What is the reason why my computer can t enter Safe Mode with Internet Connection?

It should be caused by the network card driver not being installed incorrectly.

Due to the incorrect installation of the NIC driver, the following is caused:

1. During the boot process, Windows followed the wrong driver to find the corresponding hardware, but of course it couldn't be found, so the boot process was stuck.

2. Since the system only loads the most core drivers and system tasks under the "safe mode", of course, you can enter the "safe mode" smoothly when the rest of the system is installed normally; However, when you are ready to enter the "safe mode with network connection", the system will load the NIC driver and related system tasks on the basis of the "safe mode", as mentioned above, the NIC driver is incorrect, so you cannot enter the "safe mode with network connection".

Solution: 1. The fundamental way is: figure out what brand and model of your machine's network card is (even if it is an integrated network card, the network card chip also has its own manufacturer, which is different), find a machine that can access the Internet, go to the latest driver of the corresponding model of your network card (to the official version, not the bata version), install the network card driver in safe mode, and restart it.

2、The way to save the country by curve:You go to the newer ghost installation disc,Redo the system。。。 Generally, the driver check and automatic installer in the newer ghost disk are also relatively new, and should be able to correctly identify and install your network card.

Right-click on the online neighbor, then click on the property, local connection The right mouse button and then click on the property, find the Kaspersky Anti-virus NDIS filter protocol, uninstall it, OK

Attached is a solution to this problem on the Internet:

Symptom. When you change the IPX frame type for your network connection from Auto-Detect to any other IPX frame type, you may see a "Stop 0x0000001d" or "Stop 0x000000a" stop error occur.

Cause. This issue can occur if you have the NWLINK IPX SPX NetBIOS compatible transport protocol installed on your computer and you are using the Driver Verifier Manager to troubleshoot errors with the driver's dedicated pool feature.

Resolution. You re-installed version 2000 on another machine, and copying it over and overwriting yours should solve the problem.

If you can't overwrite the system file, you can use the replace command to overwrite and replace the file.

replace [drive1:][path1]filename [drive2:][path2]

It's a network error.

This method doesn't work on my machine.

Hello dear! It's your choice that isn't right. There are two kinds of options to enter the safe mode after booting, pay attention to the optimistic one is with the network.

One is without, usually we choose not to have a network, so you can't connect to the network, if you do need to connect to the Internet, please choose the security mode option with the network. The Safe Mode options with networking are as follows:1:

Enter msconfig in the start menu run bar, and it will be disabled. 2: In "Startup", all are disabled.

Restart the system to see if there is a problem, if it can be solved, also call up msconfig, check the previously disabled items one by one, and slowly find the cause of the problem to see what causes it. 3: If you can confirm the problem item, check what the item is online, and you can confirm that it is unnecessary, you don't need to check it again.

Hope it helps. If my answer is helpful to you, please give a thumbs up (rate it in the bottom left corner), I look forward to your like, your efforts are important to me, and your support is also the driving force for my progress. Finally, I wish you good health and a good mood!