My USB flash drive is write protected Unable to format file system RAW I didn t find Strong devicepo

U disk, if there is a failure to format, can not delete the files inside, when formatting prompts the floppy disk to write protection, this indicates that the flash of the USB disk has a bad block, the main control of the USB disk to protect the data, prohibit writing, now if you still want to use the USB disk, then you only have to carry out mass production, first use the main control detection tool chipgenius to detect your USB disk master control model, and then use the corresponding mass production tools for mass production, you will get a new USB disk, The capacity inside may increase ... A 1g USB drive may reach. Of course this is likely to happen:

The properties of the USB drive may look like this - 975M of free space, 253M of used space, but there is not a single file in the USB drive. I think,This is due to the blocking of the bad blocks of flash during mass production,In this case, you can re-mass produce it,The second solution is formatting,To select fast formatting,That is, delete the data,So that his capacity will become normal。

USB flash drive capacity 0, RAW format?

If this happens, if you want to keep the original data, format it directly, just select the quick format, that is, delete the data, the file system can be defaulted, after formatting, the U disk will be normal, at this time, you can recover the data with data recovery software, this is my experience, there are many methods on the Internet, there are also RAW tools, but I am very unhappy with it, useless,。。 It's still a quick format,And then do data recovery good.,Final recovery to do data recovery.,Especially the formatting is very easy to use.,General deletion directly with a undelete on the line。。。

I also appeared this morning that the USB flash drive file system was changed to raw, and I searched the Internet for a long time and still didn't solve it.

For the first time, there were.

It's a super patrol USB stick immunizer that I installed.

Solved. It's nice to try it again today.

OK again. Their so-called high-level solution is oh European.

Immunization and you're done.

Your USB flash drive may have a locking device, on your USB flash drive, you look for it.

Because I've tried it before.

The RAW file of the USB flash drive is damaged, and it needs to be repaired in mass production. You can check the main control information with the chip wizard, and then find mass production tools for mass production repair according to the chip manufacturer and chip model found.

SSS6697-B7 mass production tool has not been released yet, wait and see. It is not yet possible to mass-produce.

Mass production tools do not flow out, can only be replaced by another main control board for mass production, in other words, the current Kingston is all TLC, speed, life is not good.

You can continue to format it and try it.

Run cmd to enter the DOS interface, enter the format space plus the disk letter q

For example: format g: q

None of the above methods will work. It's best to mass-produce USB disks!

Invoke the command prompt window and enter format x s

Let's restart mass production with the right mass production tools, and take a look at the digital house, there are a lot of them.

The virus forces your USB flash drive to write protection, and you use the USB flash drive antivirus expert to check and kill, and the antivirus effect is good, which can solve this problem.

RAW format? The USB flash drive format should be FAT or FAT32

Landlord.. If none of the above works, you can try to re-mass produce it with mass production tools. If it still doesn't work, then your USB flash drive can be reimbursed directly.

Start Run Enter cmd Enter Enter Command Line Enter format drive letter x q Enter you try it.

Try plugging in a different computer, your USB flash drive may be broken.

Can anyone help me get out of my USB flash drive.

If you want to recover USB flash drive files, we recommend Anyi Data Recovery. Very easy to use. The read-only mode is used to scan the data, and the original directory file name structure is formed in memory, without destroying the content of the source disk.

It is capable of recovering data emptied by the site, repartitioning lost data, accidentally deleted and formatted data recovery, etc.

If the data is very important, don't try to operate it yourself, this situation belongs to the loss of the U disk file system, the effect is not very good with recovery software, if you need help, you can hi me, I am manual recovery, you can recover remotely, I am paid to recover, you can ensure the success rate and security of recovery.

Try a different computer.

Could it be a computer system problem?

It's not a USB flash drive problem.

The next USB flash drive model detection tool, the above version, if you can't read it, the hardware is damaged, and you can only go to the after-sales service for repair.

If you can read it, you can save it, send the information that you read out, and you can fix it, and try it a few more times under the low grid of the corresponding mass production tool under the PID vid and the chip model. Try a few more versions.

I feel the same way! My USB flash drive is the same, but you can try mass production tools, and it should be the same as your USB flash drive model!