How to clean yellow stains on the foam of your Adidas Boost running shoes

Cleaning method: 1) Gently wipe with a soft damp cloth.

2) Using a sponge and hand washing to maintain the quality of the shoes will also avoid glue opening and peeling.

Data Extension:Daily cleaning of sneakers.

1) When the shoes are dirty, you can gently brush them with water dipped in detergent, then rinse them with water, and place them in a ventilated and cool air to dry them to avoid direct sunlight. Do not use heating or open flame for drying, so as not to cause aging, glue opening, fading and serious deformation. Excessive direct sunlight, heat from the hair dryer and improper care can reduce the life of the shoes. It cannot be soaked for a long time when washing, and the general soaking time should not exceed 20 minutes.

Leather shoes should not be soaked in water.

2) Most of the raw materials of sports shoes are synthetic polymer materials (mostly polyester nylon mesh and non-woven artificial leather, and the soles are mostly made of rubber or rubber foam materials), and some uppers are leather, so avoid contact with organic reagents and oil solutions, and at the same time, it is not suitable for long-term wear in a high temperature environment. Generally, the wearing or washing temperature should not be higher than 45 degrees Celsius.

3) If it is stored for a long time, the shoes should be brushed and cleaned first, and then stored in a cool and ventilated place after drying, so that the shoes have enough time to dry to avoid mildew. It is best to prop up the inside of the shoe with a paper ball or shoe support to avoid serious deformation. Dry with the toe toe facing down and the sole facing the wall in a ventilated place at room temperature to prevent water from soaking into the midsole foam material.

Because the foam material does not dry easily, it is recommended not to lay wet shoes flat. ）

The materials we need to prepare are: rags, toothbrushes, toothpaste, water, a small basin.

1. If the shoes are not particularly dirty, you can dip the rag in some water and wipe the dirty parts of the shoes. Generally about a month, after all, the cleaning ability of clean water is limited, if it is not cleaned for a long time, it will become old and dirty, then it will have to be cleaned in a troublesome way.

2. Use toothpaste and brush, if you use a soft-bristled toothbrush, the effect will be better, we will dip the toothbrush in some water, apply a little toothpaste on the sole of the shoe, wipe it off, and spread it until the delicate foam appears.

3. If there are masters around, you can use paint to brush the soles, but it should be noted that the elasticity of the boost is very good, and if the quality of the paint is not good, the paint will fall off.

Online tutorials are generally filming. Note that it is more convenient to enter with caution or toothpaste, after all, no one will stare at your feet, and it is still a midsole, even if you look at the average person, you can't see anything.

4. Finally, BOOST is softer, and we should pay attention to maintenance at ordinary times. Don't wear it on rainy days, and don't wear it on dirt roads. It is suitable for shopping malls, roads, squares, and floors. Avoid stepping on sharp, fine gravel stones, otherwise the material on the soles of your feet will be punctured with small holes.

1. Gently wipe with a soft, damp cloth.

2. New shoes or shoes that are two or three months old are not too dirty, you can use toothpaste and toothbrush, wet with water and brush directly (do not directly rinse with a large amount of water, which will cause the stolen goods to be washed directly into the shoes, causing irreparable).

3. Use a sponge and hand wash to effectively maintain the quality of the shoes, and also avoid glue opening and peeling.

4. The shoelaces and shoes should be cleaned separately in order to keep the shoelaces clean. When drying, take out the insoles and put them in a ventilated place to dry. If there is a white part of the shoe, wrap it in toilet paper to avoid exposure to the sun.

4. Next, use a shoe brush to scrub the foam of the Adidas boost sole, as shown in the figure below.

5. Then use a towel to wipe the Adidas Boost sole foam clean, as shown in the figure below.

6. Finally, you can clean the Adidas Boost sole foam.

The foot feeling brought by the boost is indeed incomparable, but at the same time, the white grainy boost is very easy to be stained by stains in daily wear, so how should the stained boost be cleaned?

Method 1: Wipe with a damp cloth.

If it is just a simple stain, then use a rag dipped in a little water and wipe it back and forth to wipe it off.

But I can only deal with some stains that have just been up, and there is no way to deal with those old dirt.

Method 2: Soft brush + toothpaste.

The cleaning ability of the toothpaste is still very good, and the use of a soft brush with toothpaste can not only avoid damage to the surface of the boost, but also achieve a good cleaning effect.

In general, most stains can be removed by this method.

Method 3: Professional cleaning reagents.

There are some stubborn dirt or dirt with dyeing effect, it is very troublesome to clean, it is difficult to achieve a good cleaning effect with general cleaning agents, only the use of special sneaker cleaning reagents, in order to ensure that it will not cause damage to the shoes, and at the same time can also clean off the stubborn dirt.

Using a sneaker cleaner and a soft-bristled brush makes it easy to remove stains and remove yellowing.

Here's how to clean your Adidas running shoes:

1. First use a clean soft cloth, dip a small amount of "leather footwear cleaning", and wipe lightly on the upper to remove dirt.

2. Use another clean soft cloth to evenly apply an appropriate amount of "leather care ointment" to the upper, not too much, and then polish the leather surface.

3. If the stain is stubborn, you can first moisten the stained part, and then use the "leather footwear washing" and a soft brush to remove the stain, and then dry it with a cloth or thick paper towel, and dry it naturally after stabilizing the shoe shape, avoiding direct sunlight. Then use the "Step 2" care upper leather.

To clean white shoes, the materials that need to be prepared include: special cleaning agent for sneakers, large shoe brushes, small shoe brushes, and towels.

1. Use a large shoe brush to dip an appropriate amount of special cleaning agent.

Second, then use a shoe brush to brush the midsole of the shoe.

3. Then use a small shoe brush, also dipped in an appropriate amount of cleaning agent, to brush the mesh of the shoes.

4. Then wipe your shoes clean with a towel.

Can be cleaned with cleaning solution. Prepare the cleaning solution and brush, put 2 drops of cleaning solution into the basin, soak the brush in the basin, and then brush the surface of the shoe with a brush, it will produce foam when brushing, and then wipe off the foam with a towel. Here's how:

1. Prepare cleaning solution and brushes.

2. Add 2 drops of cleaning solution to the basin.

3. Soak the brush in a basin of water.

4. Then brush the surface of the shoe with a brush.

5. Foam will be produced when brushing.

6. Then wipe off the foam with a towel.

7. Finally, use a hair dryer to dry.