Toilet custom version What do you think, how to measure the distance between the toilet pits

Updated on home 2024-02-09
20 answers
  1. Anonymous users2024-02-05

    Do you do engineering or home improvement? It can be seen in the general hydropower diagram.

  2. Anonymous users2024-02-04

    Toilet No. 1: Two upside-down quartz stairs, the top quartz at the back is fast, and the toilet lid is a pressure plate Toilet No. 2: Alchemy pot type flush, wooden toilet lid, flip lid Toilet No. 3:

    This toilet is similar to Toilet No. 2, with a funnel flush system. Minecraft is known as the first true sandbox game, the world of the game doesn't look exciting at all, but it's a free world where you can create anything, including the environment in the game, where you are God. Some say that in this game, you only have to do two things:

    Construction and destruction. You'll be able to create all kinds of things with the blocks available to you in the game, you can use your imagination, you can build houses, castles and even cities, you can also tame your pets, create your manor or create a beautiful world online with other players. The high degree of freedom of Minecraft Mobile makes many players who adapt to the plot uncomfortable, however, we can think that this is no longer a game, this is a platform for players to build their dreams, we create our own houses, try to survive in survival mode, we play online with friends, enjoy the fun of playing together, build wonderful mechanisms, and make others jaw-dropping.

    In this free world, players can build their own world exactly as they wish, pleasing themselves to the eye and making others praise.

  3. Anonymous users2024-02-03

    The following schemes are from high to low in order of feasibility: 1. Lengthen the length of excrement as much as possible, and then cut off after the front end of the world site bottoms out (the requirements for sphincter control are higher). 2. Before the excrement falls and is about to touch the water, quickly raise the buttocks to avoid splashing (the requirements for the explosive power of the leg muscles are higher than those of Souqi).

    3. Replace the toilet that does not store water (it is difficult to find it on the market). 4. Spread toilet paper on the water surface of the toilet bowl before sitting down.

  4. Anonymous users2024-02-02

    It is best to change the sewer pipe, and you should ask the original water hole or reserved when the "master" installed the toilet not, now the hole spacing of the toilet is generally very common are 300 and 400 kinds, from the wall at 10 cm or the like is OK, the strict requirements are close to the wall, there is a rubber thing under the toilet can have a 4 cm adjustment. If the floor and waterproofing have been done, for the sake of aesthetics, buy a new toilet, there are special ones, you can search on the Internet, but ** more expensive than the ordinary ones.

  5. Anonymous users2024-02-01

    1 Treat the ground drain as high as the ground, and then press the center of the outlet to draw a cross extension.

    2 Draw a crosshair along the toilet outlet to the spot where you can see the edge of the toilet, 3 Put the horse to the drain with the crosshairs overlapping.

    4 Draw a line along the outside of the toilet bowl and remove it.

    5 Place the toilet sealing flange on the drain on the ground, and make a circle of glass glue along the inside of the overall circle line of the toilet bowl.

    6. Place the toilet on top of the crosshair, press the bottom edge of the toilet on the glass glue, connect the water hose, and install an angle valve at the water outlet on the wall to turn off the water for maintenance in the future.

    7 Do not use and keep the ground dry for 24 hours.

  6. Anonymous users2024-01-31

    This kind of daily use is still to spend money to hire people, look at your description, you don't understand this aspect too well.

    If it is broken and leaked in the middle, the gain outweighs the loss.

    One hundred in a small city and two hundred in a big city can be regarded as a sky-high price, so why bother?!

  7. Anonymous users2024-01-30

    It's still okay to use putty, but the psychological feeling of using flanges is a little more stable, and the outside is more beautiful, but using putty should save a little money.

  8. Anonymous users2024-01-29

    Make a basin of water and pour it over the stuck place. Then twist it out, and you can't get out vertically.

  9. Anonymous users2024-01-28

    We have a very old story here, how did the bull's head drill come out of the jar? Cut the head of the cow first, then smash the jar.

  10. Anonymous users2024-01-27

    Hit ** to 119, it didn't cost it, and shouted for help! If there is no one, you can only find something to unload your feet!

  11. Anonymous users2024-01-26

    You can die now, but before you die, can you let me know how you got into it?

  12. Anonymous users2024-01-25

    Alas, immediately smashed the toilet.

  13. Anonymous users2024-01-24

    Great god, you can put on a picture, so that everyone can see it

  14. Anonymous users2024-01-23

    Drill in and climb out again through the sewer manhole cover.

