What should I do if the CMCC signal is not good, what should I do if the CMCC signal is weak?

Hello, if you are a Beijing Mobile customer, it is recommended that you take a look at the surrounding customer network, if the surrounding customer network is not good, you can call 10086 for feedback. If there is no problem with the network situation of the surrounding users, then there may be a problem with the settings on your mobile phone, and it is recommended that you troubleshoot as follows:

2. Browser problems: Use the browser that comes with the mobile phone, do not use a third-party browser.

3. Cache problem: Clear browser cache and cookies.

5. Last abnormal offline: Turn off the wifi switch for more than 15 minutes and try again.

In addition, the signal source of CMCC is a small box, which is called AP, which is similar to a thing of infinite routing, your side should be too far away from this device, and the signal you search for is too weak, so it can't be connected! The best thing to do is to go to the neighborhood and surf the Internet, or find someone from a mobile company who is in charge of this to help you install a new AP to cover your area!

Two goods! There are many ways to solve the problem of weak signal.

Hello, shut down and reboot.

The CMCC signal is hindered by walls, trees, etc., and the attenuation is very strong, and the signal difference is also very large in different positions and directions within a few meters. If you want to be stable, it is recommended that you get a wireless network card with RJ45 interface, you can put the network card outdoors or on the roof in a good location, and transmit it back to the room with a network cable

Questioner commentsThank you!

Regarding this problem, don't listen to their nonsense, it's normal for the signal in the room to be weak, because the equipment room is installed outdoors, and there must be weakness through the air wall, you can contact customer service, react to this problem, someone will test, and then increase the power, so you can hit a ** OK!

Hello, first of all, confirm whether your computer has retrieved the CMCC network, if you confirm that there is a network but cannot connect. You need to confirm the following two points: first, in addition to your computer, whether other terminals (such as mobile phones and pads) in the same place can log in to the CMCC network; Second, in addition to the CMCC network, can your computer log in to other wireless networks?

Corresponding to the confirmation result:

1. If other devices can use CMCC, please check the network settings of your computer, you need to choose to automatically obtain IP address, restart the device and try again.

2. If your computer cannot log in to other wireless networks, please check the wireless network card driver, reinstall and try again.

3. If all terminals cannot log in to the network, it means that the network information is weak or unstable.

Thank you for your understanding.

Query the WLAN hotspot. Due to the differences in business in different regions, if you are a non-Beijing Mobile customer, we recommend that you call the local 10086 for consultation. Thank you for your understanding.

Enhanced CMCC Signal:

1. Buy a wifi booster in ** or physical store, choose according to different signal sources, and be sure to look at the introduction of others.

2,1 Install the official driver.

2. The system will automatically turn on and off the icon as follows every time you turn on and off.

3. Operate each button according to the manual, time limit, wifi point-to-point connection.

4. After connecting to it, you will find that it is not the CMCC signal, but a signal source converted into it through the WiFi booster.

5. Click to log in to your mobile.

6Note that the login page can be closed.,After closing, you can continue to surf the Internet.,Because the artifact has a memory function.。

7. This is okay, CMCC has been used, and you will find that the time will not increase, hehe, great!

Why use CMCC at home, you can use the router to connect to your home's network cable, which is definitely faster than CMCC.

If you use CMCC, you keep disconnecting and reconnecting. Maybe the signal can be enhanced.

To enhance the wireless network signal, you can go and buy an AP

Mainly because of network coverage and signal problems, you can ask 10086.

1. The WLAN signal is unstable, the signal strength fluctuates too much, and when the signal is suddenly low at a certain point in time, the terminal will think that it has been disconnected from the wireless network, and the disconnection caused by this reason is that the wireless connection in the lower right corner is directly disconnected;

2. The interference of the surrounding WLAN signal is too strong, resulting in the signal received by the terminal or wireless network cannot be demodulated and parsed normally.

3. Under the current wireless network, there are too many wireless users, the wireless network users are almost saturated, or the network address pool does not have enough IP addresses, and the wireless connection in the lower right corner of the wireless connection shows a small exclamation mark when the network cannot be accessed due to such reasons;

4. The performance of the LZ terminal is insufficient or improperly configured (this performance is not the performance of the whole machine, but the performance of the wireless network card) LZ can be checked on the Internet, and the wireless network card is now produced by many manufacturers, and the performance is uneven between them. In terms of configuration, there are mainly the power-saving mode of the wireless network card, the roaming initiative of the wireless network card, the rate set supported by the wireless network card, the technical mode of the wireless network card work, and so on.

Episode 29 What is the reason why the mobile phone signal is full but I can't get on the Internet?

It may be that the signal is full on the surface, but there is no signal at the bottom, or there is a problem with the mobile phone.

I've also encountered this situation, sometimes I can't get on the net when I cut the screen, and I have to restart the phone.

1. Free version. You can refer to the appearance of the satellite signal receiver, find your own aluminum pot lid, aim it in the direction of the CMCC signal source, and then put the mobile phone in front of the pot lid, carefully adjust the angle and distance, and the signal strength will be significantly improved. Of course, the free lunch is not so tasty and too troublesome.

2. Add a CMCC signal booster, which can relay and amplify the CMCC signal, and the signal will go up.

You can buy a wireless network card with RJ45 interface, and then cooperate with the wireless router to connect the router to the CMCC. This device has a built-in 16db directional panel antenna, network cable transmission, extension cable can be connected to more than 50 meters, can be connected to a router, multiple people share the same account, and will not repeat the timing. It can solve the problems of weak signal, slow network speed, and short-range radiation; It can also be used as an ordinary wireless network card, this device can receive China Mobile CMCC signal, as well as China Unicom Chinauncom signal, China Telecom Chinanet signal, or other ordinary wireless routers sent by the wifi signal, and the received signal is converted into an ordinary network cable signal, with an ordinary network cable to transmit back to the computer or router.

Hello, the situation in the problem is generally caused by the busy network, it is recommended that you wait for a while and then try to connect again, if you still can't connect, and the surrounding customers are in this situation, it is recommended that you call 10086 for feedback. Thank you for your understanding.