How to connect the G41 motherboard? How to wire the G41 motherboard with the original wire

First of all, let's get to know all the cables on the case, Power LED is the power indicator, HDD LED is the hard disk indicator, Power SW is the power button, Reset SW is the restart button, the front interface of the case, audio is the front audio of the case, the front interface of the case, etc.

In the above figure, the four jumpers of Power LED power indicator, HDD LED hard disk indicator, Power SW power on/off button, and Reset SW restart button belong to a group, with the white cable being the negative pole and the colored cable being the positive pole.

The switch jumper connection method is the most difficult place to install, take the following jumper 9-pin pins as an example, this is the most common pin, of course, some motherboards are a little different, we need to insert them according to the motherboard identification.

Switch headers. Note: There is a logo below the jumper, left + (positive pole), right - (negative pole).

The red box indicates the PWR LED, which corresponds to the jumper of the Power LED of the chassis cable, and you need to distinguish between the positive and negative poles.

The green box indicates the HDD LED, which corresponds to the jumper of the HDD LED of the chassis cable, and you need to distinguish the positive and negative poles.

The yellow box indicates that it is reset, which corresponds to the reset sw jumper of the chassis cable, and does not need to distinguish between positive and negative poles.

The blue box indicates PWR BTN, which corresponds to the Power SW jumper of the chassis cable, and does not need to distinguish between positive and negative poles. (Some motherboard switches may not be PWR BTN, such as POWER SW, PW, PWR, POWER, and ON OFF, all represent switches, and the meaning is the same.) ）

Jumper connection between the chassis and the motherboard**.

Note: Some motherboards have different headers, in fact, we only need to insert them correctly according to the logo on the motherboard.

<> is usually these 4 pins.

You try to short the two green circles and see if they can turn on, if they can, you can be sure.

First row from left to right Power Indicator Positive , Negative , Power on and Off (Positive or Negative) Second Row Hard Disk Indicator Positive, Negative, Reboot (Positive or Negative).

In a corner of the motherboard, there is a writing on how to connect. You take a serious look. There is also a look at the wiring instructions of ordinary motherboards, which are generally the same.

Look at the motherboard label, just connect it.

<> root type trembles according to the letter of the rolling letter Bu Bei is defeated.

There are letters on it. Just follow the errand.

The easiest to count, the lazy number can go directly to Zhongguancun** to find the corresponding model of the motherboard to check its parameters.

HD LED+ HD LED - Pin to motherboard HD marker, PWR SW to motherboard PWRSW, Reset to motherboard RESET marker. all have corresponding signs.

Do you want to connect the switches and indicators on the front panel? If yes, just tell you in the picture above.

The switch connection method on the motherboard can be based on the silk screen on the motherboard, and then the screen print on the chassis can be connected to it, and the switch connection method on the motherboard is mostly the same, you can refer to the figure below, it is recommended to install the battery on the motherboard first

You can see the small white box under the skip pin, there will be the English logo of pow, and it is good to insert it in it.

The positive and negative electrodes have been marked, and there is no positive and negative electrode without a mark.

<> compare this connection to it.