  15. Anonymous users2024-01-22

    For the toilet with floor drain (the drain pipe runs directly from the bathroom floor to the toilet), the pit distance refers to the distance between the drain under the toilet and the outermost edge behind the toilet, because if this distance is left less, the toilet cannot be directly connected to the reserved drain pipe due to the influence of the wall.

    For the toilet with a wall row (the drainage pipe extends from the rear wall to connect to the toilet, and some people call it the back row, and the toilet is connected to the drainage pipe backwards), there is no problem of pit spacing, but the problem of the height of the drainage interface and the toilet drain should be considered.

  16. Anonymous users2024-01-21

    The toilet pit distance is the distance from the rear façade of the toilet tank to the center of the toilet downpipe, which is generally 300, 350, 380, 400 mm. In fact, the measurement is very simple, the distance from the middle of the drainage pipe to the vertical line of the rear façade of the tank is the pit distance. As shown in Fig

  17. Anonymous users2024-01-20

    Landlord,This is a complete palliative solution.。。

    According to what you say. The glaze of the toilet bowl has been completely damaged and corroded by you.

    No matter what you wash it with, it won't be long before it's dirty again. Repeated washing will find that the time for repeated dirtiness is shortening.。

    It is recommended to use a neutral lotion to clean ceramic things to avoid damaging the glaze.

    Use diluted hydrochloric acid for it. Soak it for a while, and then wash it off with water, if it's better, you should often be clear in the future, it is recommended to use toothpaste, but toothpaste can only be used when it is not very dirty.

    toto

  18. Anonymous users2024-01-19

    Don't use hydrochloric acid, hydrochloric acid is volatile, don't use sulfuric acid, sulfuric acid will be exothermic when exposed to water, if the concentration is high, it will also happen. I've had enough of this, and now I don't dare to enter the school labs.

    Use weak alkali (weak acid) to do.

  19. Anonymous users2024-01-18

    There is a special one called "Pipe Pass."'something to sell. Most supermarkets will have it. I've used it and it works great. And it's not expensive, only ten yuan a box. It is also a chemical agent. It is recommended to give it a try.

  20. Anonymous users2024-01-17

    The concentrated hydrochloric acid soaking time is a little longer.

Related questions
13 answers2024-02-09

Generally, each electric vehicle battery is 12V, but also 6V (rarely used); The battery shell is generally printed with 6-dzm- (number), the number represents the battery capacity, such as: 12, that is, the battery is 12ah (ampere-hour); Generally, there are 10ah, 12ah, 14ah for small electric vehicles, 16ah, 17ah, 18ah, 20ah for large electric vehicles, etc., the capacity of the battery represents the size of the mileage that can be run, and the mileage of the large capacity is larger, and the larger one can be selected, ** The difference is not big; It can be connected in series to form 36V, 48V, 60V, etc., the general safety voltage is 36V, but with the current situation of overspeeding of people and goods, the voltage is getting bigger and bigger, and you can choose according to your actual situation.

28 answers2024-02-09

Love is visible. What we see is not love itself, but the outward manifestation of love. Love can be seen from every bit of life. Don't be blindly idealistic, love is too tired like that

8 answers2024-02-09

Two methods.

First, open cmd and type python-->import selenium-->selenium.__version__ >>>More

11 answers2024-02-09

The higher the CPU frequency of a smartphone, the faster it runs, and that's right. At the same time, a smart phone is like a computer, and the operating system in it can be divided into several types, such as Nokia's Symbian operating system, while Samsung uses more Windows Mobil operating system, in addition to Apple's dedicated operating system, etc., compared to the Symbian operating system, which is more power-efficient, and the Windows Mobil operating system supports more software, but it is more power-intensive, which is recognized, and Apple does not use much. At the same time, the speed of the mobile phone is also affected by the memory of the mobile phone, which is equivalent to the relationship between the memory of the computer and the CPU. >>>More

8 answers2024-02-09

First of all, you have to call** to Nokia customer service, and ask if this version has been released in China, which is the red one you said, if you are sure that there is a release, which 50% is fine. To see if a mobile phone is brand new, you can look at these places, one is whether the screws of the mobile phone have been screwed, open the back cover of the mobile phone, take out the battery, and smell it with your nose to see if there is a smell of solder. Another one you enter on your phone* Check whether the total call time of the mobile phone is about the same as the time you used, if it feels a lot more, which mobile phone has been used, but this method is not particularly accurate, because if it is a refurbished machine, the fine one will be cleared before the total time. >>>More