downhill, the speed of the car will be faster, because the transmission device is disconnected from the wheels, the engine can not control the car, and the speed of the car will be faster under the action of inertia and gravity.

The clutch, as the name suggests, is to play the role of disengaging and closing. It plays a role in the separation of the engine and the wheel transmission. That is to say, when you press the clutch, then the transmission of the engine is disconnected from the wheels, and the power of the engine is not transmitted to the wheels to drive the car.

When you release the clutch, the transmission of the engine is connected to the wheels, and the power is transmitted to the wheels, and the car will naturally move.

Should you press the clutch when starting a manual transmission car?

You can step on it or not, this is a problem of each person's driving habits, and if you are used to parking and gearing, it is best to step on the clutch to start. The advantage of stepping on the clutch is that it does not start by stepping on it: the gearbox is disengaged to reduce friction, and it saves fuel and electricity during cold start.

The advantages of stepping on the clutch when starting are 1: to prevent the start of the gear, which also prevents the car from running, that is, to prevent sudden start, 2: when the clutch is stepped on, the engine is separated from the transmission system, which can reduce the load of the starter and the engine, and make the engine easier to start, especially in winter.

Only press the clutch when starting on gear, and don't need to press when starting in neutral.

It depends on what kind of car, I drove an old Toyota, that car is to start must step on the clutch, I am driving the car now but you hang on the gear, step on the clutch to start, the starter is not what reaction, I have been driving for ten years, I will only agree to step on the clutch can disconnect the mechanical transmission between the engine and the gearbox, otherwise the starting motor not only has to turn the engine, but also indirectly rotate the gearbox gears, the transmission is divided into one shaft and two axes, I don't know how you know about the structure of the vehicle, But if you step on it, you can separate the transmission from the starter, which you will experience when starting in winter, when the gearbox oil is thick when it is cold, and there will be a little lag when starting the cold engine

When driving a lighter, should I step on the clutch?

It is not necessary to press the clutch when ignition.

First, it is not necessary to step on the clutch when ignition, but it is a good habit to step on the clutch when the car is ignited, it can prevent the gear from not being in neutral, if you do not step on the clutch, the gear is not in neutral, then the car will jump out, and danger will occur; Pressing the clutch during ignition also reduces the load on the starter.

Second, the reason for stepping on the clutch during ignition:

1. After stepping on the clutch, the power transmission can be interrupted to prevent the dangerous situation that may occur when the gear is ignited.

2. Protect the car battery and engine starter. Especially in winter, many car owners know to step on the clutch and then release the clutch after ignition, and they can obviously feel the sound of the engine being more strained. It shows that in neutral mode, the gearbox still has a certain load.

Then, if you do not step on the clutch in neutral gear, the starting load of the starter will increase, the starter current will increase sharply, the instantaneous discharge of the battery is much higher than that when stepping on the clutch start, the battery is easy to lose power, and the service life is reduced; At the same time, the starter is prone to overcurrent when igniting without stepping on the clutch, and the motor may be burned in extreme cases.

3. Compared with not stepping on the clutch to ignite, the starting time of the engine is more interrupted and the starter current is smaller in the previous case. The starter current is generally between 200A and 400A instantaneously, and the current is different for different displacements.

Therefore, when ignition, it is better to step on the clutch.

Should you press the clutch when starting a manual transmission car?

Yes, you have to step on the clutch, the first is to safely prevent the car from running out when the car is not out of gear, and the second is to reduce the resistance caused by the negative gearbox gear oil when starting, especially when the temperature is low, the oil consistency is large, and the resistance is greater.

The saying that you step on the clutch and then ignite. It is to help some novice drivers, especially those who prefer to pin the vehicle with gear when the engine is turned off without using the hand brake. It is afraid that once ignited, the engine will rush or cause the clutch to be instantly ablated.

As shown in the figure above, when the engine and the wheels are separated when the gear is not hung up, the train will not move at this time, but at this time the gears of the engine and the gearbox are connected, not separated, at this time, the ignition starts the engine needs to be driven by the motor will increase the resistance, the cost of electricity and the gear, step on the clutch, the engine and the gear in the above picture are separated, saving labor and gear, especially obvious in winter.

Pressing the clutch is required to ignite.

