Guitar on? What should I pay attention to?

Classical guitars do have the same acoustic problems as violins,。。 But you say that the new piano is not good, it is not right, it can only be said that the new piano is played correctly by the master, and the timbre will be more beautiful and beautiful after a certain period of time, everything has a process from the beginning to the end, including the most essence and the best period, the guitar is no exception, not that the new piano is not good... As long as you play more, the timbre will get better and better, and the feel will become smoother and smoother!

Different parts of the guitar require the use of wood with different personalities. Experience has shown that European white pine, Engelmann white pine and Korean pine, and California red pine are suitable for panels; Brazilian rosewood, maple, and some mahogany woods are suitable for dorsal side panels. Spanish red pine or Cuban mahogany is good for the neck.

Ebony or rosewood is suitable for fretboarding.

The sound difference between the red pine panel and the white pine panel.

The voice of the red pine immediately came out ("Turn on"Earlier).

White pine"Turn on"Later, a few years later.

Red pine treble is warm and sweet, the sound is bright, suitable for playing romantic and Spanish music, Spanish classical guitar and flamenco guitar mostly use red pine, white pine high and low resonance is balanced, the sound is neat, suitable for playing classical or baroque**.

White pine is much more expensive than red piano, and top guitars are mostly white pine tops. But we see that many masters like to use the red pine qin when they open a meeting, because the red pine qin is easy to drive, and no one wants to play the white pine qin. To be honest, the sound of the white pine qin is better than that of the red pine.

However, the white pine qin is really difficult to drive, and many enthusiasts can't make a good sound when playing the white pine qin, because of the problem of playing the way.

On the other hand, the red pine qin is relatively easy to drive and easy to produce a good sound. But if you have the skills, the sound of the white pine qin is fascinating.

The humidity is about 60, too dry and too humid air is not suitable for making an open sound, the playing volume is moderate, don't be too loud, generally about 3 months, it's hard to say, depending on whether the frequency of your play is high, if you play it once every three months, then you insist on playing it for 30 years, maybe you will open the sound. Ha ha.

The sound of the guitar is when the new guitar becomes better and better after being played. Normally, the tone of a new guitar is abnormal, either because the sound is a little small, or because the sound of the vocalizer is not the same as that of other guitars, because the adhesive part of the new guitar is not fully integrated.

When after a period of use, the adhesive part of the new piano is fully run-in, and the plates.

When the vibration is sufficient, the tone of the guitar will become normal, and the sound of the guitar will become better and better after playing. This process is the guitar sound.

The principle is that when playing the guitar, the elastic deformation of the strings produces tension, which makes the top, back, and side plates of the guitar elastically deformed.

In addition, the strumming accelerates the evaporation of wood moisture, increasing the reflection of sound.

It is important to know that not all guitars can make a sound, such as a plywood guitar will not have a sound. Usually refers to veneer guitars, face sheets and full single guitars need to be turned on. Among them, the full single piano has the greatest potential for opening, followed by the veneer, and finally the plywood.

The main changes after the guitar is turned on are: 1. The sustain of the sound is lengthened. 2. The treble volume increases. 3. The voice changes from sharp to mellow with slag keys, from jerky to mature.