Water drips from the right end of the air outlet of the Panasonic air conditioner

The main reasons for dripping water in the air conditioner are as follows, and the automatic shutdown should be circuit protection, and it is best to check whether there is conductivity and other phenomena.

1.The VTH unit is offset.

There are three main reasons for the deviation of the indoor unit: the installation of the indoor unit is not firm, the installation of the fixed hanging plate of the indoor unit is not firm, and the installation of the indoor unit is not horizontal at the beginning and is slightly tilted. With the slight vibration of the internal unit during the operation of the air conditioner, in the case of the first two points, the internal unit is easy to shift after a long time, resulting in a high position on the side of the drainage pipe, resulting in difficulty in drainage; When the horizontal position of the indoor unit is improperly installed, when the horizontal position of the indoor unit is installed and tilted, the direction of the pipe intersection is too high, resulting in the obstruction of the discharge of condensation.

Solution: Move the air conditioner inside, recalibrate the position of the air conditioner with a liquid level, and trim or lower the end of the condensate pipe outlet of the air conditioner as much as possible.

2.Poor drainage.

Due to the aging of the drain pipe, it is loose or bent into a wave shape, resulting in poor drainage, which is also easy to cause the phenomenon of dripping water in the air conditioner. Secondly, the air-conditioning holes reserved in the house often attract birds and rats to nest and build nests, which will cause damage to the drainage pipe, resulting in poor drainage or damage to the drainage pipe, and condensation water will flow inward along the drainage pipe from the hole to cause dripping.

Solution: Contact the after-sales service of the store, the air conditioning manufacturer or a qualified repairer to replace the drainage pipe during the three-warranty period. Of course, if you know the relevant technology, you can also buy an ordinary PVC thin pipe and install it yourself, but most people live in buildings nowadays, and the construction of outdoor units is dangerous.

3.Condensation on the piping.

Because the insulation material on the pipe is too poor or too thin, or not completely encapsulated, when the refrigerant passes through the pipe, it causes condensation, just like some water droplets always condense on the outside of a cold beer.

Solution: First of all, you should disassemble the adhesive tape to check whether the insulation material is aged or installed properly, if you find a gap or a thin phenomenon, you can rewrap it. At the same time, the aging adhesive tape can be replaced to maintain the tightness of the copper pipe.

4.The drain pipe is blocked.

The drain pipe leading out of the exterior is artificially blocked or the drain is blocked by stolen goods, so that the condensation cannot be discharged.

Solution: This situation usually occurs in the south with a lot of smoke, if the building is designed with drainage pipes, it is necessary to focus on checking whether the drainage pipes are unblocked, and whether the drainage pipes and air conditioning pipe inlets are properly connected. If the drainage pipe is installed by direct dripping, the possibility of the drainage pipe being blocked by dust is greater, and the drainage pipe can be flushed with a high-pressure water gun or tool to achieve the purpose of dredging.

5.The heat exchanger drips.

When we find that the water of the air conditioner is present in large quantities and drips from the blades of the heat exchanger, that is, the indoor unit, it is usually that the heat exchanger is too dirty, and it can be rinsed with a commercially available cleaning agent, gently brushed with a wool brush, or used a high-power electric hair dryer to cool off the dust. Of course, if you find that the air conditioner is not refrigerated, it may also be that the heat exchanger temperature is uneven due to insufficient refrigerant, which can be measured through the pressure gauge.

If the lack of fluoride happens to coincide with the low speed of the internal fan, it will also drip water, giving people the illusion that it is clogged or not level.

Teach you how to get rid of the blockage of the water pipes, find a clean new water pipe, connect it to the outside drain, suck it hard, if there is dirt coming out, it will be blocked.

There's also the possibility that the filter is dirty, and it's dripping.

There will be reasons why water will blow out or drip from the tuyere:

1. The humidity of the environment is too high, such as dining rooms, kitchens and other spaces.

2. The performance of the air conditioner is excellent, and there is too much condensate, and it is easy to blow out if it is too late to exclude.

3. The filter screen of the internal machine is too dirty or the evaporator is too dirty, so that the circulating air volume becomes smaller, and it is easy to have a lot of condensation, so the filter screen and evaporator need to be cleaned.

Hope it can help you, satisfied. Thank you.