Pressing on the clutch not only reduces the load on the starter, but also reduces wear on the clutch plates. The principle is to cut off the connection between the engine and the transmission input shaft (one shaft) by pressing on the clutch (disengagement). Sometimes stepping on the clutch to start has a more important role, which is to prevent the gear from not being in neutral when starting, and sometimes when parking, in order to be safer, it will push into the first gear to prevent landslides.

There's no need to step on the clutch at all, and it's okay to step on the clutch, and it doesn't have any effect.

As long as it is neutral, it makes no difference whether you step on it or not, and it is for insurance to prevent unnecessary trouble in gear.

Personal habits, I'm just stepping on the fire.

There is no effect, the bullet does not hit the brakes and does not ignite.

When driving a lighter, should I step on the clutch?

Depending on the model, most cars do not need to step on the clutch under the premise of neutral gear.

Introduction: First, you can step on it or not, this is a habitual problem habit of driving, and it is best to step on the gathering and scattering to start when parking.

Second, the advantages of stepping on the gathering and dispersion than not stepping on the start:

The gearbox is separated, reducing friction, saving fuel and electricity during cold start.

The right hand is put into 1st gear, and the right hand turns on the left turn signal; Press the horn with the left hand, slowly lift the clutch pedal with the left foot to semi-linkage, and slowly release the parking brake lever with the right hand at the same time, while slowly pressing the accelerator pedal with the right foot to refuel; Observe the movement of the car.

Refuel in time if there is a tendency to shake, and loosen the parking brake pedal in time if there is a tendency to slip. Listen carefully to the engine sound: if it gets low, refuel in time or release the parking brake pedal in time; If the engine sound becomes high, reduce the throttle or lift the clutch pedal in time, and release the clutch pedal with the left foot after the car starts for 3-4m; After refueling with your right foot to increase your speed to normal speed, drive the car into the normal lane and turn off the turn signal.

Before the car is ignited, should I step on the clutch? Listen to the old driver tell you in a minute.

The manual transmission should press the clutch in neutral gear when starting, in order to reduce the running resistance of the starter and make the start smoother.

Stepping on the clutch to start the vehicle is to separate the engine from the gearbox, which reduces the starting load and is conducive to the life of the battery.

Some cars need to press the clutch pedal to ignite, even if they are in neutral, otherwise they do not respond, whether it is automatic or not.

It is a good habit to step on the clutch when the car is ignition, which can avoid accidents caused by ignition when hanging on the gear, and the Volkswagen series can not be played without stepping on the clutch when ignition, hoping to develop good driving habits.

Make sure the car starts smoothly and doesn't work without stepping on it.

The car is in a stationary state before starting, if the engine and the gearbox are rigidly connected, once the gear is hooked, the car will suddenly rush forward due to the sudden connection of power, which will not only cause damage to the parts, but also the driving force is not enough to overcome the huge inertia generated by the forward rush of the car, so that the engine speed drops sharply and stalls.

If the clutch is used to temporarily separate the engine and the gearbox at the start, and then the clutch is gradually engaged, because there is a slip grinding phenomenon between the active part of the clutch and the driven part, the torque transmitted by the clutch can gradually increase from zero, and the driving force of the car also gradually increases, so that the car starts smoothly.

How it works. The active part and the driven part of the clutch are used by friction between the contact surfaces, or the liquid is used as the transmission medium (hydraulic coupling), or the magnetic transmission (electromagnetic clutch) is used to transmit torque, so that the two can be temporarily separated, and can be gradually engaged, and the two parts are allowed to rotate each other during the transmission process.

Should you step on the clutch when driving a lighter? Novice drivers should pay attention, otherwise it is dangerous to hurt the car.

When the manual transmission model is ignited, there are some people who are accustomed to stepping on the clutch, especially some old drivers, I have asked a lot of older drivers before, why do you want to step on the clutch when starting the vehicle, the answer is very strange, many people said that when the coach taught the car in that era, it was necessary to stipulate that the clutch was first stepped on in the ignition, and then this habit was formed, and some old drivers said that it was safer to step on the clutch to ignite, which could prevent the vehicle from being in the gear, and there were accidents when ignition, and now there are some drivers who stepped on the clutch to ignitionFirst, some models equipped with a one-button start can't catch fire if you don't step on the clutch, and the second is that it is also a habit, stepping on the clutch is more steady.