Does the Sharon 380 engine burn oil?

It will burn the engine oil, but it is not too serious, pay more attention to maintenance.

Most of the Sharan burning engine oil is caused by the piston ring being trapped by carbon deposits. Relying on the addition of high-viscosity engine oil to continue life is only an expedient measure to cure the change. When the oil enters the combustion chamber to participate in combustion, more carbon deposits will be formed, which in turn will lead to the aggravation of the burning of engine oil, forming a vicious circle.

In the long run, it will cause cylinder wall strain, or even cylinder burst, and finally the engine can only be disassembled for overhaul.

Four reasons why you burn engine oil.

A ...If you don't clean the oil circuit for a long time or don't do effective oil circuit cleaning, detergents are used at will, and using detergents and effective detergents are two different things;

IIThe antifreeze replacement cycle is too long or not changed at all;

IIIThe oil change interval is too long;

IVLong-term or often short-distance driving.

The above four points of the vehicle that burns engine oil must be occupied by one or all four points.

How the piston rings are stuck.

The principle of piston ring stagnation should start from the oil circuit, the oil temperature is 110 degrees, and the high temperature caused by the long-term unclean oil circuit makes the oil at a temperature of 120 degrees or higher for a long time, so that the oil will be exhausted in advance, the small hole of the oil ring is very small, and the oil inside will be dried and scabbed for a long time. It becomes a liter of engine oil for 1000 kilometers or even hundreds of kilometers. Therefore, in order to solve the problem, we must start from the root oil circuit, which is the way to remove the root.

The solution to burning the oil.

In the habitual thinking of car enthusiasts, they always think that burning engine oil should be overhauled, so that they not only have to bear high maintenance costs, but also bear the unpredictable risks and depreciation losses brought about by the overhaul. Destroy the airtightness and precision of the engine. And there is a possibility that the engine oil will burn again after tens of thousands of kilometers, so overhauling the engine is not sustainable.

Now the no-dismantling technology has been very mature and gradually accepted by the majority of car owners. In particular, the non-destructive repair products containing PNF patented technology have completely gotten rid of the technical shackles of the operation of the auto repair shop, and the owner can operate it himself without removing a screw, and the piston ring is repaired and released during driving, and the effect is remarkable.

Burning engine oil means that the engine oil enters the combustion chamber of the sail hole machine through a certain way, and participates in the combustion together with the mixture. This is mainly due to a cylinder leak caused by damage to the piston rings, and oil escapes into the combustion chamber. It is recommended to carry out maintenance as soon as possible, if this is the case for a long time, not only the fuel consumption of the engine car is large, but also the impurities generated by the combustion of the engine oil will cause the increase of carbon deposits in the combustion chamber.

If the engine burns oil seriously, it is necessary to call Hongxing engine overhaul, replace the cylinder liner, piston, piston rotten ring, and then carry out cylinder head valve reaming, replace the valve oil seal, and Zheng Lishu can solve the problem of burning engine oil.

It is recommended to check the following aspects: 1. Crankcase forced ventilation valve; 2. Carrying orange exhaust valve; 3. Whether the model of oil deficit is up to standard; 4. Whether the turbocharger is working normally. Hope to pick up the pin key acceptance.

It is a matter of time before the Volkswagen car burns engine oil, and improper use or improper maintenance can easily cause the serious phenomenon of burning engine oil to be purely judged. However, if the maintenance is reasonable, the phenomenon of burning engine oil will be slightly better, but due to the existence of turbocharging technology, the phenomenon of burning engine oil basically exists for European Pat Zhao cars.

Volkswagen Sharan burns engine oil seriously, how to solve the old slippery problem? If the Volkswagen Charon burns the engine oil seriously, then let the wild you only have to change the spark, plug the spark plug, change the oil and burn the oil, seriously, then you only have to repair and rebuild, rebuild and upgrade, and the big bell big bell big bell, at least 1000 yuan.

Volkswagen turbocharged models burn engine oil is a common problem, if it is very serious Xianzhou, you can try to clean the throttle, replace the waste valve, if there is no obvious improvement in Kaisheng, it will have to be overhauled.

The engine of any model burns oil severely, then only overhaul is necessary. Replace the cylinder barrel piston rings. Re-grind to find the gap.

It should be a lot of engine oil, if this car burns engine oil, then hurry up to find the manufacturer, or find a four-s shop, and go and take a look. Is it possible to change the car? If He Shen can't change it, hurry up and repair it, it's not a good problem to have less, hey, this is also a big problem, so You buried and said to hurry up and find him to shoot the ants.

If you say that this is a very thin situation, then you can choose to go to the tank room to iron a post, which is very simple and simple, and then it is a matter of spending more money.

What else can I do if I change cars???

Cars with T are all oil-burning, because of the unique configuration of the turbine, high temperature and reserved clearance, the oil will be burned. [If you have a problem with the car, ask the car master.] 4S shop professional technician, 10 minutes to solve. 】

Hello