What do you learn about the content of the car wheel water transfer printing course?

1.Transmission fluid.

When you change your engine oil, you can check your transmission oil by the way, and since the inspection process is more cumbersome, you can ask the dealer's service department to handle it. In order to measure accurately, the car must be discharged into neutral p, run at idle speed, and parked on a flat place, and the oil must run to an operating temperature of 80 93.

Too much or too little oil can damage the gearbox, and too much oil may cause excessive resistance to the operation of the parts, or cause the transmission oil to bubble and deteriorate, resulting in abnormal wear and tear of the parts. So when you check your transmission fluid, it's important to measure accurately.

2.Power steering oil.

When the engine cools down, wipe the top of the oil filler cap and the oil reservoir clean, then unscrew out the direction oil cap, and wipe the dipstick clean with a fiber-free clean paper towel, and then install the lock, and then open and pull out the oil level to check the dipstick.

To fill or change the oil, it is necessary to use the correct power steering oil, if it is not used properly, it will cause damage to the steering machine.

3.Brake fluid.

Just open the hood and look at the level of the brake oil can, as long as it is not lower than the lower limit.

When the level of brake fluid is not checked, brake fluid should not be added, so as not to add too much, and the brake oil will be sprayed to the high-temperature engine, resulting in corrosion and even combustion. If there are bubbles in the brake oil, or the oil becomes dirty, it means that the brake fluid has deteriorated, please replace it as soon as possible, so as not to reduce the boiling point of the brake fluid and produce bubbles, resulting in poor braking effect, which is very prone to danger.

The content of the car water transfer course: Learn how to transfer various patterns and patterns to the wheel hub of the vehicle.

What do you learn about the content of the car wheel water transfer printing course? What do you learn about the content of the car wheel water transfer printing course? What do you learn about the content of the car wheel water transfer printing course? You should go to an automotive technical school for counseling and studying.

I will make a simple description, that is, on a plastic, press down on the product, and use the pressure of water to paste the plastic paper on the product, because the force is more uniform, so the appearance will be smoother. Hub water transfer, that is, the water.

Learn automotive water transfer printing, Course content: learn the knowledge of resins, pigments and solvents and other coatings, the basic knowledge of organic chemistry, the performance and use of commonly used coatings for automobiles, the selection and matching of coatings, and the construction of commonly used imported coatings

Hello, car wheel hub water transfer printing is a new technology, learn technology must go to a professional school to learn, belongs to the car beauty technology module, you can directly come to the school to learn more, this single technology learning time will not be too long, generally within a week can be learned.